Question about 1990 Volkswagen Golf

1 Answer

Need to know wath is the idle speed rpm for a 1990 Golf sedan with a 1.8l engine Automatic transmission. Thanks, Gilles

Posted by on

  • yadayada
    yadayada May 11, 2010

    IT IS COMPUTER CONTROLLED. FINAL IDLE SHOUD BE AROUND 600 RPM

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 345 Answers

With autobox 750 to 850 otherwise the engine will cut out

Posted on Feb 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Airscrew


Before you could adjust the mixture, make sure that the spark plug gaps, ignition timing and valve clearance are all OK.
- Start the engine and bring it at operating temperature.
- Adjust the throttle stop screw to bring it at the stable rpm.
- Turn in the idle mixture screw while observing the engine speed till the engine starts to stall. At this point turn out the idle mixture screw and keep on opening slowly till the engine acquire the most stable rpm. Finally adjust the throttle stop screw to obtain the desired idle speed.

Jul 12, 2013 | 1990 Toyota Land Cruiser

1 Answer

Car stalls then restarts


You need to run a fault code test on the car and do the service below. To run the test follow the instructions HERE
Also do this service.

Engine stall or RPM fluctuates at idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Oct 02, 2012 | 1990 Plymouth Acclaim

1 Answer

How do u get the 1990 DODGE ramcharger to stay idleing


Engine stall or RPM fluctuates at idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Sep 20, 2012 | Dodge Ramcharger Cars & Trucks

1 Answer

My 1990 Toyota corolla just shuts down when my air condition is on


IDLE SPEED COULD BE TOO LOW.IDLE SPEED SHOULD BE 800 RPM. IF IDLE SPEED TOO LOW AND ENGINE NOT WELL TUNE UP AIR CONDITIONER WILL PUT LOAD ON ENGINE CAUSE ENGINE OVER HEAT AND SHUT OFF.

Sep 05, 2011 | 1990 Toyota Corolla

1 Answer

Idle needs resetting. emmissions told me my rpm is to high but i do not know how to do myself since engine is fuel injected. the year is a 1992 and engine is a v-8 305


if the idle is to high then you have a defective part in the automatic idle speed control system or a leaking intake manifold gasket or a vacuum hose leaking, idle speed is not adjustable.

Jun 01, 2010 | Chevrolet Caprice Classic Cars & Trucks

1 Answer

Engine running on and no the ignition timming is out i have a timming light and just wanted to no what degree it should be set to its a 1800 mk1 golf cabriolet


6 Degrees Before top dead center *Set at warm idle speed (925 RPM) *Distributor vacuum hose disconnected & plugged *Transmission in neutral (parking brake engaged)

Jan 29, 2010 | 1990 Volkswagen Golf

2 Answers

Have codea 12-19-30-41-52-91 f10-32 please help the car i have is a 1990 cad sedan de ville 4.5 engine


ECM Trouble Codes
12-Distributor signal fault
19-Fuel pump circuit fault (short)
30-Idle speed control (isc) motor rpm out of range
41-Camshaft position sensor (CMP) or circuit fault
52-Electric control module (ECM) reset
91-Park neutral position switch or coicuit fault

BCM Trouble Codes
10-Outside temperature sensor or circuit fault
32-Electronic control module (ECM) to Body control module (BCM) fault loss of communcation

Source: Haynes repair manual


Dec 11, 2009 | 1990 Cadillac Deville

2 Answers

I have a 1990 cadillac sedan deville with a E98 code


Sounds like the engine is idling to high. There is a procedure that you must go through to set it. Reply and I will let you know how to set it.

Nov 11, 2009 | 1989 Cadillac Sedan DeVille

1 Answer

1990 Ford Probe 2.2 automatic stalls in forward, reverse OK


Sounds like a bad IAC (idle air control valve/sensor) that controls your idle when going from throttle to idle. If bad your idle will act crazy and can cause stalls easily. Pretty sure that's it.

Dec 20, 2008 | 1993 Ford Probe

Not finding what you are looking for?
1990 Volkswagen Golf Logo

Related Topics:

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...