Question about 2004 Infiniti I35

Open Question

Infiniti i35 blower motor

Can i replace the blower motor myself

Posted by on

  • Brian May 11, 2010

    blower motor replacement is quite simple, are we certain this is what's needed? If the blower is having problems, the fan control amp is the most common cause of blower problems-although the blower itself certainly can go bad?

  • Jay Stewart
    Jay Stewart May 11, 2010

    If you are somewhat mechanically inclined you should be able to.  You will need to remove the panel beneath the glove box, and you might need to remove the glove box itself, I can't remember exactly how it sits up in there, but I know I have changed a couple. I used to work as a service advisor at an infiniti dealer. You should be able to without too much trouble.

×

5 Suggested Answers

  • 13 Answers

SOURCE: replacing all season blower motor

six screws hold the glove box two at bottom four at the inside when u open the box after the screws are out pull on the box to remove and three hold the blower motor.its not hard at all.

Posted on Jun 22, 2008

pingman37
  • 58 Answers

SOURCE: How to program 2002 i35 infiniti keyless remote?

The procedure goes like this. First get in the car and lock all the doors. Secondly insert and remove the key repeatedly until the turn signal indicators on the dash flash twice simultaneously, it should be like seven or eight times. Then turn the key on and press the lock button on the remote and the lights should flash again. After that turn the key off and manually unlock and open the drivers door, then shut it. Wait a few seconds then try the remote. 

Posted on May 05, 2009

  • 14036 Answers

SOURCE: I have 2002 infinity I35

WELL YOU HAVE TO USE A VOLT METER CONNECT ONE VOLT METER WIRES TO GOOD GROUND AND THE OTHER VOLT METER WIRES GOES TO EACH SWITCH SPEED.IF VOLT METER GET VOLTAGE A 1 OR 2 CONTROL SPEED RESISTOR BAD.IF RESISTOR BAD YOU WILL GET 1 OR 2 BLOWER MOTOR SPEEDS.IF BLOWER MOTOR WORKING.CHECK THE AC AND HEATER CONTROL SWITCH FUSE OR CHECK BLOWER MOTOR FUSE AND RELAY.IF ALL GOOD SO FAR CONTROL SWITCH ITSELF COULD BE FAULTY.

Posted on Nov 06, 2010

  • 1 Answer

SOURCE: how do i replace the camshaft position sensor on a

hi, i have infinity fx 35 2003 it light on the service engine camshaft position sensor bank 1 , i replaced the bank 1 after 3 hour it light on again service engine + VDC off and slip i put the scanner it told me camshaft position sensor bank 1 again what can i do ?

Posted on Feb 27, 2011

Mr BrokRench
  • 1623 Answers

SOURCE: 2002 infinity i35 i'm looking to buy one but on

Yes, this is a potential transmission rebuild due to low internal pressures, loose bands & worn clutches. I would not by this vehicle in this condition.

Posted on Sep 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Infiniti i35 2004 fuse box diagram


heater not working, blown heater control switch fuse or a blown blower motor fuse/relay?

Jan 04, 2012 | Cars & Trucks

1 Answer

I have a 2002 infiniti I35 with 150K on it when I park the car and take the key out the some motor in the engine keeps running. Why? I took out the engine cont #1 fuse (15amp) out from underneath the hood...


This may be the engine stabilizer mount motor. It can get stuck, and run all night. I had this happen recently. You can pull the fuse, but the car will not run as smoothly until you replace the stabilizer.

Nov 27, 2011 | 2004 Infiniti I35

1 Answer

Camshaft position sensors 2002 i35 infiniti. sorry this may be a duplicate, but my 'check engine' light is on and the error codes are p0011 and P0021 which are bank one and two cam positio sensors....


find the parts online
go look for an image
lets you know what to look for on your car

2002 i35 infiniti
bank one 02 sensor
two cam position sensors

fault codes mean replace the parts the codes say

clear fault codes and if any codes return means it wasnt the problem

44-gvbdhzrta0vksrs4gnzywznx-2-0.jpg

Mar 26, 2017 | 2004 Infiniti I35

1 Answer

I have 2002 infinity I35 and the blower motor stop working ,I took out the blower motor to make sure was good. YES the blower motor still working .the only think I really don't know how to check is Blower...


WELL YOU HAVE TO USE A VOLT METER CONNECT ONE VOLT METER WIRES TO GOOD GROUND AND THE OTHER VOLT METER WIRES GOES TO EACH SWITCH SPEED.IF VOLT METER GET VOLTAGE A 1 OR 2 CONTROL SPEED RESISTOR BAD.IF RESISTOR BAD YOU WILL GET 1 OR 2 BLOWER MOTOR SPEEDS.IF BLOWER MOTOR WORKING.CHECK THE AC AND HEATER CONTROL SWITCH FUSE OR CHECK BLOWER MOTOR FUSE AND RELAY.IF ALL GOOD SO FAR CONTROL SWITCH ITSELF COULD BE FAULTY.

Nov 05, 2010 | Infiniti I35 Cars & Trucks

2 Answers

How do i replace the camshaft position sensor on a 2004 infiniti i35


hi, i have infinity fx 35 2003 it light on the service engine camshaft position sensor bank 1 , i replaced the bank 1 after 3 hour it light on again service engine + VDC off and slip i put the scanner it told me camshaft position sensor bank 1 again what can i do ?

Jul 24, 2010 | 2004 Infiniti I35

1 Answer

Air conditioning


check blower motor resistor common problem on most vehicles..

Jul 11, 2010 | 2004 Infiniti I35

1 Answer

2004 infiniti i35 bose woofer goes in and out randomly can anyone help?


2004 INFINITI I35 subwoofer works some times and sometimes it just does not work at all.

Apr 14, 2010 | 2004 Infiniti I35

1 Answer

The heater fan is not operating and I thought it might be a blown fuse. I checked the fuse box under the dash and couldn't locate the fuse for the fan by the descriptions given. Do you know which fuse on...


My 2002 I35 has the blower fuse under the hood in the fuse box in the engine compartment. The fuse box cover has the "key" or description of which fuse is which. If the blower fuse is bad and you replace it, only to have the fuse burn again then I would check the blower resistors that are located behind the glove box. Very common for one of these resistors to go bad causing only low speed operation of fan. Burns the fuse when you try to operate the fan on the higher speeds. Good Luck

Nov 17, 2009 | 2004 Infiniti I35

1 Answer

My ac/heat will not work. i hear it come on but


test the circut athe fan motor itself

Nov 02, 2009 | 2004 Infiniti I35

2 Answers

Replacing all season blower motor


six screws hold the glove box two at bottom four at the inside when u open the box after the screws are out pull on the box to remove and three hold the blower motor.its not hard at all.

Jun 14, 2008 | 2004 Infiniti I35

Not finding what you are looking for?
2004 Infiniti I35 Logo

Related Topics:

1,472 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

13573 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...