How to hook up Centrodyne S 620 Taximeter

The best solution you'll get from books at www.reliable-store.com

These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc

Wrong category.

If you do a google image search on "RCA wire color code" you will find multiple wiring conversion charts. Good luck and just trying to help.

I think this is what your looking for:
http://www.97supraturbo.com/Radio%20Conversion/Harness%20descriptions.JPG

Are the wires on the new fuel pump connector color coded? Can you match up the wire colors? If not color coded, can you go abcd on the wiring connector? Compare one connector to the other.

centrodyne 610?? What is it?

Call Lee at Centrodyne he will help you.
The pulse is most easily found on the transmission at the VSS output. It is a connector with two wires, you want the DG/V. Run that to the pulse divider green wire. From the meter, tie the white in the 2 stand cable to the pulse output. Hook up power and ground then calibrate the meter. You should end up in the 33,000 range for calibration.

It's very easy on the pcm you will find a blue/orange wire. That's you hook up wire(vss). There are two set of wires off the meter bracket one comes with three wires and the other one with two. The one with 3 one goes to battery(red) ground(black) and top light(green or white). The other set of wires only the white one is connected to the vss.(vehicle speed sensor)

how to install a centrodyne silent 610

you are not putting a factor radio it not have that same colors . look at the wire diagram to tell which color to hook to car side

Check your neutral switch, its usually on drivers side on the back of stearing column .Its easy to reach and if you consult a mechanics service book, it will be alot easier to find and save you alot of frustration. Please rate this. Thanx.