Question about 1995 Mazda MX-3

1 Answer

Cleaned out my throttle housing on my 1997 mx3 18i v6 as was running rough and stalling now it wont start at all after clean?

Posted by on

  • Anonymous Feb 18, 2009

    lost compression so had to tow to get it to start so now running again.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Lost compression had to tow now running again so now in garage to see why it was running rough in the first place.

Posted on Feb 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Will not idle when cold. On gas its OK when hot. On petrol rough running and stalls at idle when hot


The Idle air control valve ( IAC ) Gets dirty over time and needs cleaned from years of use. Remove and clean carbon from it, Also clean throttle body with throttle body cleaner. At most auto parts stores Advanced, Auto zone, ETC.

May 12, 2016 | 1997 Toyota Land Cruiser

2 Answers

89 ford probe hesitates when leaving a red light, then runs fine otherwise, fuel filter?


Engine Runs Rough, Stalls, Hesitates on Acceleration, Hard ...

repairpal.com > Problems > Ford > Probe
Ford Probe Engine Runs Rough, Stalls, Hesitates on Acceleration, Hard Starting, Poor Performance. This is a verified problem based on 9 reports. Learn more ...

Starting Problems - 1997 Ford Probe - RepairPal

repairpal.com > Questions > Ford > Probe > 1997 Ford Probe
Dec 5, 2010 - Starting Problems on 1997 Ford Probe ... If the engine runs rough,stalls, hesitates on acceleration, is hard to start, or has generally poor ...

A new misfire/hesitation on accel. Problem.. - ProbeTalk.com Forums

forums.probetalk.com > Tech Section > 2nd Gen (93-97) V6 2.5L

Feb 05, 2016 | Ford Cars & Trucks

1 Answer

84 mustang 5.0 auto-Idle problems. runs Ok when cold , runs rough and stalls when warm. 1st year throttle body injection. was told the IAC valve needs cleaned. can`t find on car


the iac sensor is along the side of throttle body , did you give the throttle plate area a good cleaning out this is where the air path is for the IAC sensor , a lot of idle problems have been fixed with a can of throttle body cleaner and few good squirts of the stuff down the hole

Sep 10, 2015 | Cars & Trucks

1 Answer

96 chevy s10 v6 stalls after i start it up


This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Oct 18, 2012 | Cars & Trucks

1 Answer

Just replaced starter on my car but now its idling rough and running rough sputtering


Try cleaning the throttle body open the throttle all the way and use a tooth brush with carb cleaner clean it good then wipe it out with a clean rag. Start the car might have to give it some gas keep it running if it wants to stall then let it idle on its own for about 5-10 minutes this will relearn the base idle.

Apr 20, 2012 | 1999 Buick Century

1 Answer

My 1994 Honda civic dx idles rough and sputters like its going to stall . but it runs fine at an increased RPM. when at a stop it acts like it is going to stall ... i was told it was the map-sensor.whitch...


Check your throttle plate and housing, as it could have buildup preventing a stable idle. Can be easily cleaned with an aerosol throttle cleaner with engine off, then starting and moderately revving the engine until it clears out the remains of the cleaner.

Aug 26, 2011 | Honda Civic Cars & Trucks

2 Answers

Crank and start but wont stay on


bad ignition,air flow sensor that keeps leaning out the mix and it stalls,bad iac idle control motor,start with a good tune up.cap rotor,wires plugs air filter and clean the throttle body.some honda cars have bad egr valves and the intake manifold has to come apart because it is plugged up inside with carbon.

Jun 07, 2009 | 1997 Honda Accord

1 Answer

Shogun 3000 v6 petrol 1993, it starts but wont drive when u pull away it dies ! iv changed leads dis cap fuel filter


You can try cleaning the throttle body, that will cause low/rough idle and stalling.
Good luck

Aug 29, 2008 | Mitsubishi Mighty Max Cars & Trucks

Not finding what you are looking for?
1995 Mazda MX-3 Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...