Question about 2001 Ford Explorer

3 Answers

Hey when i push the power botton for the rear window it doesn't go down,I checked the power button,and its good ! Can i replace the power motor in the rear window,and where is it located,i would like to fix the problem,John

Posted by on

  • Anonymous Apr 02, 2009

    The window regulator is out in the tailgate. The regulator is inside the gate, however fix it fast. For some reason when the reargate goes out the midgate follows. I have read several blogs were this has happen but GMC has no recall.

×

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,035 Answers

  1. Raise and support the rear door window glass to the full up position.
  2. Remove the interior door handle.
  3. Remove the rear door speaker.
  4. Remove the water shield.
  5. Disconnect the rear door window regulator motor electrical connector.
  6. Remove the rear door window regulator rivets.
  7. Remove the rear door window regulator by sliding the regulator arms off of the window glass track.
  8. Installation is the reverse of the removal procedure, noting the following:
    • Cycle the door glass to make sure of engagement of the drive mechanism.
    • Remove the rear door window glass-to-regulator bolt or rivet.
    • Position the rear door window glass as necessary to access the rear door window glass-to-regulator rivet.
    • Secure the rear door window glass in the full UP position with tape.
    • Disconnect the window regulator motor electrical connector.
    • Remove the 2 window regulator nuts.
    • Remove the 3 window regulator motor bracket nuts.
    • Install the window regulator assembly. Tighten the 3 motor bracket nuts to 89 inch lbs. (10 Nm).
    • Install the 2 window regulator nuts. Tighten the nuts to 89 inch lbs. (10 Nm).
    • Connect the window regulator motor electrical connector.
    • Remove the tape securing the rear door window glass in the full UP position.
    • Position the rear door window glass as necessary to access the rear door window glass-to-regulator rivet. Tighten the bolt to 62 inch lbs. (7 Nm), or install a new rivet.
    • Install the window regulator motor
    • Remove the window regulator assembly.
Remove the window regulator motor

Posted on Feb 23, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Director Badge:

    Uploaded 100 video answers.

  • Ford Expert
  • 83 Answers

A different car but this gives you an idea about how to fix a non working electric window motor

Posted on Oct 29, 2015

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 5,158 Answers

Check the relay for it first... it's likely under the dash on the drivers side

Posted on Feb 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 nissan pathfinder driver side window won't go up and down


does it click or grind when pushing window button if so the window lift track may need replaced, if there are no sounds then disconnect the wires from the lift motor and with the ignition on so power is sent to switch, push button and check wires to 12 volts dc. If no power I would replace the driver side switch after checking the wires for defects. If there is power then I would re-install wires to motor after turning off key and try button again with power on. replace motor if it doesn't work.

Dec 31, 2011 | 1996 Nissan Pathfinder

1 Answer

I have a 2009 dodge avenger that the front passenger window goes down but it doesnt go back up. I checked power at the motor & had power going both up & down. I thought it was the motor but I...


It may be a bad Power Window Switch, if the Power Window Motor goes up and down when you ran power leads to it but doesn't work with the switch, than the switch is bad. Replace the power window switch and it should work fine.

May 04, 2011 | Dodge Avenger Cars & Trucks

2 Answers

Rear window will not open or release , can hear electric release


you will need to check all the fuses first, then remove the pop window switch and check for power at switch, and power going through switch when button is pushed, this button is on the dash, if there power then you may have a bad release motor,if your blazer does'nt have a hatch release on the dash then you will have to remove the panel on rear door and test there .

Jun 15, 2010 | 1996 Chevrolet Blazer

3 Answers

Driver side window usually won't work - Usually....


you can but you would need to attempt to diagnose this problem when the vehicle is acting up. You would need to check for power and ground at the window motor/regulator assembly, they have a tendency to go through window switches and regulators so before changing both i would get a good test light. Wait for the problem to start and probe one of the wires while moving the switch up and down, if you dont get power at either direction its the switch, if you do its the regulator.
happy motoring

Aug 28, 2009 | 2005 Dodge Caravan

1 Answer

Mustang rear window...fuse or motor?


first check the fuse.if its good then check the window motor by pressing the button and if you dont hear the motor going theres your problem, needs to be replaced.  unfortunatly the motor isnt sold by itself you got to buy the window regulator. here is a pic. of the part29159f3.jpg

Apr 26, 2009 | 2000 Ford Mustang

2 Answers

2005 chevy impala rear driver power window stopped going up.stuck


If neither switch works it is a bad connection at the motor or bad ground or a bad motor. Remove the door panel unplug the motor push the switch and see if there is 12volts on the wires if there is the motor is bad There are small brushes in the motor that go bad tap on the motor while pushing the switch if it works that way replace it

Mar 29, 2009 | 2005 Chevrolet Impala

1 Answer

Windows stuck in Down Position


You may have a master switch that locks out the buttons check that first. You said that you have power going to each switch, but when pressed does it power the other side of the switch? If it does then check the wire at the window motor to see if the power is getting to that point. If it is check to make sure the motor is well grounded. If it is and the motor still will not work you will need to replace the motor.

Jul 05, 2008 | 2001 Chrysler Sebring

Not finding what you are looking for?
2001 Ford Explorer Logo

1,490 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...