Put truck into either 2nd or reverse and the electrical cuts out... headlights dim, truck dies. heard a slight crackle through radio which was off right before it happened
SOURCE: truck wont move in gear [manual trans] why?
push the clutch pedal all the way and see if the slave cylinder pushrod is going out at least an inch, if not replace the slave cylinder, if it does goes out, sad to say but you have problem somewhere else inside your clutch assembly
SOURCE: no reverse gear but all other dears work
one of 2 things. 1 the reverse gear is out on transmission or 2, the trasmissions on chrysler are bad about computer module in transmission going bad. either way you are looking at a transmission rebuild. i use to have alot of plymouths and dodge taxi cars and a rebuild was usually 1500.00 you can get a good low mileage trasmission from a auto salvage for alot less.
SOURCE: my truck stumbles then cuts out when accelerating
check fuel pressure if less then 55 p.s.i change fuel pump and fuel pressure regulator
SOURCE: volvo xc70--engine starts but truck doesn't move when put in gear
check tranny fluid.if fluid level is correct.change fluid and filter if its been a long while.if it still wont go into gear.your tranny oil pump is worn.and the forward clutch seals and drive plates worn.
35 views
Usually answered in minutes!
×