Question about 1993 Mitsubishi Mighty Max
I would like to know where the fuel shut off switch for my 1993 mighty max is located at. thank you
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
See Figure 1
The starter motor is located on either the lower right hand (passenger) or left hand (driver) side of the engine, bolted to the transmission housing with two mounting bolts.
Fig. 1: Common starter location and installation-the starter is a fairly heavy component, be careful when lifting it out of the vehicle
Posted on Jan 10, 2009
the fuel pump has nothing to do with the oil.your oil sending unit could be bad causing the poblem you describe but not the fuel filter
Posted on Jan 17, 2009
I'm not sure if your '87 is the same as my '88 or not, but mine is located just in front of the tank. I also have to remove the rear driver-side wheel to get at it.
Hope I've helped, don't forget to rate.
Posted on Feb 24, 2009
Actually, an older Mitsubishi truck (mine is an '88) doesn't have a horn relay. The horn (located just behind and below the front grill on the driver side) has two leads. One has 12v that comes on when the ignition is turned on. The other has a lead going to the horn button. That button will ground the horn, causing it to blow. The ground actually AT the horn is not needed at all. To get at the horn to check it out, you remove the screw directly under (but on) the steering wheel. You can then flip up the horn assembly...just put pressure upward on the bottom of the horn and it will flip out. The lead coming to the horn should have 12V on it if the ignition is on. When you ground that lead, the horn should blow. If there is no voltage on the lead, the horn is probably shot (circuit is open) and you will need a new one. So, if your wiring is ok and your connectors are connected, either you have a bad horn or there is a problem with the horn itself in producing a ground.
Posted on Jul 03, 2009
First thing I'd recommend doing is getting a benley or Haynes repair manual. Your fuel filter my be internal off the fuel sender in the gas tank.
Posted on Apr 07, 2010
Tips for a great answer:
Mar 10, 2016 | 1987 Mitsubishi Mighty Max
Jan 21, 2012 | 1993 Mitsubishi Mighty Max
Dec 05, 2011 | 1987 Mitsubishi Mighty Max
Jul 30, 2011 | 1986 Mitsubishi Mighty Max
May 25, 2017 | 1992 Mitsubishi Mighty Max
Aug 27, 2010 | 1988 Mitsubishi Mighty Max
Apr 23, 2010 | 1991 Mitsubishi Mighty Max
Aug 05, 2009 | 1989 Mitsubishi Mighty Max
Jan 17, 2009 | 1989 Mitsubishi Mighty Max
84 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: