Question about 2004 Audi A4

1 Answer

Audi A4 how to remove the front door panel to replace the electrical motor, Audi A4 2004 2l

Posted by on

  • Anonymous Mar 24, 2014

    Audi driver seat motor makes noise but doesn't move up or down

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

Not sure if they've changed it but this is what i do for my 99 a4

First remove the screw in the handle pull, it should be next to where your fingers go.
Pull down on the black piece of plastic and remove the screw form the door
Then remove the screws on either end of the door, one near the door jam on top and one near the other side, same place.
Finally pull up then out and the door panel should come out

Hope that helps

Posted on Jun 17, 2009

1 Suggested Answer

chain saw
  • 94 Answers

SOURCE: how to remove front door panel to replace window

FIRST CHECK THE CABLES THAT RUN INTO THE DOOR BECAUSE THEY CAN GET CUT THOUGH COMMON PROBLEM (JUST WERE THE DOOR HINGES INSIDE RUBBER BOOT.) DOOR PANEL REMOVAL...... PRIZE OUT THE TRIM PANEL AT THE BASE OF ARMREST UNDO TWO SCREWS (DRIVERS SIDE) OR ONE SCREW ACCESSIBLE THROUGH THE ARMREST UNDO THE SCREW AT THE BASE OF THE DOOR TRIM IN THE CENTRE. STARTING AT THE FRONT EDGE CAREFULLY PULL THE TRIM PANEL (ABOVE THE INTERIOR RELEASE HANDLE ) AWAY FROM THE DOOR TO RELEASE THE CLIPS, THEN SLIDE IT TO THE FRONT TO UNHOOK THE REAR EDGE OF THE TRIM PANEL.UNDO THE 4 SCREWS IN THE TRIM PANEL RECESS NOW PULL THE DOOR PANELAWAY FROM THE DOOR FRAME RELEASING THE RETAINING CLIPS, SOME FORCE WILL BE NEEDED PREPARE FOR SOME CLIPS TO BE BROKEN THEN LIFT THE DOOR PANEL UP SQUARELY NOW YOU CAN EASILY GAIN ACCESS TO ELECTRIC MOTOR.HOPE I WAS SOME HELP TO YOU THANKS STAN

Posted on Feb 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace the windows in an Audi a4 2002 years


front or rear.front doors have to be stripped to frame.frame must be removed from door,lay it somewhere clean & soft.drill out rivets holding regulator to frame & remove from glass,refit new one using new rivets.nb when removing frame/glass from door,you will see wedge shaped spacers,make sure they go back o the same way.

Jan 12, 2010 | 2002 Audi A4

2 Answers

Heater blower does not work on my audi a4, where


The blower motor is located behind the glovebox.

You will need to remove the glovebox and you will see the blower motor at the top right side. Remove the screws holding it, disconnect the electrical connector and remove it from the car. It is a tight squeeze, be patient.

Dec 19, 2009 | 1998 Audi A4

1 Answer

How do i remove the door panel on my 97 audi a4?


Hi,
You have 2 screws on front and rear of door panel (on the sides / top) and where door handle is , take ouut that screw , than Pull handle shell downward out of door trim. Remove bolts (2x).Lift door trim up and out of door shell.
Let me know, if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!

Nov 04, 2009 | 1997 Audi A4

1 Answer

Remote wont open boot on Audi A4 2002.Working fine for doors. This stopped working without warning.I have to use the key manually.I did what it said in the manual about position of the door lock but to no...


The motor is under the boot lid if you take platic panelling off then disconect the switch and re-fit it then it may just be a bad conection , if you have no joy then it may need replacing or the electrics need testing.

Sep 03, 2009 | 2002 Audi A4

1 Answer

My 2000 S plate A4 1.6 SE front passenger door will not open


you would have to try and remove the door panel if possible and find the rod that controls the latch and open the door.

Aug 25, 2009 | 2003 Audi A4 Cabriolet

1 Answer

Back doors locked permanently


remove door panels look for the motor and rod that actuates the lock,remove rod from motor ,should be able to open manualy check for any bent or broken components

Jul 02, 2009 | 2003 Audi A4 Cabriolet

1 Answer

Door panel


Here's how:

First, take out the two screws at the top of the door panel, screwed into the top corners and pointing toward the middle of the door panel.

