Question about 1998 Chevrolet Monte Carlo

1 Answer

Can i put elct seats in my car if it came without

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 6,674 Answers

I would assume mounting would be similar or same, and you may even find wiring there already if your lucky. Take lots of measurements before diving in, as in where bolts on floor etc, to make sure. Some of the bigger autorecyclers have software that will tell you for sure whether it will work or not, if you give them a call. One other thing I would do, is check with local GM parts dept and see if you can buy those seats new, and if there is any problems with liability issues. I know when I was with Chrysler, we couldn't sell certain seats unless they were installed by a Chrysler approved shop, just for liability reasons.

Posted on Feb 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Switch reset


Did the air bags deploy ? will it crank in neutral ?

Jan 30, 2014 | Oldsmobile Intrigue Cars & Trucks

1 Answer

Panel Dimming fuse won't insert back in fully. If it is suppose to, i see its missing the metal clamps that a couple of other fuses have. Is there a way to resolve this problem to have the fuse back in its...


if it stops a cover from being replaced you can put dialectic elct grease on. 5 bucks a tube . or just a touch of vasoline to make it slippery to slide in .carefully straighten any bent contacts and insert.

Nov 22, 2013 | 2002 Buick Regal

1 Answer

I put an aftermarket driver seat in my 2002 mazda protege 5. I'm under the impression all airbags no longer function without the original seat in. Is there any solution to keep the aftermarket seat while...


no their isnt ,not without fitting the the sensors under the seat ,What you have done is totally illegal as it its not complying with the certificate of homoglonation issued for this vehicle .When this vehicle is presented for its annual mechanical inspection it will fail for being altered and not original

Dec 12, 2009 | 2002 Mazda Protege

1 Answer

The trunk won't open w/ remote or elct. sw. only


Hello. Chances are that the Unlocking mechanism in the trunk is either out of alignment or broken. Take a close look at it. It is where the trunk lid actually latches and locks. See if it is loose, or bent, or broken.

Nov 11, 2009 | 1997 Dodge Intrepid

1 Answer

Super dud! landrover discovery. overheating no emulsification of coolant and oil. no stat, fan clutch engaged all the time, elct sup fan comes on at 200*F. 4.0 unit with a/c.


The impeller blades worn off water pump and not circulating enough water is a good place to start. have to remove and check if thats not problem flush entire system and see if any blockages or corrosion comes out

Aug 04, 2009 | Land Rover Discovery Cars & Trucks

1 Answer

Front washers not working


u can check for damaged or blocked routing of fluid hoses,if ok, check voltage at pump.if power is there replace pump, if power is not there ,probe elct.circuit.for damaged wire.

Mar 20, 2009 | 1994 Mazda 323

2 Answers

Speed sensor


speedo cable could brken,defect vss where cable connects or cable is unplugged from dash,or defect.speedo .for gas gauge look at sending unit elec.connector for corrosion,broken wire,check voltage at connector,if it there ,problem is unit,if its not,elct.circuit,

Feb 25, 2009 | 1991 Plymouth Acclaim

1 Answer

Seat belts remainder


I have found that it does this when someone has been riding then I get out of the car without me putting it in park after, so I put car in park and reopen then close door and it goes off

Nov 13, 2008 | 2006 Volvo S40

1 Answer

Rear seat


Yes by putting spacers under the front of the seats effectivly raising the front and lowering the back

Oct 18, 2008 | 2007 Chevrolet Silverado 1500HD

Not finding what you are looking for?
1998 Chevrolet Monte Carlo Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...