Question about 1997 Dodge Caravan

1 Answer

My fuse is good i think it is the horn relay - 1997 Dodge Caravan

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 137 Answers

Do you have no horn and the airbag light is on?


if so its the clock spring and its under warranty from dealer as a recall

Posted on Feb 19, 2009

6 Suggested Answers

alicantecoli
  • 21990 Answers

SOURCE: horn does not work 02 jeep liberty

get someone to hold hand on horn then tap it with a light hammer ,then when itts working give it a squirt of engine oil on the vibrating part so it runs behind it

Posted on Feb 28, 2009

USfalcon
  • 175 Answers

SOURCE: horn does not work

check B+ in the horn pin and check the ground on the horn if there is B+ and B- just change the horn if there is no B+ on the horn conector replace the relay .
B+ = battrey power
B- = battrey ground

Posted on Mar 14, 2009

  • 65 Answers

SOURCE: 1999 Chevy Lumina horn is not working. Horn is

Simply have it replaced, horns on domestics usally stop working as mine did on my 93 lumina, it stopped working and I had it replace and it worked fine after that.

Posted on Aug 21, 2009

Puppet03
  • 172 Answers

SOURCE: horn does not work. relay and fuse good, need wiring diagram

Had the same problem myself i just replaced the horn itself.

Posted on Oct 24, 2009

  • 243 Answers

SOURCE: My 1996 jetta horn does not work. Fuse / relay okay

hi did you also checked the horn itselfs. when you take out the horn and look at the back you will see a adjust srew with sealingmastic on it. you can remove the sealingstuff and try to adjust the horn. this only works if the coil is not broken. but first you have to check the connection inside the steeringwheel. make sure the switch in the steeringwheel is making contact to earth. if this all doesnt work you have to buy a new one goodluck.

Posted on Feb 16, 2010

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My horn does not work on my Kia Sedona 2005. Fuses are all good. Any help out here in cyber world???


lol, yeah, I'm here in cyber world.

Did you check for voltage at the horn fuse? Even if the fuse is good, if no voltage the circuit is still dead. From the fuse, the voltage goes to horn relay. the horn relay has two sides, a load side, line with arrow head, it shows open in the diagram, when relay is energized, that line with the arrow head moves to the other terminal and carries voltage to horn.

The control side of relay looks like a coiled up line, that needs voltage and ground to energize the relay. One of the grounds for the control side of relay is the horn switch on the steering wheel.

It may be possible to use jumper wire across load side of relay, between the proper two terminals and the horn may sound. If so, I think the problem is the wiring in the steering column.
25968533-3c2oxcn01wu0jbwcn5jwb5on-4-0.jpg

Nov 19, 2015 | Kia Cars & Trucks

2 Answers

Horn doesnt work all fuses and relays are good


If you know the fuse and relay have power, you should be able to jumper the relay and make the horn blow. The horn pad on the steering wheel usually grounds the relay. If you can jumper the relay and make the horn blow, the problem may be the horn pad or the clockspring in the steering column.

Sep 25, 2012 | 2003 Chevrolet Silverado 1500

1 Answer

For 2004 ford truck f150 extended cab, I found the horn fuse, where is the horn relay?


disconnect the horn or horns, operate the horn and see if the fuse still blows. if the fuse still blows then there is most likely a short in the wiring. relays rarely cause shorts. if the fuse doesnt blow with the horn disconnected, reconnect the horn and operate the horn again, if the fuse blows you have a shorted horn.

Jul 14, 2012 | 2004 Ford F150

1 Answer

I have a 1995 Chevy S 10 and the horn does not work. I think my problem is under the dash. Are there any switches,relays, or breakers I need to be looking\r\nfor? I have traced from horn to fuse panel and...


The horn relay is in the fuse/relay box under the hood. so the fuse is HOT on both sides? you should hear the horn relay click when pressing on the horn switch. there may be other relays in that fuse box to swap with and see if the horns work, if the relay clicks, its "usually" good, but the contacts may be bad. if the relay clicks, check for power at the horn. DARK GREEN wire, if it has power , then check the black wire, thats the ground. If it has power and ground, but does not work, the horn is bad.

Sep 14, 2011 | 1995 Chevrolet S-10 CA Edition

3 Answers

My horn no longer makes sound i checked the fuse it is fine


Your horn is hooked to a relay. The relay is activated by the ground wire that comes from the horn button. If the fuse is ok then you need to check the relay and the horn switch. You may have a dead relay or a bad contact from the switch.
Hope this helps... Dale

Apr 20, 2011 | Jeep TJ Cars & Trucks

1 Answer

Where is my horn relay located in my 92 olds cutlas cruiser ?


have you checked the fuse for the horn you don`t say what you have done to this point,if the fuse is good and you hear a click when you push on the horn button, then the horn relay is good as that is what is clicking,if not you will have to check the horn itself as some relays won`t work if the horn not itself is not working,by running a jumper wire from the battery positive to the terminal on the horn, it should work if not then the horn is the problem.the relay is on the fuse panel under the dash.I think it is a square sided relay

Mar 10, 2011 | 1992 Oldsmobile Cutlass Ciera

3 Answers

I have a toyota camry 2000 and since I bought it the only horn that would work was the high tone one. All of the sudden none of them are working now. I realized that a relay on the fuse box that is under...


The click you here is the horn relay, You need to find the horns and check for power at the wire connectors. But you probably have a bad low and now a bad high not horn. since the relay clicks your fuse is good so that eliminates the fuse.

Feb 17, 2011 | 2000 Toyota Camry

1 Answer

My vw 2002 cabrio's horn has stopped working. How much does it cost to repair and could it be just a fuse?


yes, it could be a fuse OR a relay. If the fuse is good look for the relay. The relay (probably in a box with other relays under the hood) should make a click when someone pushes the horn button. If the relay clicks, the problem is probably the horn. To verify the horn is bad, hotwire it to the battery and see if it blows. You can look up the cost of a new horn online. I don't think they are expensive. Let un sknow if you have more questions. If all of these parts are good the problem is in the horn button or wiring. Please get back to us if it comes down to that.

Sep 12, 2010 | 2002 Volkswagen Cabrio

1 Answer

My horn does not work. I press the horn, but all i hear is a click in the fuse box. Checked the fuse and it is good. I bought it from a auction and had problems with the alarm and locking because i didnt...


If the horn fuse ( Fuse #26 ) is installed and has power on both sides of the fuse, you might want to check that the horn connector is still on the horns.

The horn relay is not serviceable in the fuse panel.

You can test the horn connector for power, the Yellow w/ Light Green wire, when the horn button is pressed.

Feb 02, 2010 | 2005 Ford F-150

3 Answers

Having problem with horn. No horn.Fuse and relay good.


get two seperate wires and connect it to terminals of the horn then connect it directly to the battery and see if it will work. if not, then your horn is busted.

Jul 17, 2009 | 2004 Ford F150

Not finding what you are looking for?
1997 Dodge Caravan Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

63990 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...