Question about 2001 Dodge Ram 1500 Truck 2WD

1 Answer

All other lights work except turn signals

All my lights are working except turn signals and the fuse box has no fuses for turn signals

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 118 Answers

Thats because they use a combination flasher for the hazzards and turn,here is the location and a diagram have a good day DB
The combination flasher is located in the Junction Block (JB) behind the fuse access panel on the left outboard end of the instrument panel.
all other lights work except turn signals - 521409e.gif

Posted on Feb 19, 2009

5 Suggested Answers

  • 1 Answer

SOURCE: turn signals do not work

IT WAS THE FUSE....WE FOUND THE FUSE BOX.

THANKS

Posted on Dec 31, 2008

  • 82 Answers

SOURCE: turn signal lights are not working...

read your owners manual, go to the back of the book and then look for fuses, go to page and the book should tell you every thing you need to know

Posted on Feb 24, 2009

localwonder
  • 6784 Answers

SOURCE: turn signal does not work

HI. Click here to view a troubleshooting page, that will help isolate the issue. The likely culprit will be the Flasher.

The flasher unit can be found under the dash panel attached to a bracket on the right side steering column opening reinforcement. On some models, the flasher plugs into the fuse panel.

The flasher can be removed by pressing the plastic retaining clip and pulling straight rearward. Align the new flasher housing with bracket and push forward until it snaps into the bracket

Click Here to view the fuse box layout picture.

The mounting of the fuse panel is either on the left side of the passenger compartment, under the dash, on the side kick panel or on the firewall to the left of the steering column. Certain models will have the fuse panel exposed while other models will have it covered with a removable trim cover.

Posted on Oct 26, 2009

Testimonial: "GAVE ME GOOD OPTIONS TO CHECK. NEEDED FUSE PANEL LAYOUT. THANK!"

  • 1201 Answers

SOURCE: on my 79 pontiac bonneville all lights work except

10 to one the tail light fuse is blown, pull the fuse marked tail lights, you will be able to see if it is blown.

Posted on Dec 15, 2009

  • 2 Answers

SOURCE: checked fuses, dash lights don't

take out the plastic panel on the drivers side in the cargo area. tucked inside the body where the taillight wiring is you will find about 6 to 8 wiring plugs. disconect all of them (dont forget to mark them as you disconnect each one. put in a new fuse and turn on the ignition. start connecting them one by one, you will hear the fuse blow when you connect the one thats bad. it should be either the rear window defroster or the rear wiper. it may sound like a lot of work, but it's pretty simple. hope that works it did for me.

Posted on Apr 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Which fuse is for the Brake Lights on a 98 Mercury Mountaineer. It is NOT listed on the Diagram fir the Interior Fuse Box !!


They're part of the turn light fuse. Replace the turn signal switch. All exterior lights run threw it, except the high mount brake light.

Jul 21, 2015 | Mercury Cars & Trucks

2 Answers

How to repair left turn signal and brake light, changed bulb, No voltage in fuse box, fuse is ok


No voltage. Replace the turn signal switch. All the exterior lights run threw it. Except the rear high brake light.

Apr 08, 2015 | 2013 Jeep Wrangler

1 Answer

I have a problem with the low beams on my headlights. The high beams works just fine. All of the other lights(turn signal, emergency lights, etc.) work except for the low beams.


Check the fuses first. then replace the turn signal switch if all fuses are good. All the lights run threw it, except the high brake light on the rear.

Jan 01, 2015 | 2003 Ford Escape

1 Answer

Rear lights not working on 2002 suzuki grand vitara


In the underdash fuse/relay box, the 15A TAIL fuse feeds power to the coil of headlight relay 2. When the combination switch is set to TAIL, the relay closes and the outer tail lamps light. In the same underdash fuse/relay box, the 20A STOP fuse feeds power to the brake light switch. When the brake pedal is pressed, the inner brake lamps light. The underdash fuse/relay box also contains the 10A TURN BACK fuse which feeds power to the hazard switch and the turn signal relay. Relay output is fed to the combination switch and turn signal power is applied to the selected middle tail light. The fourth fuse in the underdash fuse/relay box is the 15A HAZARD fuse which feeds power to the hazard switch and turn signal relay. When the hazard switch is set, the turn lamps on both sides begin flashing.

Sep 18, 2012 | 2002 Suzuki Grand Vitara

1 Answer

Dash lights and reap lights


change fuse in fuse box for instrument panel the dash lights go out to tell you your tail lamps are not working

Jul 20, 2009 | 2001 Ford Escape

1 Answer

Dash lights-turn signal and rear lights


Access your fuse box and check the fuse labled- rear tail lgts,turn sgns, that fuse is blown, replace the fuse with the same value fuse, while your under there, on the fuse box or next to it you'll find 2 round plug in components, about the size of a Marshmellow, one of these is your flasher unit and the other is for your turn signals, replace both of these, even though one may work, it's just good sense to replace both, that shoud fix your rear lighting problem. good luck.....

Jul 11, 2009 | 1994 Ford Crown Victoria

1 Answer

Instrument panel not working at all - all signals work o.k. , brakes, turn, etc.


check the igntion off draw fuse if it is blown or not fully seated in the fuse block it can cause this

Oct 18, 2008 | 2001 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

438 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...