Question about 2004 Volkswagen Touareg
When I start my 2004 Touareg, it runs for about 30 seconds and then shuts off - everything else works, the radio, lights. etc.
if it occurs when you are moving it is most likley to be the propshaft centre bearing i have done a few....you cant get the bearing seperate im affraid its the whole shaft...hope this helps.
Posted on Feb 20, 2009
Find and replace the Blower fan relay, not sure where it is on your VW but it's common to be in with the fuse box by the battery. Good luck and hope this helps. When the relay goes bad from the heat of the electrical current, it seizes and does not disengage keeping the connection causing the ran to keep running.
Posted on Jul 02, 2009
Same as any other vehicle.
1. Raise and support vehicle
2. Remove tire/wheel
3. Loosen/remove the two caliper bolts
4. Slide caliper off the rotor.
5. Use a C-Clamp to depress the caliper piston
6. Remove old pads from caliper
7. Install new pads on caliper
8. Install caliper/tighten caliper bolts
9. Install tire/wheel
11 Move to next wheel/repeat
Some people take a turkey baster and remove some of the brake fluid from the master cylinder prior to depressing the caliper piston because it can over flow. If you choose to do that just add the fluid back when finished so it is at its proper level.
Posted on Sep 12, 2009
Tips for a great answer:
Aug 31, 2015 | Cars & Trucks
Feb 09, 2013 | 2004 Volkswagen Touareg
Mar 15, 2011 | 2004 Volkswagen Touareg
May 19, 2010 | 2004 Volkswagen Touareg
Nov 06, 2009 | 2004 Volkswagen Touareg
Jul 10, 2009 | 2004 Volkswagen Touareg
Jun 21, 2009 | 2004 Volkswagen Touareg
Jun 02, 2009 | 2004 Volkswagen Touareg
May 24, 2009 | 2004 Volkswagen Touareg
Dec 03, 2008 | 2004 Volkswagen Touareg
115 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: