Question about 1985 Nissan 300ZX

1 Answer

I have a 1985 300zx (non turbo)5sp. when you try to drive it,it goes for half a sec. then stops in all gears including rev. you can cont. pressing the gas and it will free up and repeat. iam thinking rear axel???but aint to sure!!!! any help would be great.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Do u think it might be the differential

Posted on Mar 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

So I'll drive my 4.3 non vortec for a bit then shut it off for line 10 min then I'll start back up and it bogs down. The oil gauge goes up and down over and over and it won't quit bogging down unless I...


Replace the fuel injector system. When you shut it off, the fuel continues to dump in the cylinders. This is the reason you have to open the throttle and rev the engine up. Getting rid of excess fuel.

Feb 07, 2015 | Cars & Trucks

1 Answer

I have a 99 gmc jimmy Ive notice while i slow down for a turn my car is still trying to accelerate and only when I come to a full stop it goes back to normal Also when first starting the car it revs up to...


Vacuum leak from brake booster. If you hear a sucking noise when you press the brake pedal replace it. Another way to check it is to place truck in gear set e-brake press brake pedal repeatedly and see if idle goes up and down. DO NOT PRESS GAS PEDAL DURING TEST.

Feb 01, 2014 | Cars & Trucks

1 Answer

Squeak in low gear.


Try spraying the belt with a "dressing" spray. With the engine not running of course. If it stops, then your belts may need adjustment or replacement.

Feb 06, 2010 | 2007 Mazda MAZDA6

1 Answer

Just started to pull away from a stop in 1st and


sounds as though your input shaft broke, this would cause a loud clunk, cause it to feel as though in gear, and cause no pull.

Oct 26, 2009 | 1988 Nissan Maxima

2 Answers

I have a 93 mazda mx3 4cyl 5sp. it is really hard to put in gear


sounds like the clutch is going to need replacement and while there you should change the slave cylinder too

Aug 06, 2009 | 1993 Mazda MX-3

1 Answer

Hi I havw question how many gears have 1991 nissan 300 zx tt automatic and when at chenging gears (rev) I heard around 4000rpm.


300zx auto will have 4 gears. 1-3 are normal running gears 4th is said to be an "overdrive" gear.

shift points should be under 4krpm, with light driving. my 300zx non-turbo usually shifts around 2-3K.

throttle position sensor could need adjustment or replacement. trans fluid should be checked to see if it's in good shape and full.

Jun 21, 2009 | 1991 Nissan 300ZX

5 Answers

Renault traffic 03 1.9dci low power until turbo cuts in and wont rev past 3800rpm in any gear also occasionaly cuts out with engine management/glow light on no faults on diagnostics


my trafic did the same.no power pulling away until the turbo kicked in and it turned out to be the airflow meter.Hope this helps as it cured mine.Plus non of them rev past 3800 revs its normal.

Feb 28, 2009 | 2006 Renault 181

1 Answer

5th gear doesn't lock


5th gear is gone, it'll be cheaper to find a good second hand one with a waranty than to get your one fixed sorry to say. The inside of gearboxes are only a place for gearbox specialists and they arent cheap unless you know someone.

Nov 24, 2008 | 1988 Nissan Pulsar

2 Answers

1990 300zx 2+2 Non Turbo


That means the transmission is going into Limp mode - something's wrong that is making the car believe it can be damaged by the speeds the upper gears will allow you to reach. For starters, check the fluid level (or just change it - it's not a bad idea), and disconnect the battery for an hour or so to put the ECU into relearn mode - this will clear current fault codes and allow you a fresh start to see if the condition reappears, or if it was a fluke failure of some part that caused the car to repeatedly go into limp mode.

Sep 07, 2008 | 1990 Nissan 300ZX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...