Question about 1994 Lexus GS 300

1 Answer

I need to know where is the sensor for the gas

Posted by on

  • elvingarcia3 Feb 18, 2009

    I need to know where can i find the gas sensor for my 1994 toyota lexus, too much gas is coming out from the engine from around the injectors

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

At the end of the fuel rail/ driver side at left of throttle assy.if your leaning over the side of the fender on drivers side. it has two 10mm bolts holding it in and a fuel line attatched and 1 vacum line attatched. its small and its called a fuel pressure regulator. steve

Posted on Apr 04, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where to locate my DPFE sensor on suzuki vitara


2000 Vitara. what engine.
Delta/Differential Pressure Feedback EGR Sensor
1.6L 16V I4 GAS
2.0L J20A I4 GAS
2.5L H25A V6 GAS
2.0L RF/RHZ/RHW Turbodiesel I4

which engine? that be 1st,
to fix engines, you need to know that and 10x for parts buys.

on my GAS, VIT 2.5L
its top rear center. of engine.
part 18 , seen on page 28 here
http://www.fixkick.com/engine/2.5L%202004%20Tracker/25L-2004-engine.pdf

its just a map/baro sensor used to test EGR.
if the tube is clean, it rarely fails.
it monitors the pressure drop, when the main EGR opens.
of P04xx DTC errrors (got those>)

Feb 18, 2014 | 2000 Suzuki Grand Vitara

1 Answer

Why do i need the oxigen sensor in my 1998 dodge ram


May affect gas ,more gas,control oxigen,why is off.

Jan 31, 2013 | 1998 Dodge Ram 1500 4WD

1 Answer

1999 S10 Gas gauge bounces from empty to full, nothing between


This problem is caused by the fuel level sensor inside the gas tank, you will need to drop the fuel tank out or remove the pickup bed to access the level sensor which is part of the fuel pump module on most GM products. The part is about $200.00 and 3 hours to install. See picture below. You can buy the part at a very good price from the on line company I use for parts www.rockauto.com
8_8_2012_11_10_24_pm.jpg

Aug 08, 2012 | 1999 Chevrolet S-10 Pickup

2 Answers

Gas gage read full when empty and sometimes emty


You have a bad fuel level sensor.The fuel tank needs to come out and the sensor replaced.You don`t have to replace the pump assembly.You can get the level sensor separate.I`m not sure if the parts stores have it but I know the dealerships do.Hope this helps.Good luck.

Mar 16, 2010 | 2004 Pontiac Montana

1 Answer

Check engine light is on, hooked up computer to brain and it says it was a fuel leak sensor or fuel leak evape sensor. where is this sensor located, it also only shows fuel gauge reading of 3/4 tank full...


check ur gas cap first for proper seal and or not tightened this is the usual problem the evap system is from your fuel gas cap [gas--vent lines /gas tank-evap canister-throttle body] to ur throttle body/injectors if gas cap good need to check the lines and components for a leak disconnected /cracked broken-as well as the sensors and canister

Feb 21, 2010 | 1992 Ford Ranger

1 Answer

How to replace an oxygen sensor bank 1 and exhaust gas recirculation sensor


The EGR valve is attached to the intake manifold near the throttle body and the 1/1 O2 sensor is on the rear exhaust manifold.

May 02, 2009 | 1997 Dodge Caravan

1 Answer

Bad gas milage


you may need to try to get an idle sensor and get it chgd. maybe the throttle, oxygen sensor also needs chging.

Apr 18, 2009 | 1999 Dodge Ram

2 Answers

I have a 1999 chrysler 300M. I just had sensor put on for the transmission. I have had the car back a week and now the gas guage sensor or something is not working properly. The fuel light indicator...


I would suggest dumping some fuel injector cleaner into gas tank.Sometimes the float mechanism gets gummed up and sticky.I would recomend Lucas injector cleaner

Jul 29, 2008 | Chrysler 300M Cars & Trucks

Not finding what you are looking for?
1994 Lexus GS 300 Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

570 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...