Question about 1996 Buick Regal Olympic Gold

1 Answer

Hood cable broke on my 1994 olds cutlass

Can anyone tell me how to take the old cable out and replace with a new one. I found a new part.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 1,596 Answers

Remove Kick Panel Latch handle is affixed to
Disconnect cable from Latch Assembly and Closely fallow and Remember the ROUT it takes to the Interior Push it Through Firewall and Remove Kick Panel from Vehicle Look Closely at the Method Used to Connect the Cable End to Lever and Remove . Install In Reverse Of Removal

Posted on Feb 21, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 1994 Olds cutlass 3.1 and the dip stick broke off at the handle. can you give me an idea?

use some pliers or vice type wrench to pull it out and buy a new dipstick or a used one from a junk yard which wld be cheaper n work just fine n better than trying to weld the old one back together

Sep 11, 2013 | 1996 Chevrolet Blazer

1 Answer

1994 olds ciera rear brakes - parking brake cables are too close too hubs. back side of wheel studs are hitting the spring on the cable causing a very annoying click, click, click. happening on both sides....

I Just replaced my parking brake cable on my 94 olds ciera . I never had a problem . I would take your car to a mechanic so they can check it !! It could be bent too far in towards the back of the studs and may need to be replaced !!

Aug 29, 2010 | 1994 Oldsmobile Cutlass Ciera

1 Answer


climb underneath with a long screwdriver and pray

Jul 24, 2010 | 1995 Oldsmobile Cutlass Supreme

1 Answer

1994 olds cutlass supreme volt gauge shows low have

Could be .. did you do any voltage checks? I suggest you check altenator output as well as battery voltages under various circumstances.

Mar 24, 2010 | 1994 Oldsmobile Cutlass Ciera

1 Answer

The hood release had broke and its all out. How can i instale a new hood release cable without the guide of the broke one? I live in Venezuela and there's not Oldsmobile Dealers here, i'm gonna make it by...

If parts are can also use a short length of wire and run it out through the front grill and open it by pulling the wire.
Just make it so nobody can see the wire.

Sep 24, 2009 | 1994 Oldsmobile Cutlass Supreme

1 Answer

1994 Olds cutlass supreme..Electric Window not working

That should be it for fuse compartments..

If its not the fuse(s) or relay it might bethe switch,, or the motor..

Try to determine if there is power getting to the switch,, if so see if there is power to the motor..

You can find replacement parts pretty cheep on-line..

Hope this helps !!
Please rate me good ;o)

Jul 10, 2009 | 1995 Oldsmobile Cutlass Supreme

1 Answer

The cable broke which opens the hood in my 1994 Lexus LS400. What is the best way (least expensive) to replace this cable? Thanks

if it broke with hood open its not going to be hard to replace it.first you go to auto parts place or dealership buy the cable feed it through the floor board to the hood where cable goes. if hood cable broke with hood down its going to be hard to see or get to the hood open mechanism.through the radiator open under neath the front bumper.

May 16, 2009 | 1994 Lexus LS 400

1 Answer

Ecm module gone bad psooiblely

Clean and tighten your battery cables. I have a 95 cutlass supreme that did the same thing. If that doesnt fix it, the ECM may be to blame. When the ECM went in my Olds, the car would fire but only run for 2-3 seconds. Once I had the ECM replaced it was fine

Jan 10, 2009 | 1994 Oldsmobile Cutlass Supreme

1 Answer

Hood will not open

NAPA will replace the wipers for you as for the hood not opening while you are pulling on the lever have someone else push down lightly on the hood and once you get it opened then before closing it again spray either WD-40 or some white lithum grease on the hood latch and lever mechanism and this should keep it from sticking next time

Jan 09, 2009 | 1989 Oldsmobile Cutlass Ciera

1 Answer

My son has a 1994 Olds Cutlass Supreme SL. His battery is dead and he can't get the doors open. They are unlocked and will only open part way. He needs to get inside to release the hood latch so he can get...

There is a latch with a hood release cable connected to it. It can be reached from underneath, between the grill and radiator, or you can reach it through the grill.

Jan 03, 2009 | 1994 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
1996 Buick Regal Olympic Gold Logo

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides