Question about 1993 Mercury Villager

1 Answer

Hi i have a 1993 Mercury Villager and i need some new seats for it but i cant find them at the pick and pull do you know what other van has the same seats i can use thanks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Mercury Master
  • 783 Answers

Nissan Quest is the same vehicle

Posted on Feb 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1993 mercury villager my o2 sensor has 2 blues a white and a black and the wiring on the van has a black red and white and i need to know what way to wire them


Sounds like the wrong sensor for the car. The correct sensor would also have 3 wires: a signal wire, a ground, and a voltage, reference voltage wire. The 4 wire sensor sounds like it might be a Heated Oxygen Sensor, not applicable on your car.

Dec 29, 2013 | 2002 Mercury Villager

1 Answer

1993 Villager: My van has poor take off power .and it misses on t...


clean the MAF sensor resister wires with carb cleaner carefully. The Maf is in the air intake tube between air filter housing and throttle body.

May 16, 2010 | 1993 Mercury Villager

1 Answer

1993 mercury villager mini van. rear heater fan does not work? do u know why?



Yes, you have bad solder joints in the circuit borad on the relay in the front control head. There a 4 solder pins that needed to be resoldered. I posted a picture on this site or you can go to our Villager site and follow the directions.

I also repair them for $25 plus shipping. I send you a repaied heater control and then you send me yours back for the next person. You can do this. If not, let me know. I also have a shop manual & wiring diagram for $25. Factory manuals, not Haynes.

http://groups.yahoo.com/group/villagerquest/



The one to the right and 2 below also need solder.


312cb02.jpg

May 07, 2010 | 1993 Mercury Villager

1 Answer

My son pulled out and then snapped back the rear passenger side seatbelt on my '99 Merc. Villager Van, and it ended up locked into place near the floor inside the mechanism used to adjust the rear bench...


is the belt wrapped around the lever to adjust the seat?
Try sliding the seat to get some slack.
He may have it in ALR mode. That is when you pull it allthe way out, and then it ratchets it's way back in until it is all the way in. Then it reverts back to pulling out and going in w/o ratcheting.
This is to lock a child seat in.
So, you need to get it in all the way somehow.

go here for more help.

Gerry

http://groups.yahoo.com/group/villagerquest/

Apr 05, 2010 | 1999 Mercury Villager

1 Answer

1993 mercury villager- drivers side seatbelt is stuck.


You have a limit switch at each end of the seat belt track. One could be bad. Is belt stuck forward or at the back? It also has a module to control it.
It operates like a garage door opener. If you have to replace track, it's a big job. Have to take a lot of trim off the van. Best thing to do is get it in the rear position and just use the buckle. Get used part at car-part.com.
page with * is lowest pice. Or, go to pick n pull salvage yard and pull it yourself and learn how it comes out.

go here for team villager help

http://groups.yahoo.com/group/villagerquest/

Jul 29, 2009 | 1993 Mercury Villager

1 Answer

97 mercury villager van lost power and oil light came on


sounds like the oil pump went on it. if so the engine is done

May 27, 2009 | 1997 Mercury Villager

1 Answer

Removing middle seats-procedure


in owner manual.

there are 2 release handles on each seat at front. pull up on them and then rock the seat up at the front. then slide the seat rearward to slide the "U" hooks out of the bottom slots.

Mar 29, 2009 | 2000 Mercury Villager

Not finding what you are looking for?
1993 Mercury Villager Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

64034 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...