Question about Chevrolet C1500

Open Question

How to change 1992 toyota corolla heater core step by step please

Posted by on

  • 1 more comment 
  • sspaul Feb 20, 2009

    no 4 door sedan 1.6 engin

  • yadayada
    yadayada May 11, 2010

    remove the dash the heater is under it.

  • yadayada
    yadayada May 11, 2010

    is this a chevy truck?

×

6 Suggested Answers

  • 2920 Answers

SOURCE: any special tools needed to

you should be able to loosen the alternator and get the belt off and then put the new one on and tighten the alternator back up. check the fuses for the cigarette lighter

Posted on Aug 10, 2008

motor1258
  • 6674 Answers

SOURCE: 1995 Toyota corolla timing belt change

Here's a link, just be sure it's that engine, otherwise click on repair guides & pick other engine.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528006f043

Posted on Dec 30, 2008

ewashmidas
  • 362 Answers

SOURCE: How to change a heater core in a 1999 Chevy Malibu?

Before starting this job I would get a repair manual. This is not a easy job, 6+ hours for an experienced tech with all of the right tools. And you may have to discharge and recharge the AC system.

Posted on Jan 30, 2009

dpblue2
  • 12 Answers

SOURCE: Replace a door handle on a 98 toyota

Here is step by step pictures:
http://www.bodyshopzone.com/archives/trim/door_panels/Toyota/Camry_2000_front/removal_f4.html

Posted on May 25, 2009

freetek
  • 5568 Answers

SOURCE: 1992 toyota corolla starter replacement

If you like doing your own repairs, I'd like to recommend having a Haynes service manual on hand; it will give you all the info you need to do home-based repairs:
'92 Toyota Corolla manual
We have a manual for each of our vehicles and even when a job is destined for a workshop, you can get a rough idea of how much labor it entails and therefore how much it should cost.

Posted on Oct 24, 2009

  • 299 Answers

SOURCE: 1992 Toyota Corolla CV Joint

You can pick up an entire re manufactured axle assembly at your local auto parts store. In order to replace the assembly you will need to disconnect the tie rod end and the ball joint. Remove the spindle nut. Push the axle stub out of the hub. Now with a suitable container under the axle to catch spilled fluid pry the axle from the transmission housing. Install is the reverse of removal. For more detailed instructions and diagrams go to www.autozone.com vehicle repair guides.

Posted on Oct 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Block heater installation on 2012 toyota corolla


if the cores are blocked the the only fix is to replace it with a new one . C heck first that the heater controls and the hoses are working and clean.

Apr 03, 2014 | 2012 Toyota Corolla L Sedan 1.8L 4-cyl....

2 Answers

Toyota corolla engine vibration after changing the clutch plate


sounds like either clutch plate didnt get lined up or maybe throughout or pilot bearing bad. take it back.

Jul 26, 2010 | 1992 Toyota Corolla

1 Answer

I have a toyota corolla vvti spirit 2002. its heating system does not work properly. it takes long to operate and heat produced is not enough to worm the car


the most affordable thing to do is either flush radiator and change thermostat.and see what happens the other thing is your heater core is clogged or is no good

Jan 30, 2010 | 2002 Toyota Corolla

1 Answer

No heat/defrost 01 corolla


Sounds like you have air trapped in the heater core when you flushed the heater core. loosen the upper most heater core hose and run the engine untill coolant seeps out. Wait until the coolant has reached running temperature.

Jan 17, 2010 | 2001 Toyota Corolla

1 Answer

No heat coming out of the vents


is it flowing into the heater core check line at heater core when engine is warm hoses should be warm as well if they are not its possible thermostat is stuck.

Jan 10, 2010 | 2001 Toyota Corolla

1 Answer

ICANT GET HEAT IN MY 1992 TOYOTA PASEO. I HAVE CHANGED THE WATER PUMP, HEATER CORE, THEROSTAT, RADIATOR, AND THE HEAT STILL BLOWS OUT JUST A LITTLE WARM.


Maybe the heater core is blocked.....try using the water hose to force water thru it. You will need to take BOTH lines loose from the heater core..water should come out fast....Be careful and go slow,don't break the necks of the core !!!

Dec 21, 2009 | 1992 Toyota Paseo

1 Answer

CHANGING HEATER CORE AND BLOWER MOTOR


Click here to watch a step-by-step video. Hope this helps, good luck!

Apr 18, 2009 | Chevrolet 1500 Cars & Trucks

1 Answer

Where is the heater core on a 1996 toyota corolla located? Is it accessible to a novice mechanic?


the heater core is located under the dash but you have to take the whole dash out of the car and yes you can do it but your looking about 4-5hours to fix maybe more

Feb 24, 2009 | 1996 Toyota Corolla

2 Answers

Heater only blows out cold air


Check the valve that controls coolant flow to the cabin

Feb 11, 2009 | 2005 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

692 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...