Question about 1986 Ford Bronco II

2 Answers

1986 Ford Bronco II 2.9 6 cylinder. It will start and run when cold, but after it has warmed up and it is shut off it will not start again.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 27 Answers

Ignition control module/approx 200 bucks installed.

Posted on Aug 10, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 68 Answers

Did you try the temp sensor

Posted on May 22, 2009

2 Suggested Answers

  • 2 Answers

SOURCE: It will not start after it has started once & warmed up

$3.00 pc of **** thermal switch on thermostat housing. get a metal (brass) one if you can. been there...done that...

Posted on May 13, 2009

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford bronco II starts but wont run


i had the same problem. the ignition switch in the column came apart at the crimps. causing it to only have contact in the start position.
i wired mine together.
good luck.

Jul 10, 2011 | 1986 Ford Bronco II

1 Answer

Does an 86 ford bronco ii have more than 4 seats


all bronco II's that i have seen have 2 bucket seats up front and 1 bench in the back that usually had 3 sets of seatbelts.

May 20, 2010 | 1986 Ford Bronco II

1 Answer

1986 FORD BRONCO II - CRANKS BUT NO START - NO SPARK - REPLACED IGNITION MODULE AND HALL EFFECT SENSOR, ALSO TRIED A NEW IGNITION SWITCH. HELP


I just had the same problem, today, check the tan- lt green wire on the fuel relay that is located on the right fender, mine wasn't pushed in all the way, this wire shut down spark and fuel

Mar 01, 2010 | 1986 Ford Bronco II

4 Answers

What is the firing order for a 1984 ford bronco 2


1-4-2-5-3-6
Now you need to know which cylinder is which. If you stand at the front of the truck looking at the engine, the number 1 cylinder is on the left closest to you. The left bank has cylinders 1-3-5 and the right bank has 2-4-6. So number 1 is at the left front and number 6 is at the right rear.

Jan 25, 2010 | 1984 Ford Bronco II

1 Answer

2.9 ford bronco 2 runs about 10 min. then just shuts off like you turned off the key ??


replace you duraspark box, when it warms up it shorts out causing the engine to lose fire and quit.

Jul 18, 2009 | 1987 Ford Bronco II

1 Answer

It will not start after it has started once & warmed up


$3.00 pc of **** thermal switch on thermostat housing. get a metal (brass) one if you can. been there...done that...

Feb 22, 2009 | 1986 Ford Bronco II

1 Answer

1986 Bronco II, 6 cylinder. Finding gas mixed in oil. Will start, but has problems running. Power isn't what it should be. Main problem is gas in the oil. Where could this be coming from.


from unburt fuel in the motor and exhaust. Completely sure thats it. had same problem. Make sure your engine is running hot and and normal operating tempurature. check over all your thermostate sensors. check to make sure actual thermostate is not stuck open. to much gas going through carburator. spark plug not getting efficent fire.

Jul 23, 2008 | 1989 Ford Bronco II

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

426 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...