Question about 2005 Pontiac G6

2 Answers

Changing heahlight on a g6 2005

On driver side

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Removing headlight

Posted on Mar 13, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Remove head light assembly, replace bulb and re-install

Posted on Feb 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Head light have low but when using high does not work just on one side drivers side


HELP! headlight not working even after change - Nissan Forums ...

www.nissanclub.com/...nissan.../302674-help-headlight-not-working-eve...

Apr 1, 2010 - 13 posts - ‎6 authors
My passenger side low beam headlight recently went off on me. ... I've changed the bulb again, and changed the fuse just in case, but .... My driver side headlight wire got loose so when i hit a bump at night if would flicker. ... When you notice one side not working (Low or High beam) it could be the module. Headlight replacement
15 posts
Jan 22, 2009
Low beams don't work but High's do
8 posts
Mar 20, 2005
More results from www.nissanclub.com

Dec 20, 2015 | 2004 Nissan Sentra

1 Answer

2003 expedition engine cut off when truning on heahlights


have your alternater and battery tested, it sounds like you dont have enough voltage to run your car

Jul 30, 2013 | Ford Expedition Cars & Trucks

1 Answer

Heahlight flase and truck will not run for more than 2 or 3 seconds


You have either a bad alternator or grond that is draining the electricity into the chassis. If that is the case, when you turn the lights on there wont be enough juice to power the ignition system. Autozone and many other reputable auto parts stores may chech your charging system for free. Good luck and i hope i was able to shed some light on your issue.

Mar 30, 2011 | 1997 Dodge Dakota

1 Answer

How to replace heahlight bulb in a 1994 Audi What bulb do i purchase? How do i release the clip that holds the light unit in place?


I replaced my globes not so long back.
The metal clip you simply push down. Replacing the left light is challenging as the air intake is in the way but its not impossible. After removing the clip there is a plastic cap. Remove it.
Then remove the cable that feeds power. You should be able to see the rear of the 'globe'. There is another spring loaded metal clip holding the 'globe' in place. Push the two ends of the clip together to remove this clip. The globe should be free now. Remeber the globe go in a specific way, so take note. I bought to Halogen globes for my Audi as these immitted a stronger beam. Please, whatever you do DO NOT TOUCH THE NEW GLOBES GLASS. The natural oil from your fingers will impact the lifespan of these and you'll have to replace these again. Remember to also reallign the beams.

May 26, 2010 | 1994 Audi Cabriolet

1 Answer

I need to change the headlamp on my 2006 Maxima - driver side.


The drivers side is the one I have changed which is pretty simple. Remove the air filter and compartment and you can access it from there. Apparently the passengers side requires the removal of the washer bottle.

Jan 09, 2010 | Nissan Maxima Cars & Trucks

1 Answer

2004 Yukon. driver side air conditioner not working


you need to change drivers side temp door actuator then disconnect battery for 5 seconds and reconnect after changing the part, turn key on for 60 seconds with touching heater control to allow actuator to program and then it will work.

Sep 19, 2009 | 2004 GMC Yukon

1 Answer

2004 Grand Am Coupe Passenger Window Problem


Yes you will have to replace switch on drivers door. That is where the problem is.

Sep 17, 2009 | 2004 Pontiac Grand Am

2 Answers

Driver's side air blowing warm, won't change


Sounds like there is a crack in the vent that leads to the drivers side, and hot air from the engine is leaking through.

Aug 29, 2009 | 2003 Hummer H2

1 Answer

Want to change headlight


Sorry, I have the same problembut the answers are not what you want to hear.
1) The headlight assemblies are mounted to the front Bumper and grill support "system". To remove the light assemblies there is a "hidden" mounting system that cannot be accessed while the bumper is mounted on the jeep.
2) Most Hayes/Chilton and other POS (..worthless) consummer repair manuals do an extremely poor job of explaining (thats a laugh) or showing (again the pix and diagrams ****) how to remove the bumper.
3) I suggest going to the local Jeep dealer and spending $60-75 for an official Shop mechanics manual for a slightly better explanation and illustration.
4) If you are patient, mechanically talented, and can do without the Jeep for a day, you can (a) remove the grill, (b) remove the radiator 'retainer' top (the metal U that looks like its the top part of the radiator, (c) use #10mm sockets and box wrenches to remove the tubular bumper mounts from the grill area, (d) use pliers to compress the push-in pins on the very bottom of the bumper (below the crack pulley) and remove the plastic lower bumpersection. ** That is as far as I have gotten**.

Dec 29, 2008 | 1996 Jeep Cherokee Country

Not finding what you are looking for?
2005 Pontiac G6 Logo

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...