Question about 1992 Buick LeSabre

2 Answers

92 buick lasabre periodicly stops running while driving

Some say the speed modual or the cranking modual I dont know where to locate these on the vehicle

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 31 Answers

Try the fuel pump

Posted on Jun 25, 2010

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

This can be caused by the fuel pump going out to. once you lose fuel into the intake it will automatically shut the car down instantly.

Posted on Feb 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of crank sensor on 1997 lesabre


The crank sensor should be on the passenger side of the engine. It probably won't be visible without first removing the power steering reservoir, and possibly other items on that side of the engine. It is located down below near the waterpump pulley.

Jul 15, 2014 | 1997 Buick LeSabre

1 Answer

Where is the fuel tank pressure sensor located on a 1998 buick lasabre


It's built into the "fuel pump modual" You have to drop the fuel tank =(

Jan 22, 2011 | Buick LeSabre Cars & Trucks

1 Answer

Where is the ignition control module located on a 92 buick lasabre 3800


it is behind the harmonic balancer on the passenger side just replaced mine

Nov 14, 2010 | 1992 Buick LeSabre

1 Answer

My 97 lasabre periodically stops running at any speed or even stopped. It will not start back up until a few minutes later. It will turn over but not fire off. sometimes it take 10 minutes and sometimes it...


when the problem is happening, you need to check to see if you've lost spark or fuel. when you try to restart the car,can you smell gas? if you can,you need to pull off a spark plug wire and put a screwdriver into the end of the wire. set it down 1/4" or so from a metal ground. have someone crank the engine, see if there is a nice strong spark. if so, you're fuel pump is probably faulty. it's inside the gas tank

Feb 28, 2010 | 1997 Buick LeSabre

1 Answer

Where is the dam vats moduale located on a 02 buick lasabre


You can check behind the glove box in your model. Everybody I know with LeSabre and Park Ave 95-2000 found it there. There are good chances it's still there in 02. You can also have a look at this site if you are working on the security system: http://vatspasskey.com . This is where I found the solution for my car.

Feb 03, 2010 | 2000 Buick LeSabre

2 Answers

1992 Buick LeSabre Custom....180K on the odometer...stalls at low speeds....sometimes at highway speeds without warning...error code 17 is popular...I have a 41 also but the magnet has been missing 2 years...


dont know what the code are w/out looking them up however i do know that is a common problem when ignition coils or 1 ign coil goes bad. or distributor shaft wears out, which i dont think 92 buicks have. your 92 buick should be ign. coils . ignition coils need tested at a auto part store.most are free test call them to make sure.

Jun 25, 2009 | 1993 Buick LeSabre

1 Answer

95 lasabre. will stall while driving on highway or will not start until after several trys. car turns over. new battery. modual has been tested. at times have not been able to get it to start in 24 hrs.


Your problem is most often associated with a fuel pump problem or plugged filter. There are other items that can also do this such as a bad ignition switch or crank sensor (to name a few). Check pump operation and pressure and have a code scan done (unless checking module was a scan)

Jun 06, 2009 | 1995 Buick LeSabre

1 Answer

Car won't start? 1992 Buick LaSabre


three core plug hahahah it has 3 coils crank sensor is located at the crank pulley it sits inside and creates a magnetic field and produces a low ac voltage 5 ac volts or less module then converts it to a squar wave to fire injectors and coils

Apr 24, 2009 | Buick LeSabre Cars & Trucks

Not finding what you are looking for?
1992 Buick LeSabre Logo

Related Topics:

233 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...