Question about 1991 Toyota Previa

1 Answer

The bearings are gone in my 2001 european toyota previa

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Just blow and clean the spark plug

Posted on Feb 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is it that the oil pump of my toyota previa is not lubricating


Did you prime the new pump with some engine oil? Another trick is to use some light grease to coat the pump gears so they will seal against themselves. If you primed the pump and are sure the pump is working, you may have worn out engine bearings or some internal oil leak that is keeping the oil from getting pressure.

Oct 19, 2014 | 1991 Toyota Previa

1 Answer

Toyota handbooks


You might have a door not fully shut! Check all your doors to make shure they are closed properly! Or a bad sensor to one of the doors!

Apr 18, 2014 | 1997 Toyota Previa

1 Answer

Noise coming right front wheel. I assume that it is the wheel bearing. My question is: are there an inner -AND- outer bearing. Also, how dificult are they to replace. 1993 Toyota Previa front disc brakes....


whole assembly has to be changed, the bearing is one non-dissasemblable unit, it has to be pressed out and in. best done by someone who has the right tools.

Jun 30, 2010 | 1993 Toyota Previa

1 Answer

Toyota previa worm rear wheel bearing how hard are they to renew are they taper


yes they are tapered and yes you will have to dissasemble diff to remove shafts

Mar 06, 2010 | 1993 Toyota Previa

1 Answer

Flasher unit on a 1994 toyota previa


hey there,yeh its under the steering wheel column under the dash..it should have a 4 pin plug in it,,,,disconnect the connection to see if it has 4 pins,if it has thats it...ull get 1 in a breakers yard for about a fiver....

Apr 19, 2009 | 1997 Toyota Previa

1 Answer

Brake light not working


Assuming you tried a new bulb(bulbs can look ok even though they are broken) i would suggest you locate the fuse for that light and check/renew

Mar 07, 2009 | 1997 Toyota Previa

1 Answer

My 1995 Previa check engine light goes on and off


My Previa was doing the exact same thing and it turned out to be a LOT of carbon deposits in the connecting passage between the throttle body and EGR valve. It just needed cleaning. That little passageway tends to get clogged on Previas a lot.

Feb 18, 2009 | 1995 Toyota Previa

1 Answer

I have a 2.5ltr toyota previa n reg


Possible air leak take off engine covers and spray with wd40 whilst engine is running if idle increases and engine becomes less erractic then air leak is were you sprayed wd40 normally its a gasket gone

Jan 12, 2009 | 1993 Toyota Previa

1 Answer

Noisy rear bearing?


Is isnt the rear end it would be very bad shaking and wouldnt last long because it would throw a bearing out. So its most likly the wheel bearing and you can just take it to a local automotive shop.

Aug 12, 2008 | 1991 Toyota Previa

Not finding what you are looking for?
1991 Toyota Previa Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...