Question about 1997 Chrysler Sebring

1 Answer

2000 chrysler sebring 2.5 lite v6 were is the crankshaft postion sensor located

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 107 Answers

Like most other chryslers , might be on the rear of engine , gets its signal from points on flywheel

Posted on Feb 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sebring 1997 I need picture to lookat the PCM sensor and the Crankshaft position sensor (CKP sensor)


On 1997 Chrysler Sebring 2.5L MFI 6cyl...
- the PCM is located in the left side of the engine compartment, beside the Power Distribution Center (PDC).

zjlimited_767.gif

Fig. 1: Location of the PCM on the Cirrus, Stratus, Sebring convertible and Breeze models

zjlimited_768.gif

Fig. 2: Location of the PCM on the Sebring coupe and Avenger models

- the Crankshaft Position Sensor is located: under hood, driver side, upper engine area, mounted on end of engine block

zjlimited_769.gif

Fig. 4: Location of the crankshaft position sensor on 2.5L engines

Hope helps; remember to rating this answer and leave some testimonial comments.

Oct 09, 2011 | 1997 Chrysler Sebring

2 Answers

Where is the crankshaft sensor located on a 2005 Chrysler Sebring


It is located under the starter that is for a 4 cylinder engine if you are a six cylinder or 2.7 it is located on the rear of the transmission housing above the differential housing

Aug 05, 2011 | 2005 Chrysler Sebring Conv

1 Answer

Where is the crankshaft sensor on a v6 2000 chrystler sebring


CRANKSHAFT POSITION SENSOR - 2.5L
REMOVAL
Remove speed control servo from driver's side strut tower.
Remove crankshaft position sensor retaining bolt Crankshaft Position Sensor
Pull crankshaft position sensor straight up out of the transaxle housing.
(Disconnect crankshaft position sensor electrical connector from the wiring harness connector.
INSTALLATION - ADJUSTABLE
All vehicles will be equipped with an adjustable crankshaft position sensor. This can be identified by an elongated mounting hole in the sensor.

NOTE: If the removed sensor is to be reinstalled, clean off the old spacer on the sensor face. A NEW SPACER must be attached to the sensor face before installation. If the sensor is being replaced, confirm that the paper spacer is attached to the face of the new sensor Crankshaft Position Sensor and Spacer

Install sensor in transaxle and push sensor down until contact is made with the drive plate. While holding the sensor in this position, install and tighten the retaining bolt to 12 N·m (105 in. lbs.) torque.
Connect crankshaft position sensor electrical connector to the wiring harness connector.
Attach connector to heater tube bracket.
Install speed control servo. Tighten nuts to 9 N·m (80 in. lbs.) torque.

May 22, 2010 | 1998 Chrysler Sebring

1 Answer

Where is the crankshaft position sensor located on a 2000 Sebring Conv.


removal steps (CPS) -remove air intake hose -Battery tray -Crankshaft position sensor

Apr 27, 2010 | 2000 Chrysler Sebring

1 Answer

Oil sending unit on 2004 chrysler sebring V6


Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove

Jan 03, 2010 | 2004 Chrysler Sebring

1 Answer

How can i replace the crankshaft position sensor on a 1999 sebring lxi


Fig. 2: Location of the crankshaft position sensor on 2.4L engines

fabab4c.jpg

Jun 25, 2009 | 1999 Chrysler Sebring

1 Answer

Where is the crankshaft position sensor located? On a 2004 Chrysler Sebring 2.2L


the crankshaft position senor on the 2.2L is located on the rear right side of the engine block

Jun 13, 2009 | 2004 Chrysler Sebring

Not finding what you are looking for?
1997 Chrysler Sebring Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...