Question about 2006 Renault Le Car

3 Answers

RESET TYRE PRESSURE SENSOR ON LAGUNA COMPUTER

I have a 2001 laguna and the rear tyre valve is leaking, the local tyre center cannot replace the inner of the valve because it is damaged although the sensor works. I have purchased another valve from renault but do renault have to reconfigure the sensor with the computer or is it just a case of hitting the the milage trip button in a certain sequence like fords when the service light comes up?

Posted by on

  • 1 more comment 
  • darron jones Feb 18, 2009

    will take a look and get back to you?

  • darron jones Feb 19, 2009

    Hi i have had the valve changed and no warning lights have come up on the dash which is not what i expected, the car is a uk model and the fuse box is on the drivers side. I have looked and their does not seem to be a reset switch? at the moment i don't know if the sensor is working or not.

  • darron jones Feb 19, 2009

    Hello again, it took a little while but the computer does now show a fault on that wheel so it does need resetting?

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I had a new sensor fitted recently at a tyre centre, but after driving home one of the rear tyres disappeared off the display! I had them reset the whole system only to find it happened again soon afterwards. Just looked at the fuse panel (right hand side on UK cars, at end of dashboard), no 'reset' switch. However, I did pull out a few fuses to see if that worked. By pure luck, there is a fuse with a strange name (can't remember it now) that is like disconnecting the battery completely (it's a 10A fuse located 3rd down from the top). Plug it back in and hey presto, no more flat tyre warning light, and centre screen shows all 4 tyres correctly. Genius!!

Posted on Jun 19, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

(it's a 10A fuse ,but located 2rd from the top .)

Posted on Jan 27, 2010

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

You should have a reset button in your fuse pannel in the passenger compartment this also resets the change oil light

Posted on Feb 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Im looking for a tyre pressure sensor for my renault laguna 2033 plate but not sure what im looking for or how to fit one thank you


1. The tyre has to be removed to fit the tyre valve/ sensor unit to the wheel. . Tyre dealers will do this for you when you supply the sensor.

2. Any renault dealer parts department can sell you a new sensor.

3. The new sensor has to be programmed to the car's tyre pressure monitoring system (TPMS).

3. Here is a list of information about the Renault Laguna tyre pressure sensors to assist you. The 2nd link below shows a picture of the tyre valve/sensor unit that fits to your wheel.

http://www.petercoopercarrepairs.co.uk/renault_laguna_mkii.htm

Renault Laguna Megane Tyre Pressure Sensor World Car Parts Store

Jan 07, 2016 | Renault Cars & Trucks

2 Answers

Suggest causes for the 4L80E transmission not to reverse


No Reverse

Checks

Cause

Case (7)

The rear band anchor pin is broken or the pin is not positioned.

Center Support (640)

Leaking at the case, or the support is broken.

Center Support Seal (639)

Leaking

Center Support Bolt (25)
?€¢
The bolt is loose or broken.
?€¢
The feed hole is blocked.

Rear Band (657)

Broken, worn, or not anchored

Rear Band Apply Pin (73)

The pin is too short or the pin is binding in the case.

Piston (65)

Binding in the case

Seal (66)

Leaking, damaged, or worn

Gasket (63)

Damaged or displaced

Cover (62)

Damaged

Bolts (61)

Broken, loose, or missing

Checkball

Missing

Fluid Pressure

Too low

Direct Clutch Components

Reaction Plates (618)

The splines are worn.

Friction Plates (611)

The splines or the friction are worn.

Spring Assembly (607)

Jammed

Housing (623)

Cracked

Piston (619)

Leaking

Seal (620, 621, 622)

Leaking

Ball Check

Leaking

Dec 18, 2015 | 2001 Chevrolet Silverado

2 Answers

Tire monitor valve stem leaking ? What's the fix ?


replacement is only solution. you better take it to tyre shop and get it replaced

Oct 06, 2010 | 2008 Lexus Rx 350

1 Answer

Iv got a 2002 laguna thats had a frunt end crash


fuel pump cutoff circuit breakers[crash switches] are usually located behind the fabric lining in the trunk,or behind a trim panel,on or above the inner rear wheel well.

Oct 11, 2009 | 2001 Renault Sportwagon

1 Answer

Can the tyre sensers be swiched off on the laguna 2001 model


well no they cant be turned of but u can have normal sensor's put in but will syil show on dash as tyres are low best fing is just 2 ignore it or replace it p.s sure the sensor's dnt just need repragraming as i found this was normally the case

Oct 05, 2009 | 2001 Renault Sportwagon

1 Answer

Light on my dashboard-renault laguna 2002 dyaminic (130) 2003


hi sounds like tyre pressure light.does it look like a tyre.check pressure.these sensers can be prone to going faulty.they are on each wheel.sometimes inflate tyres to say 40 psi then deflate to correct preesure.resets valve and light goes out.

Feb 01, 2009 | 2003 Renault 181

1 Answer

Tyre pressures for renault laguna


32 psi in the front and 30 psi in the back. if the tyre preasure monitoring is acting up even with the preasures ok. take the car to a renault garage to have them re initialised

Jul 26, 2008 | 2001 Renault Sportwagon

1 Answer

Tyre wear


ok have you checked that the tyre pressure is the same on all four wheels or it could be that the rear axel is not being lubricated properly check the bushing.

Jun 26, 2008 | 2006 Hyundai Accent

1 Answer

Chrysler Crossfire tyre dilema


They are tubeless sorry buddy but you need a new tire. You can not fix cuts on the side wall of a tire for many reasons. Beside, if you can afford a Crossfire you can afford the tire, right? ;-)

May 15, 2008 | 2001 Chrysler Crossfire

Not finding what you are looking for?
Cars & Trucks Logo

9,723 people viewed this question

Ask a Question

Usually answered in minutes!

Top Renault Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22026 Answers

xxxxxx xxx

Level 3 Expert

4789 Answers

yadayada
yadayada

Level 3 Expert

69199 Answers

Are you a Renault Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...