Question about 1995 Mercury Mystique

Open Question

1995 Mercury Mystique GS - Power side mirror instalation ????????

Timing belt installation
I have a 1995 Mercury Mystique GS and don't know how to remove and install new side mirrors please help me tell me how to install new ones.

Posted by on

5 Suggested Answers

Shadowmaru
  • 33 Answers

SOURCE: 2001 Mercury Sable Drivers side view mirror removal

No you do not, there will be a small plastic cover over the door mounted tweeter.

Squeeze it with your fingers and you should be able to pop it right off.

There are two screws on the speaker and the others should be visible on removal of the speaker itself.

I suggest you bring a soldering iron or a pair of wire cutters because the speaker wiring is soldered on the speaker and the speaker will not fall back through the speaker frame.

Posted on Feb 11, 2009

SOURCE: broken driver side view mirror-2005 camry

Heated mirrors usually have a symbol on them -- a small diagram showing squigley heat lines.

If you don't see this, it's probably not heated. But when you take the mirror off, if it's heated it'll have wires connected to the back.

Yes, you can replace a heated mirror with non-heated -- just leave the wires tucked out of the way when you install the new mirror.

Posted on Apr 29, 2009

  • 60 Answers

SOURCE: Passenger side mirror replacement procedures

If its a power mirror there is more thing you will have to remove to get to the wires but if not there is a screw on the corner piece on the inside of the door. just pull the screw out and the bolts (3) that hold the mirror on are behind it. If it power then you will have to remove the door panel to access the wiring to disconnect it

Posted on Jun 21, 2009

  • 1986 Answers

SOURCE: how do u install a side mirror

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

  • 1986 Answers

SOURCE: Need to replace driver side mirror for Camry 2002, Power mirror

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to fix service port valve on 1995 murcury mystique a/c


a new valve core costs about twenty bucks from auto parts store , but the tool to install it will cost ya about fifty as it's special made to trap the old valve core and not let refergerant all leak out , better to find somebody to install it for ya

May 09, 2014 | 1995 Mercury Mystique

1 Answer

Do you need to replace the timing belt when you change a water pump for a 1998 mercury mystique v6?


You don't have to replace it but you have to take the belt off to remove the water pump for the extra $30.00 i would recomend changing the belt too, unless the belt has been changed less then 20,000 miles ago .

May 09, 2011 | 1998 Mercury Mystique

1 Answer

1995 mercury just died going up hill got fire got fuel but the timinig belt seems real loose do i have to pull the motor to fix


you should not have to pull the engine to do this, you need to take apart the front (timing cover) so that you can access the lower portion where the crank shaft is so you can line up the marks for a new belt installation-the belt has a tensioner so it getting really loose means you should check it out if you decide to do the belt.

Mar 23, 2011 | 1995 Mercury Mystique

1 Answer

I wass wondering how diffcult would it be to fix a timing belt on 1995 mercury mystique? Or is it expensive? And replacing all four brakes? Is that expensive?


FIRST,as long as you line up the pulleys BEFORE you take off the belt its relatively easy.if you feel, you are competant, get on and do it....with brakes they are so simple/logical,as long as you take your time and replace exactly as it comes apart,you will have no problems,WE are here to help if you get stuck.

Sep 09, 2010 | 1995 Mercury Mystique

1 Answer

How to change my timing belt for a 97 mecury mystique gs 2.0


There are so many steps. After removing everything so you can get to the timing belt you need to make sure you have the engine set so the #1 Cylinder is TDC. Remove the old belt and re-install the new one. If you need step by step directions on how to do any of this I recommend you get the Haynes Repair Manual for your vehicle since it will show you those and give you instructions on how to make sure your at TDC. If you try putting that belt on without being set to TDC the engine is not going to run correctly.

Jun 23, 2010 | Mercury Mystique Cars & Trucks

1 Answer

Need a diagram for installing a drivers side electric power mirror on a 1995 mercury villager van


here's 1996, all I have. Please rate.

Mirror, Power — Outside Rear View NOTE: This procedure applies to both RH and LH power outside rear view mirrors.

Removal
  1. Remove the front door trim panel (23942). Refer to Section 01-05 for the removal procedure.
  1. Remove the two outside rear view mirror inside mounting hole cover screws and the outside rear view mirror mounting hole cover (17K709) from the front door (20124).




  1. Remove the wire clip.
  1. Disconnect the power outside rear view mirror electrical connector.




  1. Remove the three power outside rear view mirror bolts and the power outside rear view mirror.




Installation
To install, reverse the removal procedure. Tighten the three power outside rear view mirror bolts to 3-4 Nm (27-35 lb-in). Glass, Outside Mirror
Removal and Installation
Refer to the glass replacement procedures in Manual Mirror for power outside rear view mirror glass (17K707) Trim Cover
Removal
  1. Remove the front door trim panel. Refer to Section 01-05 for the removal procedure.
  1. Remove the two outside rear view mirror inside mounting hole cover screws.


    Remove the outside rear view mirror mounting hole cover.
Installation
To install, reverse the removal procedure. Mirror Control
Removal
  1. Use a small flat-blade screwdriver to pry the power outside rear view mirror control switch from the instrument panel (04320).


May 13, 2010 | 1995 Mercury Villager

1 Answer

What are the timing marks for a 1998 mercury mystisque 4cy....I need to know how to position them


1998 Mercury Mystique 2.0L MFI DOHC 4cyl

e842492.jpg

align the camshafts and the...

20f3fce.gif

Fig. 5: Alignment marks for timing chain installation-left hand side

3da874c.gif

Fig. 6: Alignment marks for timing chain installation-right hand side

Hope thats help.

Feb 02, 2010 | 1998 Mercury Mystique

1 Answer

What parts of a 1995 mercury mistique gs are controlled by its surpertine belt and if the belt has broke, do I only need to have it replaced? A mechanic told me that the belt doesn't just break. That...


the belt will break if old and brittle and yes u need to replace it the belt controls alternator-- charges battery and needed to supply vehicle with power--air cond -power steering pump-water pump-- fan

Oct 19, 2009 | 1995 Mercury Mystique

1 Answer

My mercury Mystique shutters when the heater is turned on or when it is put into gear. I have set the timing according to the book and it still does the same thing. I have replaced the o2 sensor, MAF...


BELIEVE IT OR NOT I THINK ITS YOUR ALTERNATOR! THIS IS TYPICAL FOR THE MYSTIQUE OR SHOULD I SAY (MISTAKE). NOTHING YOU CAN DO , ITS AN ELECTRICAL DESIGN FLAW. THE CARS ARE TO ELECTRONIC FOR THEIR ALTERNATORS OUTPUT. OF COURSE THIS IS MY OWN ASSUMPTION. THEY ARE AN ELECTRICAL NIGHTMARE. HOWEVER I DID FINALLY FIX THE PROBLEM I HAD WITH MINE.( I SOLD IT!)

Oct 10, 2009 | 1995 Mercury Mystique

1 Answer

How to Set timing..


if it like a 98 there are 2 slots on the far end of the cams.remove spark plug #1 closest to the timing belt and set to tdc....then align the two slots so you can get a straight edge into both at the same time....i use a piece of keystock.....place the belt on and thats it....really qiute simple

Jul 01, 2008 | 1995 Mercury Mystique

Not finding what you are looking for?
1995 Mercury Mystique Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

63291 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...