Question about 2004 Volkswagen Touareg
2006 VW Touareg stability control engaging when driving normally on winding road, making a loud mechanical noise
Sounds like you have air in your steering system. I would start by looking for any leaks on your steering system like hose to fitting crimps, steering pump, etc. Check your steering fluid level to make sure it is full and also look for bubbles on the dip stick. If everything looks good, start the vehicle and turn the wheels all of the way to the left and then to the right. Do this while the vehicle is in park and repeat at least 5 times. This will work out any air in your steering system. If the problem persists then the power steering pump may need to be replaced.
Posted on May 24, 2009
The retraction tool all depends on the caliper. My 04 Touareg came with 4 piston Brembo's in the rear and they do not require rotation just compression as in the front which are Brembo 6 piston.
Posted on Aug 30, 2009
Same as any other vehicle.
1. Raise and support vehicle
2. Remove tire/wheel
3. Loosen/remove the two caliper bolts
4. Slide caliper off the rotor.
5. Use a C-Clamp to depress the caliper piston
6. Remove old pads from caliper
7. Install new pads on caliper
8. Install caliper/tighten caliper bolts
9. Install tire/wheel
11 Move to next wheel/repeat
Some people take a turkey baster and remove some of the brake fluid from the master cylinder prior to depressing the caliper piston because it can over flow. If you choose to do that just add the fluid back when finished so it is at its proper level.
Posted on Sep 12, 2009
Try underneath passenger side rear doors,inside the frame.If you gonna replace it yourself make sure you take off gas cap to relieve pressure from fuel system,if not it will spray you bad.
Posted on Jan 04, 2010
Tips for a great answer:
Mar 24, 2015 | Cars & Trucks
Aug 31, 2013 | 2005 Volkswagen Touareg
Mar 06, 2013 | 2006 Volkswagen Touareg 3.0
Feb 09, 2013 | 2004 Volkswagen Touareg
this warning light or any other stays on in the dash it is indicating
that the systems control module (or the system sensor in the case of
lights like low oil pressure, door open indicators etc.) has detected
a fault, it then disables the system (this applies to ABS,TCS, TCM,
SRS and BCM faults and others) as long as the light is on. You must
now have the dealer hook up a special electronic diagnostic tool and
"scan" the system for the fault code that is stored for the
Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module
Oct 16, 2012 | Cars & Trucks
Feb 21, 2010 | 2005 Volkswagen Touareg
Jan 11, 2010 | 2006 Volkswagen Touareg
Jan 02, 2010 | 2005 Volkswagen Touareg
Dec 29, 2009 | 2006 Volkswagen Touareg
205 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: