Question about 2005 Ford Five Hundred

Open Question

Ford 500 2005 cluster inop/reverse light on

What is the fix
cluster or poor solder conn.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Cluster panel lights on 2005 ford freestar goes off and comes back on no problem with engine etc why


Pull the fuse and put it back in, first. Then pull the plug on the back of the IP and put it back in. It is intermittent. These will usually fix the problem... Corrosion.

Jul 01, 2016 | 2005 Ford Freestar

Tip

Ford explorer odometer fix


if your odometer will not light up or it comes on and off them you most likely have a cold solder joint and can be fix with basic soldering skills a soldering iron and solder.

Remove your instrument cluster and check the solder joints on the back of the cluster main board. You may have to flex the board to see the cracks in the solder. i have found the main connector soldering joints to be cracked for the display it self. any in question re solder while you are there.

simple cheap fix and not very time consuming at all.

on Dec 12, 2009 | Ford Explorer Cars & Trucks

Tip

Ford experdition odometer not working fix


if your odometer will not light up or it comes on and off them you most likely have a cold solder joint and can be fix with basic soldering skills a soldering iron and solder.

Remove your instrument cluster and check the solder joints on the back of the cluster main board. You may have to flex the board to see the cracks in the solder. i have found the main connector soldering joints to be cracked for the display it self. any in question re solder while you are there.

simple cheap fix and not very time consuming at all.

on Dec 12, 2009 | Ford Expedition Cars & Trucks

3 Answers

What would cause the directionals an odometer not to work on a 2001 Dodge Caravan


the guest that stated that it was Poor solder joints on the circuit board is 100 percent absolutely correct this is a known problem with dodge and ford someone saying bad drivers in the e c m and whatnot but it's nothing that a solder gun and a keen eye and steady hand can't fix

Jun 06, 2015 | 2001 Dodge Caravan

1 Answer

How do I replace dash light bulbs on a 2007 Ford Escape?


What lights are not working ? The instrument cluster illumination is inoperative or all the lights ,radio , heater control head, all the switches that would be back lighted.
  • The climate control panel illumination is inoperative , The passenger door lock control switch illumination is inoperative. Could need new dimmer switch , new instrument cluster. When installing a new instrument cluster, it is necessary to upload the module configuration to the scan tool. Following installation of the new instrument cluster, download the module configuration from the scan tool into the new instrument cluster. Refer to Section 418-01 .
  • Dec 09, 2014 | 2007 Ford Escape

    1 Answer

    My odometer message center has gone blank. on my 2006 f150 4x4 ,can use give me some advise. thanks ray


    This is usually a cold or poor solder joint that has given up.

    You will need to remove the cluster from the dash to take a look at the solder joints and the pin connector for the message center display.

    sscullys_17.jpg
    sscullys_18.jpg

    This is if the display itself is blank, if ti is just the back light, that is the bulb
    sscullys_19.jpg
    sscullys_20.jpg

    Nov 12, 2010 | 2006 Ford F-150

    3 Answers

    2005 freestar cannot see mileage


    you need an intrument cluster

    Jul 22, 2010 | 2005 Ford Freestar

    1 Answer

    My 2000 Ford F150 Odometer display keeps going on and off.


    There is a loose solder joint on one of the pins inside the cluster. The cluster has to be removed and disassembled in order to resolder . Try googling f150 odometer inop. There should be a step by step repair procedure on there. Good luck.

    Feb 24, 2010 | 2002 Ford F150 Regular Cab

    1 Answer

    TACH INOP 1996 SEBRING


    resisters behind the cluster circuit board. the solder joints came loose. easy fix

    Jun 04, 2009 | 1996 Chrysler Sebring

    2 Answers

    Beeping


    When you turn key on check if airbag light on instrument cluster comes on. 5 beeps is the tone to let you know your airbag light in instrument cluster is inop..

    Sep 03, 2008 | 2003 Ford Escape

    Not finding what you are looking for?
    2005 Ford Five Hundred Logo

    Related Topics:

    81 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    70387 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22041 Answers

    Ron Lankford

    Level 3 Expert

    5386 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...