Question about 2001 Buick LeSabre

1 Answer

Cruse control on 01` buick lesabre only works when the button on wheel is held down

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 58 Answers

IM GUESSING YOUR TURN SIGNAL SWITCH IS BAD U HAVE TO TAKE OFF UR STERING WHEEL OF SO YOU COULD GET TO THE WHOLE PICE OR ELS UR CRUSE CONTROL ON THE PEDAL IS BAD

Posted on Feb 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 Buick lesabre and my cruise control stopped working


Without factory wiring diagrams to follow

A repair shop is the answer

Nov 30, 2012 | 2001 Buick LeSabre

1 Answer

BAD CRUISE CONTROL


? Does all other functions on the turn signal lever work? Is the switch pushed to the right? (cruse on) Does the button on the end of the turn signal lever pushed in? I don't mean to be telling you the obvious but I make mistakes like that. Have you done a scan (obdII) for any errors? The multifunction switch on the steering colum controls many functions of your buick. Did you check the fuse. See owners manual either glove box, or passangers side under the hood.(its labeled cruse) Are your brake lights working? (they deactivate the cruse control) If your 1999 Buick is in fair condition I wouldn't look for a wiring problem (corroded connectors) The cruise contol module is located under the hood on the drivers side inner fender wall check for damage ie connectors. It could be a sensor in the transmission?(speed control) Just start eliminating the obvious Edmonds, Haynes, Chillions have manuals that are available at most major libraries for diagrams an suggestions. Sorry but without more specific info. there can be a multitude of causes.

I just try to help

Jan 30, 2011 | 1999 Buick Century

1 Answer

Cruse control light comes on but it doesn't work?


check the actuator in the engine bay where the linkage joint with the throttle might loose...

Nov 20, 2010 | 2003 Buick LeSabre

1 Answer

How to install a new blower motor


its above the passengers feet , held in by 4 or5 5/16 inch
bolts .
It should drop down and out , remove the blower wheel
off the shaft , after removing the retainer clip.
reverse procedure for install.

Aug 24, 2010 | 2000 Buick LeSabre

2 Answers

2000 Buick LeSabre's cruise control button won't stay engaged


We had the same problem and ended up replacing the switch. We used a small flat-tip screwdriver and lifted along the edge of the switch. With the switch removed from the steering wheel, we disconnected the wire connector and installed the new switch by reversing the order.

Jun 17, 2010 | 2000 Buick LeSabre

1 Answer

Horn won't work on a 1994 buick lesabre and i don't have a fuse diagram


if the horn doesn't work it is most likely the rotating ribbon circuit contract under the steering wheel called the "clock spring contact", the circuit runs along a plastic ribbon and that breaks from all the turing of the steering wheel over the years, then the horn button is no longer connected to the horn circuit.

May 21, 2010 | 1994 Buick LeSabre

2 Answers

I need a new radio, not sure which one.


Go to a scrapyard and buy a radio that comes from the same car you have, with the same steering wheel controls. The only difference will then be that the new one works. make note of any security codes and get vin# from vehicle radio was removed from so that anti-theft feature will not prevent it from working. Radio and wiring harness will not change if you obtain radio from identical vehicle.

Aug 10, 2009 | 2000 Buick LeSabre

1 Answer

Cruse control


Does your blower fan work on your heater/ac or your rear defrost work it could be the igniton switch were you put the key in. Turn the car on and off several times once you notice the cruise will not work and see if it starts to work if it does than it is the ignition switch this just happen to my 2003 century.

Sep 14, 2008 | 2003 Buick LeSabre

Not finding what you are looking for?
2001 Buick LeSabre Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...