Question about 1992 Geo Tracker

2 Answers

I have a 1992 geo tracker and I just changed the clutch cable with no problems.Today I went and backed out of my driveway and when I put it in first I heard a big thump and the tracker would not move.I can get the shift knob into every gear but when I depress the clutch,Half way I hear nothing but all the way in I hear grinding.The tracker starts eveytime but it just wont move.Is the clutch gone or could I have did something wrong when putting the new clutch cable in.Please be a cheap answer not an expensive one!!!Thx Paul

Posted by on

  • Anonymous Mar 19, 2014

    Changed the clutch,pressure plate sect....problem is not sure how to put the shifter in.

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 137 Answers

You didnt snap in the top end of cable into fork , above pedal.
the cable is a cheap china knock off and is useless ( common)
you did set the free play to 1/2 like it says in the book.

need help post back
or ask on my leave message page.
http://www.kick-fix.com/

end of page.

Posted on May 14, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

Sounds like you need to adj the clutch cable

Posted on Feb 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Pedal hard to push in has new cluch


the cables is #1 top failure. and can damage car, or it can stick and cause a wreck
http://www.fixkick.com/tranny/clutch/clutch-on-kick.html

never run old cables here.
they fail inside, big time, where you will never see,
also if you keep it like this, the spins on the top of the clutch pedal
strip, (good luck finding that)
or fire wall cracks at the mount for cable.
or the pedal welds snap.
seen 100's on all tracker/kick forums.

Apr 02, 2014 | 1992 Geo Tracker

1 Answer

Changing a clutch in a 95 geo tracker


there are in fact 2 disks, one for 8v and one for 16v 95hp.
its all here, every step.
click clutch

http://www.fixkick.com/PULL-PAGE.html

Dec 16, 2012 | 1995 Geo Tracker

1 Answer

Throwout bearing sticks on my 90 tracker


very old post , the cables all do that, at 200k, miles.

old post.
they have all fixes for that here,
http://www.fixkick.com/tranny/clutch/clutch-on-kick.html

Nov 10, 2012 | 1993 Geo Tracker

1 Answer

Clutch is hard to push in,the cable is o.k. the cross shaft seems o.k. bushings under clutch peddle under dash o.k., but when hooked up to Bellhousing, cable creaks.


may be binding in the clutch fork or the clutch itself. if when the cable is free it moves easily the the problem is in the clutch area. hope this helps

Mar 23, 2011 | 1992 Geo Tracker

1 Answer

What's wrong when my 1992 Geo Tracker is hard to shift geers when engine heats up ???


check clutch fluis + bleed slave cyl
if does not help replace throw bearing by clutch fork

Apr 24, 2010 | 1992 Geo Tracker

2 Answers

No tension on clutch peddle


That sounds like it could be... I'm assuming the bearing slipped off of the fork, and that would give you this condition, see if you can look in through the rubber boot at the fork to see this.

Aug 17, 2009 | 1991 Geo Tracker

2 Answers

Geo tracker wont shift after clutch and clutch cable replaced


this is common.
it is caused because NO ON ever changes the cable at 100k miles.
it then wears a groove inside the cable and jams where you cant see.
(got my car dirt cheap cuz no one could figure this out)

the next thing to happen (toss coin) is the fire wall cracks or the clutch pedal spline strips.
full story here,
http://www.kick-fix.com/tranny/clutch/clutch-on-kick.html

now you know the why , so now correct all the damaged caused by a $45 cable.

all parts are at suzuki , every single one.

Jul 22, 2009 | 1991 Geo Tracker

1 Answer

1995 Tracker, after clutch cable replacement - won't start


check and replace the negative battery to the engine, the starter is grounding through the clutch cable, very common.

May 07, 2009 | 1995 Geo Tracker

1 Answer

Tranny clutch problems in Geo Tracker


well i have test.

if you have 1inch free play in pedal it clutch slips ,
clutch is bad , or the 89 93 bell housings are diffr.

was disk put in not backwards?
is it a new clutch.




Nov 19, 2008 | 1992 Geo Tracker

1 Answer

1992 Geo Tracker


geo trackers all have the problem of after 3/4ths down on the gas pedal it slows down and if you gas it its supposed to down shift if its automatic because it means it revs higher for you to go faster

Jul 03, 2008 | 1993 Geo Tracker

Not finding what you are looking for?
1992 Geo Tracker Logo

377 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...