Question about 1997 Plymouth Voyager

1 Answer

1997 PLYMOUTH VOYAGER DRIVER WINDOW DOSNT WORK

HELP

Posted by on

  • Mike Butler
    Mike Butler May 11, 2010

    What exactly is happening, anything at all?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 123 Answers

I had this problem with mine, I have the later model after yours but if you remove the interior cover, and carefully pull back the plastic, you`ll see the motor, if you loosen the three screws just enough so the you can remove the two screws that hold the motor to the winder mech (watch out for the two square nuts that can fall out once you remove the two screws), You`ll probably find that the carbon brushes inside have stuck in a position where they don`t touch the commutator. Clean them up and operate them a couple of times and you`ll probably find that it works, however, Mine is still sluggish meaning that the brushes will be getting hot due to the current and they may fail again. I`ve found out that the window lift cables have to be replaced because even with the motor removed, the glass is extremely hard to move up and down. I`ve lubricated it and everything I can think of but the motor still finds it hard to move. I hope yours runs OK. Ian

Posted on Aug 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What the gap suppose to be on a spark plug for 1997 plymouth voyager


According with the Voyager Repair Manual, check this information for each engine:

Model: VOYAGER
Year: 1997
Engine: V6 - 3.3L - FI - - GAS
Parts Number: RN14MC5
GAP : .050"


Model: VOYAGER
Year: 1997
Engine: V6 - 3.0L - FI - - GAS
Part Numbere: RN11YC4
GAP : .044" (Original Equipment Manufacturer and/or Original Equipment Equivalent)


Model: VOYAGER
Year: 1997
Engine: L4 - 2.4L - FI - - GAS
Part Number: RC12YC5
GAP : .050" w/DOHC (Original Equipment Manufacturer and/or Original Equipment Equivalent)


Hope this helps (remember to rating this free answer).

Oct 07, 2011 | 1997 Plymouth Voyager

1 Answer

What will cause my guages to stop working on my 1997 plymouth voyager


theres a fuse box on inside the van on the drivers side and check the 10A fuse where it says radio there connected... change it see how it goes

Sep 06, 2011 | 1997 Plymouth Voyager

1 Answer

I am trying to loceate the o2 sensor bank 1 sensor 1 on a 1997 plymouth voyager se


That would be the sensor on drivers side closest to front of vehicle or in front of catalytic converter.Hope this helps!!

Apr 20, 2011 | 1997 Plymouth Grand Voyager

1 Answer

Why doesn't my rear window washer work . the resevior is full of vfluid the windshield washer works fine it is a 1997 plymouth voyager . the wiper works ok but not the wash


Sometimes they plug up or somewhere along the line it gets pinched. Take the line off of the nozzle in the back and try it out to see if you have good fluid flow with the hose removed. If you have good fluid flow your nozzle is likely plugged up.

Dec 08, 2010 | 1997 Plymouth Voyager

1 Answer

Power window not working


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. Then pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything.

Aug 14, 2009 | 1997 Plymouth Grand Voyager

2 Answers

1997 PLYMOUTH VOYAGER DRIVER WINDOW DOSNT WORK


i agree with joseph. the window regulator is bad. it runs off of a cable system

May 26, 2009 | 1997 Plymouth Voyager

1 Answer

Will a distributor from a 1994 plymouth voyager with 3.0 engine fit a 1997 plymouth voyager 3.0?


I don't think so, 1996 was the change in computer systems for all cars and trucks

May 17, 2009 | 1997 Plymouth Voyager

1 Answer

I have a 1997 Front wheel drive 3.3l Plymouth voyager. I need to replace the studs on the driver side front wheel. Is there anyone that can help with this.


Call auto parts store or go there, most have a print out you can get for step-by-step instructions when you buy the parts.

Apr 13, 2009 | 1997 Plymouth Voyager

Not finding what you are looking for?
1997 Plymouth Voyager Logo

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...