Question about 2002 Isuzu Axiom

1 Answer

Isuzu axiom 2003

What is the location of the fill hole for the transmission on the axiom???

Posted by on

  • Anonymous Mar 16, 2009

    Whare the hell do i check my Tran. Flu. ? Also whare di I put new Flu. in at? IM SO LOST???????????????



1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

There is no dipstick or filling ports in the engine bay. underneath the car near the valve boby pan there are 2 bolts, one for draining the trans., and one for filling the trans. this is not the easiest of repairs and it is quite messy. drop cloths or some kind of catch would be wise. first drain the pan by removing the lower bolt. allow the fluid to completely drain and reinsert bolt. next remove the larger (valve body) pan. there is a filter that you will see is held in place by 3 bolts, remove filter and replace with new one. clean mating surfaces of all debris and fluids. next apply the gasket to the pan you just removed and cleaned. fill the empty pan with about 3-4 quarts of new ATF. a second pair of hands here is recommended. together realign pan to trans. careful not to spill fluid! apply a few bolts to allow for free hands. insert all bolts DO NOT OVER TIGHTEN BOLTS! this is very important, only tighten bolts until gasket just starts to squish. over tighten and you risk a new leak.

now the messy pain in the **** part. in oder to check fluid level, you need to have car parked on level ground. remove the upper bolt from the pan you just reapplied. You will need some sort of pump and a few feet of hose to complete the filling process. fill until fluid runs back out the hole, quickly insert bolt, tighten to specs. and wipe exterior of pan to see for any new leaks.

this should solve any trans. slips do to ATF seepage.
best of luck

Posted on Mar 12, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Isuzu axiom 2002 has got reverse no forward

Could be possibly a bad solenoid in the transmission. Most likely a transmission rebuild.

Nov 17, 2014 | 2002 Isuzu Axiom

1 Answer

I have just had the transmission rebuilt in my 2003 Axiom an it still will not go into first gear. All electrical wiring has been checked out. Could this be a computer issue?

if you just had the transmission rebuilt then take it back to were you had the work done as it maybe something that they either have or have not done that should have been.

Mar 06, 2014 | 2003 Isuzu Axiom

1 Answer

2002 isuzu axiom won't move when put in drive or reverse

ur linkage come un clipped from the rod that goes into the transmission or ur bands need adjusted if its a clutch bleed the clutch

Feb 27, 2013 | 2003 Isuzu Axiom

1 Answer

2002 Isuzu AXIOM - Transmission fluid FILL

For how to fill transmission fluid on Isuzu Axiom,click the link below :----
--------This will help.Thanks.

Feb 07, 2012 | 2002 Isuzu Axiom

1 Answer

How can I flush my 2002 axiom Isuzu transmission?

I don't recommend using the flush machine on any vehicle. In the case where you have to flush the transmission then you need a special machine that was running about $160 to $200 to flush a transmission. I recommend removing the drain pan and draining the transmission. After the transmission is drained start the vehicle for about a minute to empty the torque converter. Replace the filter and the pan and fill to the proper level. Test drive the vehicle about 2 blocks to make sure everything gets filled and top off transmission as needed.

Feb 28, 2011 | Isuzu Axiom Cars & Trucks

3 Answers

Changed filter, need to know where to put in atf

This veicle has no dip-stick for the ATF, You will need to raise the car and support on jackstands. On the bottom of the tranny pan there are 2 bolts one for drain (the lower one) and the upper one for filling. Here's the tricky part, the fluid will have to be pumped in with the engine running, when it starts to overflow, then it full. Cut engine and tighten fill bolt.

Mar 02, 2010 | 2002 Isuzu Axiom

2 Answers

I cannot locate the dip stick to check the transmission fluid level on a 2002 izuzu axiom

The 2002 Axiom does not have a dipstick to check the transmission fluid. The holding tank is on the right side by the brake fluid. Check your levels & fill if needed there. It has a "sealed" transmission.

Dec 04, 2009 | 2002 Isuzu Axiom

1 Answer

2002 izuzu axiom- can't find transmission dip stick

i have a 2002 isuzu axiom and i have been having some recent problems with my transmission and it took a while to find out but eventually i found out that it has a closed transmission and there is no dipstick there is a fluid resevoir next to the brake fluid but to get the transmission fluid filled or flushed it has to be serviced at a shop

Nov 11, 2009 | 2002 Isuzu Axiom

4 Answers

Leaking transmission fluid

How can I check transmission fluid on a 2002 Axiom - dipstick!

Jul 21, 2008 | 2002 Isuzu Axiom

Not finding what you are looking for?
2002 Isuzu Axiom Logo

313 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides