Question about 2003 Toyota Camry

1 Answer

I need to replace the mirror glass on a 1994 camry driver side p

How do I replace the mirror glass on a 1994 camry driver side power mirror?.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 653 Answers

Start with a good thick pair of leather gloves, a putty knife, and a tall trash can. Place the trash can below the mirror, tilt the mirror inward so you get a hold of the outer edge, and carefully pry the remaining pieces of mirror from the backing plate. Do not apply any pressure directly to the backing plate, or you may damage the gears on the electric motor. You should be able to pick up a new mirror and adhesive at your local auto parts store. Use masking tape and a couple of wood blocks to hold the glass in place while the adhesive sets (blocks against the glass, then wrap the whole thing in tape).

Posted on Feb 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace side mirror glass 2005 silverado 2500


you can not replace just the glass. you need to replace the whole mirror. sorry

Mar 09, 2013 | 2005 Chevrolet Silverado

1 Answer

Need to replace driver side mirror. The mirror is


gm does make just a mirror glass than you can get at you local dealer.First ck all the clips on the mirror and make shure that they are not cracked

Feb 24, 2010 | 1994 Pontiac Grand Am

1 Answer

Driver side view mirror need to replace not power


chek your local auto parts store you can usually buy the replacement glass with adhesive tabs already on it fairly cheap

Oct 14, 2009 | 2005 Dodge Caravan

1 Answer

The driver's side view mirror glass is disconnected from the power motor mechanism. How do I pop the mirror out and reattached it to the control. The mirror is not broken, just will not adjust with the...


Feel free just pull the nirror out then see if the knob is disconnected or you first check on the fuse that is meant for the power mirror.

Good luck.

Please rate this

Apr 05, 2009 | 2002 Toyota Camry

1 Answer

How do you replaced a mirror on a 1990 Toyota Celica ST?


What part are you replacing? Just the glass, or the entire mirror head?

If just the glass it glues to a backing plate, if the entire head it will bolt to the car which will require you to remove the door panel on the inside to get to those bolts.

Feb 23, 2009 | 1994 Toyota Camry

2 Answers

Quartz clock, Cig. lighter and power side mirrors stopped working


Raincity here, I discovered I was checking the wrong fuse. Got it working, fuse blown. The fuse is under the dash behind the little pocked to the left of the steering wheel. Good luck.

Jan 21, 2009 | 2000 Toyota Camry

1 Answer

Need to replace driver side mirror for Camry 2002, Power mirror


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Dec 05, 2008 | 2002 Toyota Camry

1 Answer

Need to install power mirror - driver side 1994 toyota camry xle


take the screws out, pop off the panel, disconnect the wire connectors, make sure you dont lose the screws.

to put the panel back on: reconnect the wire connectors, put panel back on track, pop panel on (hit the corners), put the screws in and tighten them.

Nov 18, 2008 | 1994 Toyota Camry

1 Answer

How do I replace the drivers side-view mirror on my 1994 Toyota C


LITTLE BLACK COVER ON THE INSIDE JUST POPS OFF. THEN IITS 3 10MM BOLTS AND A WIRE CONNECTOR

Nov 17, 2008 | 1994 Toyota Camry

1 Answer

Replace the passenger powered side view mirror assemby 1994 camry


You do need to pull the door panel off, as the wire from the mirror is plugged into the door harness under the middle of the door panel. The tringular plastic panel just pulls off, start at the top. There is no difference Japan vs USA production. The mirror is held on by 3 10 mm bolts behind the triangular plastic panel.
Hope this helps. The graciousness of a FixYa rating for my solution would be greatly appreciated.

Nov 14, 2008 | 1994 Toyota Camry

Not finding what you are looking for?
2003 Toyota Camry Logo

508 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...