Question about 1998 Chevrolet S-10 Pickup

1 Answer

Need a diagram of vacumn lines one fell off and can't find where it goes?? 1998 chevy S-10

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

Should be on radiator frame in front of engine if not you will need to buy a chevy book for your ride or do a vacuum schematic search

Posted on Mar 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vacumn line diagram for 03 durango 4.7 L 2 wd


look under the hood, the diagram is always there affixed with a sticker.

Sep 09, 2014 | 2003 Dodge Durango

1 Answer

I need a wiring diagram for a 1998 Chevy Blazer fuel pump


The fuel pump assembly consists of fuel pump relay,fuel sensor,the fuel pump controlling fuse,its ECM B fuse. The fuel pump and oil pressure switch. ----------- For its wiring diagram, click the link below and refer the diagram:--- http://technoanswers.blogspot.com/2011/10/fuel-pump-wiring-diagram-for-1998-chevy.html ----------- This should help.Thanks.Helpmech.

Oct 06, 2011 | 1998 Chevrolet Blazer

1 Answer

1991 Jeep wrangler 2.5 standard shift.vacumn lines from transfur case to front drive axle.we need a picture of where each vacumn hose goes. a print out of the colors. thank you


i just boought a 1992 Jeep Wrangelr sport with a chevy 305 V8 and its a automatic with a standard 4 wheel drive and i put in 4 wheel drive and the front tires wont move what is wrong????

Mar 11, 2010 | 1990 Jeep Wrangler

1 Answer

4WD Not Working - No Vacumn From New Transfer Case Switch


do you have vacumn at the t/c switch when engine is running if not trace the line back to the engine also that line tees off to the vac ball

Dec 31, 2009 | 1990 Chevrolet S-10 Blazer

3 Answers

1998 Chevy S-10. The heat will only blow out vents


Possible vacuum leak in the heating system.Start and run the truck for a minute or so,after shutting it off listen for a hissing sound.You may need to remove the kick panels under your dash to determine just where the leak is coming from.Then you can determine if its a damper door or the line is disconnected or broken.Two other possibilities.The control head could be broken(this sends air to the different locations)or an under hood vacuum leak.There's plastic line from your engine that feeds into the cab of your truck,that vacuum line is used to control the vent activation.This is take a lot of time to track down, I hope this helped you?

Dec 07, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

Vaccum hose diagram for 88 chevy truck. I put a 350 motor in my 88 chevy 1500 truck from a 95 suburban. I cant get the throttle body to stop idaling to high. I may need a vaccum line diagram for this motor...


it may not be a vacumn leak from a line,check the throttle shaft for movement,for example,i had a 89 1 ton 350 and my throttle shaft was moving around a lot and in order to keep it from idling high,i had to kick the throttle pedal.But also check the idle air control valve,which is the round sensor on the side of the throttle body.

Sep 10, 2009 | 1985 Chevrolet Chevy

2 Answers

I need a vaccum line diagram for a 4.3 liter the whole under the hood vaccum diagram for a 1998 s10 4.3


Below a link to the diagram you requested for a 1998 S-10 with a 4.3. Please feel free to post back with any questions. Best of luck.
Greg

Chevy S-10 Vacuum Diagram


Jul 22, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

Wiring Diagram 1998 Chevy S-10 starter replacement


The starter has one large cable from the battery positive, and a wire that goes to the solenoid (Part of the starter) that becomes hot when the key ignition is turned to start. This also passes through the neutral safety switch. (So it wont start in gear) Not sure if this is what you need, a little vague.

May 10, 2009 | 1998 Chevrolet S-10 Pickup

3 Answers

Chevy s10 broken vacuum line


The plastic line in the wiring harness goes to the heater controls; and believe it or not , the other end goes to the vacuum tank - but its in the FENDER !!!!! behind the ABS, kinda under the drivers side hood hinge - great place to put one ain't it ? No wonder GM is going broke !! Good Luck

Aug 03, 2008 | 2003 Chevrolet Silverado 1500

1 Answer

Chevy s10 broken vacuum line


I have the same problem, did you get a solution or a diagram?
gonefishn55@yahoo.com

Jul 06, 2008 | 2003 Chevrolet S-10

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

330 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...