2005 Pontaic G6 GT How do remove driver side headlight assembly?

Make sure theres juice going to the pump. You should here the pump running when you turn the key on. If theres no juice check the fuse.

real interesting... there should be no relation to the "drive" and the head light. current drawn by the starter causes the lights to go out or dim. Check the headlamp relay and for corrosion on connector to lamp assemblies in the engine compartment. On back of assemblies there is a large diameter plastic retainer after you remove the wire clip. Turn counter clockwise and pull back. a wire clip should retain the bulb itself

Remove the bolts from the headlamp assembly.

Remove the push-in-retainers across the front fascia.

Pull the headlamp forward to release the locating tab from the front of the fender, then lift the headlamp up to release from vehicle

then disconnect the electrical connectors

hope this helps

Remove the drivers headlight housing (remove obvious screws on top of housing and then pull the assembly straight forward with moderate force (needed to dislodge from a small ball joint that is not visible)). When the headlight housing is pulled, you will see the horn clear as day below.

It's easy no tools required.
There are 2 inserts behind the head light, just pull them straight up and the headlight will come out. I recomend you use masking tape on the top bumper to prevent scratches when removing.

fast flashing on the one bulb is a fault is due to the failure of one bulb, hence the holder for the flasher unit not wirking has gone defective the contact may have broke in the flasher unit not working , look in where the bulb goes and compare the working and non working unit, you may see a contact missing, hence repace unit, or repair

Upside down L shaped bracket that is bolted to frame just behind headlight assy. Unbolt bracket, lift bracket straight up to unlock headlight assy. Headlight assy should easlier fall forward to replace any of the 3 bulbs

open the hood, on the top of the assembly, there should be a bar/rod on each side. simply remove them and the assembly should slide right out

its probally a haligen bulb needs replaced from the inside under the hood that twists in the back of the light just half a turn the unplug old and put in new

remove head light assembly, replace bulb and re-install