Question about 2001 Pontiac Aztek

1 Answer

Lights on Air Conditioner controls and Gear selector area are blown. Need to know replcement Bulb numbers and how to install.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

How to replace bulb on radio gear control and heating and a.c. around knobs

Posted on Feb 24, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My 2010 Hyundai genesis gear selector has no lights, Where is the fuse?

usually in the fuse box under the dash check owners manual

Mar 28, 2015 | 2010 Hyundai Genesis

1 Answer

2005 honda odyssey dash lights not working

fuse blown.
check fuses , open operators guide, flip to fuse section, bingo.

Feb 03, 2014 | Honda Odyssey Cars & Trucks

1 Answer

Auto gear selector light

bulb in console- all dash/indicator lights on same circuit

Dec 22, 2013 | Daewoo Cars & Trucks

1 Answer

What to do when air conditioning vents on 2005 chevrolet silverado1500/v6 ?

It is all electronic these days an electric motor is controled by the selector on the dash. Remove the dash surround: gear selector in 1st engine off, tile steering wheel down, push down FIRMLY on the top of surround and pull towards you and off it comes. Remove the two screws that hold the heater/air cond. control in, there are 4 plastic clips as backup release them and gently remove the control, inspect for loose connectors (there are 2) it helps to run the blower to see if you have found the problem- I did.

Jul 27, 2012 | 2005 Chevrolet Silverado

2 Answers

Back up lights not working, changed 1 bulb, still no go?

Have you checked and see if you had a blown fuse and if you do not have a blown fuse,on your gear shift there is a switch that tell you that you are in reverse and kick the back up lights on it could have went bad.

Jan 21, 2011 | 1998 Chevrolet Tracker

1 Answer

How do i change bulb in air conditioner panel ny my 2001 jetta

Behind the center knob for the heater controls there is a single small bulb that lights the whole heater control.
Move the switch to the vertical position, move the gear shift out of the way(shift to D or 1 with engine off, and set the parking brake). Use a pair of pliers with a rag to protect the knob and pull the center knob out. The bulb is directly behind it. The best way to remove and replace the bulb is with a piece of rubber vacuum hose. Gently push the hose over the bulb, then pull, the bulb should come out stuck in the hose.
You can install the same way, push the bulb in, then gently pull and twist the hose to release.
Be careful to align the bulb to its socket. If the knob is vertical the taper of the bulb base should also be vertical.
Then just push the knob back on, remembering that it is aligned to a vertical position

Jan 09, 2011 | 2005 Volkswagen Jetta

1 Answer

I am trying to figure out which fuse operates the back lights for the Air Conditioner control knobs on a 2005 Dodge Ram 1500. (4.7 engine)

If the dash lights are working and the other controls light up then your problem is the bulbs need replacing, remove the controls and in the rear you will see where the bulbs go,remove the small socket and install new bulb. hope this helps.

Oct 27, 2010 | Dodge Ram 1500 Cars & Trucks

1 Answer

Air Conditioner light display doesnt work but controls do

the disply is ullimated by one bulb w/deflector spreading the light check bulb 1st

Apr 28, 2010 | 2002 Toyota Camry

1 Answer

Automatic shifter light burned out

I've done this many times. First grab the shifter and pull up with everything you have. It will come off if you pull hard enough. You may have to use 2 hands and a couple of legs to get it off the first time. After is is off, simply use a screw driver and pry out the trim piece with the letters on it, you know the D,R,N, 1, 2.... The light is under it, so simply untwist the bulb holder to undo it. Ensure you align the notch for the correct gear. You'll be able to tell if you are in Park and your gear selector says Neutral. After you put the trim on, just put the selector knob back on with a sharp blow with your fist.

Oct 27, 2008 | 1994 Jeep Cherokee Country

Not finding what you are looking for?
2001 Pontiac Aztek Logo

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides