Question about 1998 Dodge Ram 3500 2WD

1 Answer

98 dodge ram 3500 no heater blower

Fan motor is OK(applied power to it and it runs) All fuses good. No power to fan switch.

Posted by on

  • 1 more comment 
  • tr49120 Feb 18, 2009

    There is no power to the fan speed resisters either.

  • Anonymous Mar 22, 2014

    the fuses are good and have pwer to the fuse box but the motor still wont start motor turns it is getting gas but wont run

  • Anonymous Mar 27, 2014

    Where is fuse located for heater fan



1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Check your fan speed resisters usually located in the engine compartment

Posted on Feb 18, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

98 dodge Ram 1500 electrical manual? Heater quit working, fan not turning on?

fan motor relay is for fan speeds
heater and AC

blower motor has a resistor
did the motor bench test ok
if fan motorand resistor are ok
i suspect
a faulty on /off switch in the dash panel

i think that system has electronic directional flap actuators not vacuum ..if vacuum might be a leak ..4d2d0af7-5ca3-476a-86ab-3456f74cc675.gif

Mar 07, 2017 | Dodge Cars & Trucks

2 Answers

Trouble shot heater switch and blower moter

You don't give much info, so it's hard to give you a good answer. Do you have power up to the heater switch and after turning the heater switch to the on position do you have power to the blower? Did you check the fuses, do you have power on both sides of the fuse? if you do follow that wire and check for power at the other end of it. Some cars have a temperature sensor and the blower will not come on until the temp. is warm enough so that the blower will not blow cold air. If you track the hot lead from the fuse box to the switch, through the switch and to the blower and at any point find you no longer have power, that would be the component I would think is causing your problem. You can also check the blower by running a test lead from the positive side of the battery to the blower motor and see if it runs.

Nov 29, 2014 | 2004 Dodge Ram 3500 Truck

2 Answers

Heater fan not working

Smack it and see if it comes on. If it does then the motor brushes are bad. If it does not come on, check the fuses. If the fuses are ok, check the voltage on the plug to the motor.

Feb 06, 2014 | 2001 Dodge Durango

1 Answer

1999 dodge 3500 truck. The heater blower motor is not working.

Somewhere in the speed switch or connected to it there is a resistor which controls the speed. These blow out on occasion. I had this happen on my car and the result was that the fan would only run on high. However, depending on how the circuit in your truck is wired, it may quit completely. From what you say, you have power all the way to the switch and none beyond it. Yes, at least one, if not more, of the wires you mention should be hot. If it isn't, you have no power going to the fan.

Dec 15, 2013 | 1999 Dodge Ram

1 Answer

Heater does not work

Check heater fuse.
If fuse good - could be a failure of the blower fan motor or blower control switch.
If fuse bad - bad blower fan motor could have blown the fuse.
DO: check fuse, then blower motor.
Pricing: new blower motor: Duralast PM270 $43.99
new heater control switch: Duralast SW229 $46.99 (without
I'd expect your blower resistor to be good - when they fail, the blower only will work on HIGH setting.

Oct 23, 2010 | 1993 Dodge Caravan

2 Answers

1997 Dodge ram 2500 deisel. Blower fan wont come on. replaced climate control module and fuse is ok. Is there an inline fuse or relay I'm missing?

if the fuse is ok your next step is to see if you have power at the heater fan switch,if you do then the next thing is the heater blower motor resister it is under the heater assembly,that is what gives you different speeds,
the last is test for power at blower motor to see if it is faulty

Nov 21, 2009 | 1997 Dodge Ram 2500 Club Cab

1 Answer

Car a/c heat blower stopped no warning

Check for a blown heater motor supply fuse,
Check operation of heater motor control relay,
Check operation of fan speed control switch,
Check heater motor speed control resistor pack (usually located in the heater ducting - in the air flow),
Check the heater motor runs if power directly applied to the motor- if not motor may be faulty.

Aug 26, 2009 | 2003 Dodge Neon

3 Answers

Subject: 2004 isuzu ac/heater blower is not working

The resistors are in circuit only on the lower fan speed settings.
On the highest speed setting, power is switched directly to the fan motor.
Check fan power supply fuses,
Check power is available to the fan when high speed selected.
If all above OK, apply power directly to the motor to verify fan motor runs- if it doesn't the motor may need replacement/repair.

Jul 29, 2009 | 2004 Isuzu Rodeo

1 Answer

Blower motor will not work

Do further tests at the relay to ascertain whether the fault lies before or after the relay.
Check power availability at the supply side of the relay contacts - should have 12v from a supply fuse on one side of the normally open contact (note -this supply may only be available when Ign or Acc sw is on).
If power supply is ok at the relay contact, check control input to relay operate coil.

If a ground (or 12v) operates the relay, operate the relay with a local ground (or 12v) and check blower motor runs.

If all above OK, check control signal from fan switch is arriving at the relay control coil.- if not trace wiring back to the switch.

Jul 03, 2009 | Dodge Pickup Cars & Trucks

2 Answers

Heater blower is not working have no power at the switch fuse is ok the motor is good

check all the connections on the back of the fuse panel and PCB upanel under the hood...they are known for corrosion

Apr 19, 2009 | 2008 Dodge Ram Pickup 3500

Not finding what you are looking for?
Cars & Trucks Logo

462 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides