Question about 1988 Honda Prelude

1 Answer

4ws light on dash flashes

4ws light on dash Starts to flash after driving a short time some trips it will not flash

Posted by on

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 28 Answers

Is this car from japan with 4 wheel steering

Posted on Feb 19, 2009

  • Breckon b Mar 04, 2009

    it prob isnt working there is a rear wheel steering rack in the back and they are ran electricly i think prob bernt out the motor

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Speedometer fluctuates and drive light starts flashing then engine light comes on


I had the same problem, if your car is rather new model, what I mean is if it is mostly electronics than this is a problem...
Lights that go on and off is indication of a short somewhere, if this is caused by a ground wire being loose than the problem can escalate to more serous problem... like burning of components, what happend in my case is there was a loose ground wire, this burned out my ignition, the ignition made all the electronics shut down, including head lights at 9pm in the evening...

hope it helps

Feb 16, 2012 | Honda CR-V Cars & Trucks

2 Answers

1991 toyota celica convertable 4 wheel stearing, the 4 wheel stear light is on on the dash and the stearing is heavy and has very poor turning circle? please help. Bill


Your first option should be to check all the connections. Corrosion and moisture can set in if the cars left unused for any length of time. Check your fuses around the brake system; this could be a problem for grease losing, damage the axle in short time. Other posibility is one electricla switch or sensor bad.

The 4WS system is a fairly complex setup hence Toyota will probably charge an arm and a leg for fixing any fault on it (also it is a *** option).

There are five main components, main motor, backup motor, speed sensor, steering sensor and 4WS computer so it could be any of these, also add a possible wiring fault on top of that.

You can carry out a diagnostic test to interrogate the 4ws management fault code by bridging TC and E1 connections at the diagnostic plug (situated next to the top of the passenger front suspension strut in the engine bay). With these two connections shorted you should get a series of flashes from the 4WS light on the dash when you switch on the ignition. Each series of flashes represents a digit which can be looked up.

Tell us news.

Jun 29, 2010 | 1989 Toyota Celica Liftback

1 Answer

1998 honda civic cuts out at lights but starts back up right away - whats going on?


is there check engine sign on ? if so go to the right hand side of the dash and pull a lil blue plug from a dummy green socket only has two wires use a lil wire to complete circuit the check engine sigh will begin to flash a code one short flash is 1 and one long flash is 10 example long long long short short short is 33 if there is more than one code a new series of numbers will begin and start all over automatically most likely its you idle air control valve dealer only part dont buy used 99%of time there burned out good luck

Jun 24, 2009 | 1998 Honda Civic

1 Answer

How to reset service timer on dash


hold in your trip reset, continue to hold, put in key and turn to position 2, wait about 10 seconds, your triangle light in the center of your instrument panel will flash 3 times, after the 3rd flash, release the trip reset. then cycle your key off and back on. your service light should be off. good luck and god bless!

May 07, 2009 | 2002 Volvo S60

1 Answer

Orange check light on my dash flashes while driving.


That orange light means that you must have your braking system check...most probably it's the pads wear indicators that are earthing warning you that the pads are worn.

Apr 20, 2009 | 1988 BMW 3 Series

1 Answer

Service required light flashes 5 times even when the other lights


It looks like your Oil Changhe Reminder needs reset... I get many calls a week for this procedure...
This is really easy! Follow these directions:

Turn the key ON

Look at the odometer, and verify that it displays "ODO" and the total mileage traveled. If it is on "Trip A" or "Trip B", press the black stick next to the odometer to read "ODO", and the total miles traveled.

Turn the key OFF.

Press in, and HOLD the black trip meter reset button, hold it in.
DO not release it.

Turn the key ON

Observe the Odometer display. The total mileage traveled will disappear, and you will see 5 dashes, then 4, then 3, then 2, then 1 dash, and finally, 5 zeros. Then, the total mileage traveled will redisplay.

Release the black trip meter reset stick.

This completes the reset procedure, and it will be back on in 5,000 miles, to remind you of you next oil change.

Hope this helps!
This is an addition to the reset procedure, I apologize for not mentioning it:

You do NOT START the vehicle at any time during the reset procedure.
If the engine starts, the procedure will not reset.

Apr 09, 2009 | 2006 Toyota Tacoma

1 Answer

Maintenance Required light came on & stayed on after oil change


I get many calls a week for this procedure...
This is really easy! Follow these directions:

Turn the key ON

Look at the odometer, and verify that it displays "ODO" and the total mileage traveled. If it is on "Trip A" or "Trip B", press the black stick next to the odometer to read "ODO", and the total miles traveled.

Turn the key OFF.

Press in, and HOLD the black trip meter reset button, hold it in.
DO not release it.

Turn the key ON

Observe the Odometer display. The total mileage traveled will disappear, and you will see 5 dashes, then 4, then 3, then 2, then 1 dash, and finally, 5 zeros. Then, the total mileage traveled will redisplay.

Release the black trip meter reset stick.

This completes the reset procedure, and it will be back on in 5,000 miles, to remind you of you next oil change.
If you do NOT see the dashes, followed by the 5 zeros, start the entire procedure again, but start with the odometer set to TRIP "A". Some vehicles use Trip A instead of the ODO.

You do NOT START the vehicle at any time during the reset procedure.
If the engine starts, the procedure will not reset.

Apr 03, 2009 | 2007 Toyota FJ Cruiser

1 Answer

Does anyone know how to reset time for service light on dash for 2004 volvo XC70 dearler won't tell me or my garage where i get service from how to reset


hold down the trip computer button, turn igntion key to position 2. wait until orange triangle in the instrument cluster starts flashing, then let go of the trip computer button

Jan 04, 2009 | 2004 Volvo XC90

3 Answers

Flashing maintenance required light


NEEDS AN OIL CHANGE. YOU CAN RESET IT YOUR SELF. HOLD IN THE "TRIP" BUTTON AND TURN THE KEY ON (DO NOT START IT) 5 DASHES APPEAR AND DISAPPEAR 1 AT A TIME THEN 5 "0"'S AND YOUR DONE. SOMETIMES THEY HAVE TO BE ON "TRIP A" BEFORE YOU START

Nov 17, 2008 | 2006 Toyota Tacoma

Not finding what you are looking for?
1988 Honda Prelude Logo

Related Topics:

247 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...