Second, inside the door pull (where you pull the door shut) is one screw pointed backward - remove that. Then force the inside "lining" of that pull downward and remove it.

Third, remove the screws you have just uncovered (two on the front door, one on the rear door).

That's it - just lift the panel upward and it'll be off.

May 17, 2009 | 1998 Audi A4

2 Answers

Replace window switches on Audi A4 2003 cabrio


LOOK AT MY SOLUTION TO REMOVE DOOR PANEL STEP BY STEP...THIS WILL HELP YOU...HOPE I WAS OF SOME HELP TO YOU (EASY JOB)

Mar 01, 2009 | 2003 Audi A4 Cabriolet

1 Answer

How to remove front door panel to replace window electrical motor, Audi A4 2004 model 2l


FIRST CHECK THE CABLES THAT RUN INTO THE DOOR BECAUSE THEY CAN GET CUT THOUGH COMMON PROBLEM (JUST WERE THE DOOR HINGES INSIDE RUBBER BOOT.) DOOR PANEL REMOVAL...... PRIZE OUT THE TRIM PANEL AT THE BASE OF ARMREST UNDO TWO SCREWS (DRIVERS SIDE) OR ONE SCREW ACCESSIBLE THROUGH THE ARMREST UNDO THE SCREW AT THE BASE OF THE DOOR TRIM IN THE CENTRE. STARTING AT THE FRONT EDGE CAREFULLY PULL THE TRIM PANEL (ABOVE THE INTERIOR RELEASE HANDLE ) AWAY FROM THE DOOR TO RELEASE THE CLIPS, THEN SLIDE IT TO THE FRONT TO UNHOOK THE REAR EDGE OF THE TRIM PANEL.UNDO THE 4 SCREWS IN THE TRIM PANEL RECESS NOW PULL THE DOOR PANELAWAY FROM THE DOOR FRAME RELEASING THE RETAINING CLIPS, SOME FORCE WILL BE NEEDED PREPARE FOR SOME CLIPS TO BE BROKEN THEN LIFT THE DOOR PANEL UP SQUARELY NOW YOU CAN EASILY GAIN ACCESS TO ELECTRIC MOTOR.HOPE I WAS SOME HELP TO YOU THANKS STAN

Feb 21, 2009 | 2004 Audi A4

2 Answers

Electrical fault Audi A4 2002


PRISE OUT THE TRIM PANEL AT THE BASE OF THE ARMREST WITH A FLAT-BLADED TOOL UNDO 2 SCREWS(DRIVERS DOOR) SINGLE SCREW ACCESSIBLE THOUGH THE ARMREST ON PASSENGER SIDE ,NOW GO TO THE BASE OF THE DOOR TRIM UNDO THE SCREW IN THE CENTRE,ONTO THE TOP TRIM NOW ABOVE THE RELEASE HANDLE,STARTING AT THE FRONT EDGE(DOOR HINGE SIDE) CAREFULLY PULL THE TRIM PANEL AWAY FROM THE DOOR TO RELEASE THE CLIPS,THEN SLIDE IT TO THE FRONT TO UNHOOK THE REAR EDGE OF THE TRIM PANEL,UNDO THE 4 SCREWS YOU CAN SEE,UNHOOK CABLE FROM REAR OF INTERIOR DOOR HANDLE,DISCONNECT WIRING PLUGS SPEAKER ,WINDOW MOTOR CONTROL UNIT AND THERE YOU HAVE IT ..EASY... IF YOU START NOW YOU WILL HAVE IT FINISHED IN 2 DAYS...ONLY JOKING....SHOULD TAKE 1 HOUR..HOPE THIS WILL BE OF SOME HELP TO YOU...LET ME KNOW HOW YOU GOT ON

Jan 25, 2009 | 2002 Audi A4

Not finding what you are looking for?
2004 Audi A4 Logo

962 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

13152 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...