Question about Hyundai Motor 1998 Accent
cylinder head bolt torque
52-55 ft lbs. cold engine
59-63 ft lbs. hot engine
connecting rod cap nut 26-28 ft lbs. SOHC
connecting rod cap nut 23-26 ft lbs. DOHC
main caps 41-44 ft lbs.
Posted on May 25, 2011
yes you will have to take engine and transmission out together.you will have to also take the front wheel's off, separate the lower ball joint's so you can swing the assembly to one side so the axles will come out, pry the axles from the transmission with a pry bar or large screw driver,And the best part is disconnecting all the wires from the sensors .
have a nice day :-)
Posted on Mar 21, 2009
You have to take out the ash tray, and remove those two screws, then pop out the center dash trim. Careful, though, you have to take out a lot of the wiring inside of your center dash trim in order to pull it out for enough room to move the radio in and out. I'm doing this right now, actually..
Posted on May 22, 2009
Below is the diagram you needed. This is an updated one per ALLDATA as some changes were made so the one below it with the X over it is the wrong way that many manuals are saying. It's done in two passes for final torque I hope this helps and good luck.
Posted on Oct 29, 2011
Tips for a great answer:
Jan 05, 2016 | Hyundai Cars & Trucks
Dec 29, 2015 | Hyundai Cars & Trucks
Dec 19, 2015 | Hyundai Cars & Trucks
Mar 02, 2014 | 1997 Hyundai Accent
May 22, 2012 | Hyundai Accent Cars & Trucks
May 12, 2011 | Hyundai Motor 1998 Accent
Feb 14, 2011 | Hyundai Motor 1995 Accent
Dec 19, 2010 | Hyundai Motor 1998 Accent
Oct 26, 2008 | 1995 Land Rover Discovery
138 people viewed this question
Usually answered in minutes!