Question about 1996 Jeep Cherokee Country

1 Answer

1995 jeep grand cherokee 4x4 low problems

No 4x4 low - acts likes its in park- no movement and no 4x4 lights on dash

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

How long have you owned this vehicle, is this a new problem? If your new to the jeep 4x4, you might not realise that you must be rolling very slowly in neutral or at least in newtral without your foot on the brake in order to egage 4 low. Not trying to be patronizing, just dont know your experience. This could solve your problem because you may not actualy be in any gear.

Joel

Posted on Feb 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i get out of 4x4 on a 2000 jeep grand cherokee laredo


On these issue, there are few solved help links for troubleshooting the issue easily.-------

Click the link below: ---

No 4x4 light on dash?

http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html

-----------

4X4 Truck makes roaring noise in the front end?

http://schematicsdiagram.blogspot.com/2012/01/4x4-truck-makes-roaring-noise-in-front.html

-------------

Car will not go into 4WD high or 4WD low?


http://schematicsdiagram.blogspot.com/2011/12/car-will-not-go-into-4wd-high-or-4wd.html

--------------

No 4x4 light on dash?

http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html

------------

4 wheel drive system will not disengage?

http://technoanswers.blogspot.com/2012/01/4-wheel-drive-system-will-not-disengage.html

----------

4WD light is flashing and beeping? NO 4WD high?

http://schematicsdiagram.blogspot.in/2012/02/4wd-light-is-flashing-and-beeping-no.html

----------

2002 Jeep Wrangler: 4WD Idiot Light is ON?

http://technoanswers.blogspot.in/2012/06/2002-jeep-wrangler-4wd-idiot-light-is.html

----------

Traction control switch will not engage on 4WD High or Low

http://whoisbyme.blogspot.com/2012/10/traction-control-switch-will-not-engage.html

-----------

4WD light flashing and 4WD will engage after few minutes

http://repairhelpcenter.blogspot.com/2012/10/4wd-light-flashing-and-4wd-will-engage.html

------------

2008 Toyota Tundra: 4x4 Wheel Drive Light is Flashing?

http://technoanswers.blogspot.in/2012/05/2008-toyota-tundra-4x4-wheel-drive.html

----------

4x4 front differential will not engage the axle on ford?

http://technoanswers.blogspot.in/2012/02/4x4-front-differential-will-not-engage.html

-------

4x4 will not engage on Ford F150?

http://technoanswers.blogspot.in/2012/02/4x4-will-not-engage-on-ford-f150.html

-------------

Dodge Ram 4x4 light keeps flashing

4X4 LOW LIGHT IS FLASHING ON DASH

http://technoanswers.blogspot.in/2012/09/dodge-ram-4x4-light-keeps-flashing.html

----------

Ford 4x4 front wheels will not engage?

http://technoanswers.blogspot.in/2012/02/ford-4x4-front-wheels-will-not-engage.html

-------------

These details will help.

Thanks.

Dec 26, 2012 | 2000 Jeep Grand Cherokee

1 Answer

1995 Jeep Grand Cherokee 4.0 starts surging and stalling after warming up or if throttle is punched to the floor. Restarts and runs good for 10 min. and repeats the acting up.


Are there any service lights coming on from the dash. Sounds like a throttle position sensor but the service engine light should be on if the sensor is defective.

Jul 10, 2011 | 1995 Jeep Grand Cherokee

1 Answer

My 06 grand cherokee laredo has a 4x4 emblem on the vehicle, and a traction button on the dash, how do I operate the 4x4?


Your jeep should have full time four wheel drive. To place the transfer case in low range look down to the console towards the rear and you will see a "T" shaped handle. To place it into low range you should stop place the vehicle into park and lift the T handle and in the dash a 4X4 indicator lamp will light up. The traction button on the dash would be used in 4 wheel high mode when you start to experience wheel slippage upon take off from a stopped position. This will give you a little more control. You only need to use the low range for very slow speeds in mud or snow. Otherwise just leave it in high range because it is always using 4 wheel drive. This is a very reliable system which Jeep has refined over the years. Your Grand Cherokee is not designed fro hard core off road use. Hard core off road use will destroy the undercarriage. The Grand Cherokee is more of a luxury soccer mom 4X4 with good road manners, a comfortable ride, and good reliability.

May 27, 2011 | 2006 Jeep Grand Cherokee

1 Answer

I have Grand Cherokee 1995 6 cylinder,I am facing starting problem now, in morning and if my jeep is in parking 4 to 5 hours,and I need to start the ignation my jeep does't start its take time 20 to 30...


Your ECU is going bad and needs to either be replaced or repaired. That 'no check engine light for 20-30 minutes' is a common problem that tells it's an ECU problem.The ECU won't power the fuel pump and other relays until the check engine light illuminates on the dash.

Jan 15, 2011 | 1995 Jeep Grand Cherokee

1 Answer

Replaced Fuel pump module now 1995 Jeep Grand Cherokee 4x4 will turn over but will not start. Acts like security system is engaged but have gone thru the steps to disengage and still will not start. Can...


Does it have spark while cranking the engine? Will it start while cranking and spraying starting fluid/carb cleaner into intake? If it still does not start with the spray fluid, check your crank sensor.

Oct 22, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Jeep cherokee fuses have some missing


I'm confussed; you post your problem in the Jeep 1995 Grand Cherokee area, but say us that you have an Jeep Cherokee SE... :-S

For solve this subject, maybe you need review the fuse box in the correct Jeep model:
- Jeep Cherokee (Page 3-5 Fuse Block / Page 15-17 Power Distribution Center)
- Jeep Grand Cherokee (Page 7 Fuse Block / Page 9 Power Distribution Center)

I hope help you with this (remember rated this help) Good lick.
-

Sep 14, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Electical


likely a failed lighting module...That's where all that stuff is tied together. It's only my opinion, but all this stuff belongs in spaceships...just too unreliable to use in cars (especially when it replaces stuff that used to work 99% of the time!!!)

Mar 10, 2009 | 1995 Jeep Grand Cherokee

2 Answers

Where is Neutral safty sensor switch located on Grand Cherokee


OK then the switch is part of the gear selector switch on the side of the trans where the shift linkage hooks up. here is a picture and part number.
ACDELCO Part # C2241 $233.89

673ffc9.jpg

Feb 17, 2009 | 1996 Jeep Cherokee Country

1 Answer

Full time 4wd doesn't feel right on my 1995 grand cherokee laredo


normaly you wouldn't drive all the time in 4 wheel drive in less it is mad that way but the reason it jearks when turning sharp is because the front axle is tring to grip but the tire just bends and slips commen problem

Dec 05, 2008 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
1996 Jeep Cherokee Country Logo

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...