Question about 2003 Hyundai Santa Fe

1 Answer

Problem with sante fe

I have an 2003 santa fe when driving it jerks than the check engine light comes on, when i stop it acts like it dont want too go than i pull over an cut it off and start it right back it goes with no problem. Took it too have an diagnostic done they gave me these codes p 1529 p 0715 o 0734 0733 0732a

Posted by on

  • kim5125 Feb 20, 2009

    I had the same problem with my '03 Santa Fe. My check engine light came on and I needed a new timing belt and an oxygen sensor. I haven't had any problems yet, but will keep a watch on it. Hope this gives you some ideas on what to check out. I have also had my cam shaft position sensor changed.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 67 Answers

Sounds like you need a transmission, with those incorrect gear ratio codes

Posted on Feb 22, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 hyundai santa fe constantly jerks while idling.


it has to do with the injection system. Might be something stupid like a manifold intake gasket leak (commonly known as cylinder 4 misfire problem) or it could be a part of the system like : spark plugs, wiring, fuel injector, throttle position sensor. A low cost solution worth trying is a kleen flow injection system cleaner. It will remove a lot of carbon and see if it helps...

Mar 20, 2013 | 2003 Hyundai Santa Fe

1 Answer

Check engine light


have the system checked with a scanner to get a trouble code that will give you a idea where the problem is

Feb 14, 2010 | 2004 Hyundai Santa Fe

1 Answer

Engine light came on in 2003 sante fe, no obvious problems noticed . I checked gas cap and that is not the problem.


Just take it up to autozone and have them run a free scan on it to tell you what code is causing the light to come on.

Jan 03, 2010 | 2003 Hyundai Santa Fe

1 Answer

2003 sante fe runs rough


Hope you changed plugs as well
When you had problem with coil,plugs will get damaged,and will malfuntion

Jan 02, 2010 | 2003 Hyundai Santa Fe

1 Answer

Santa Fe makes jerking motions


the air conditioning changes your idle speed when the compressor cycles on and in some vehicles will cause the problem you have.
it is the design and there is nothing you can do about it

Aug 19, 2009 | 2003 Hyundai Santa Fe

1 Answer

2003 santa fe A/C compressor replaced, engine surging & dying


I am not sure where the compressor is on the santa fe but it sounds like something was not hooked back up properly or something like a vacuum line was damaged during job. If a shop did it I would ask the to please just look at it and see if anything is out of place. If you did it I would retrace steps. Is the check engine light on ? How is it running different ?

Jun 04, 2009 | 2003 Hyundai Santa Fe

1 Answer

Just purchased 2002 Hyundai Santa Fe. While driving, steering became difficult, brake light, and engine light came on as if the car died, but once we brought the car to a stop we realized that the car was...


I had a similar prob with my 2003 sante fe. It turned out that a plastic panel under the front end had fallen off and now water spalses onto the steering belt and makes it difficult to steer. I need a new spalsh panel (about $300 new/ a lot less from a junkyard and it looks easy yo install)

Jul 21, 2008 | 2003 Hyundai Santa Fe

Not finding what you are looking for?
2003 Hyundai Santa Fe Logo

Related Topics:

400 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...