Question about 2005 Nissan Xterra

1 Answer

2005 nissan xterra windshield reservoir leak

How do you get to the windshield fluid reservoir tank?

Posted by on

  • Anonymous Mar 19, 2014

    I cannot locate the windshield washer fluid reservoir.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

You may need to remove wheel shield
(it hard to say with out seeing it)
it may loose hose

Posted on Feb 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Windshield wiper fluid leaks


pipe from washer bottle could be cracked or perished. try follow pipe from water bottle to sprayers and check condition of pipe. sounds like leak is close to bottle

Jul 12, 2016 | 2009 Nissan Xterra

1 Answer

My xterra shows code 463. The fuel gauge is not working right. What should I be checking? Do I have to remove the gas tank to repair it?


Put--- ( nissan recalls & problems) --- in your search engine

You won't like what you read

The dealer may replace the sending unit, as all fuel
tanks are deformed ,all radiators leak,etc,not good

Mar 16, 2011 | 2005 Nissan Xterra

1 Answer

Which fluid do I top up with in the reservoir next to the converter under the bonnet? Toyota prius 2005.


Is a old school habit to top up fluids, if is low is , then there is a leak, or somebody serviced wrong, the reservoir that you are mentioned is call inverter reservoir, it uses long life toyota coolant, if the water pump leaks it is the one that will get low.

for the record, the only fluid that you refill is the windshield washer fluid.

Jan 20, 2011 | Toyota Prius Cars & Trucks

1 Answer

What type of transmission fluid should be used for 2005 Nissan xterra Automatic?


Use NISSAN Type Matic J ATF, factory fluid is the best way to go, other types may cause damage to your tranmission or poor shift performance

May 27, 2010 | 2005 Nissan Xterra

2 Answers

HOW TO REPLACE A FUEL PUMP FOR A NISSAN XTERRA



Removal & Installation

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Relieve the fuel system pressure.
  3. Drain the fuel tank.
  4. Remove or disconnect the following:

    Negative battery cable Fuel pump module harness connectors Filler hose shield Fuel pressure and return lines Filler hose Vent hose Evaporative Emissions (EVAP) hose Fuel tank skid plate Fuel tank Fuel level sender Fuel pump

To install:
  1. Install or connect the following:

    Fuel pump Fuel level sender. Tighten the screws to 17-23 inch lbs. (2.0-2.5 Nm). Fuel tank. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). Fuel tank skid plate. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). EVAP hose Vent hose Filler hose Fuel pressure and return lines Filler hose shield Fuel pump module harness connectors Negative battery cable
  2. Fill the fuel tank.
  3. Start the engine and check for leaks.

Mar 31, 2010 | 2005 Nissan Xterra

1 Answer

2000 nissan xterra...windshield washer fluid pump motor has failed. How do I get to and replace the motor?


On the drivers side of the vehicle just behind the front bumper is the washer fluid reservoir. The washer pumps (2 - one for the back and one for the front) are located ont the face of the reservoir.

1) Drain the resevoir. (You can reuse this fluid, so put it in a clean container)
2) Disconnect the wiring harness for the problem pump.
3) Remove the sprayer line.
4) Remove the pump. It is held in by being snapped into a channel on the resevoir and by the rubber grommet. This may take some elbow grease.
5) Remove the old grommet.(If your new pump came with a new grommet)

Installation is reverse. Usually new pumps come with new grommets. If not, it is ok to reuse the old one.

Jan 25, 2010 | 2000 Nissan Xterra

1 Answer

WINDSHIELD RESERVOIR RAPIDLY EMPTIES WHEN WASHER FLUID IS ENGAGED. THE RESERVOIR RETAINS FLUID WHEN THE PUMP IS NOT ENGAGED.


There a small diameter hoses that run the the nozzles for the front and rear windshield. More than likely, one is loose or cracked and is leaking. Do you have good spray on the windshield as you operate it? Is one weaker than the other? - If so, you definitely have a leak in a hose or nozzle. Another common leak area is around the reservoir edge or near the pump. The pump commonly resides at the bottom of the reservoir.
Hope this helps!
Rate this solution!

Jan 05, 2010 | 2005 Chrysler Town & Country

2 Answers

I have a 2005 Chevy Equinox and my windshield washer fluid does not work. The reservoir is full and the wipers wipe, but no fluid comes out. nothing is leaking under the car either. what else can i check...


u will need to pull the washer fluid tank out and check to see if the tank motor that pumps the fluid is getting 12 volts when the washer switch is pushed, if it is the pump will need to be replaced, if it isn't then the washer switch is defective, this switch is part of the turn signal switch.

Aug 24, 2009 | Chevrolet Equinox Cars & Trucks

1 Answer

My 2005 is leaking some water based fluid on the


object could have punctured a hole in radiator, radiator hose, windshield washer tank or washer hose

Aug 05, 2009 | 2005 Nissan Quest

Not finding what you are looking for?
2005 Nissan Xterra Logo

Related Topics:

430 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...