Question about 2004 Saturn ION

Open Question

Where is the airbag module located inside of a 2004 Saturn Ion ?

We are replacing the Airbags and the Module in this car, but can't find the Module.... Can anybody help?!?!?!

Posted by on

5 Suggested Answers

  • 412 Answers

SOURCE: Needing to locate the airbag control module '07 caliber

it is located behind the floor shifter in center console..under small piece of carpet

Posted on Jun 20, 2009

jj127
  • 37 Answers

SOURCE: 2000 Chevrolet Malibu LS airbag problems

The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.

Posted on Jun 20, 2009

  • 150 Answers

SOURCE: Airbags deployed

You have to disconnect the battery, replace the air bag modules (air bag modules are the things that explode in your face) and the crash sensors and the control unit or module that came with it. Reconnect the battery and the car should start. Hope this is helpful.

Posted on Feb 18, 2009

  • 1071 Answers

SOURCE: 1999 Honda CRV Module

usually beside park brake inside center console

Posted on Jul 23, 2009

  • 19 Answers

SOURCE: location of body control module on 2007 saturn ion

Bcm and fuse box are one piece, located in front of center console, just under the heater controls.  Remove side panels from console on both sides.

Posted on Aug 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My airbags blue and need to replace them how much would it cost 2004 Saturn ion


Steering Wheel aprox. $540.00
Passenger Dash aprox. $751.50
Deployment Sensors
Steering Wheel Damage?
Dash Damage?
Door Panel Damage?
Shop Total $1500---$2000+

Buy Airbags used at places like Ebay, will save lot $$$

AIRBAG Inflatable Restraint System 751 50 Fits 2004
Saturn Ion Part...

AIRBAG Inflatable Restraint System Steering Wheel 540 00 Fits 2004 Saturn...

http://www.wholesalegmpartsonline.com/

Mar 02, 2017 | Saturn Cars & Trucks

1 Answer

2004 grand marquis airbag code 21. need trobleshooting info.where is control module mounted?


You do not want to be messing with airbags unless you are well trained with them. You have a resistance problem indicting an airbag fault on the passenger side from what info I could find. That indicates in a crash that that airbag will not be functioning properly or at all. Find a professional as airbags are very dangerous if you do not know what you are doing.

Jan 16, 2014 | 2004 Mercury Grand Marquis

1 Answer

2001 pontiac grand am air bag module reset


Yes!!! You can replace it yourself.(Dont let others fool you into paying extra or telling you otherwise.)
-This is for pontiac grand ams 1999-2005 only.
-There are no frontal airbag impact sensors nor are there belt tensioners.
-The SRS system consists of only the (driver airbag) ,(passanger airbag),and the (airbag control module) in 1999-2005 grand ams.

If you crash/wrecked and airbags deployed you will need.
-Driver and Passanger airbags
-Airbag control module

You can buy cheap airbags from a local junkyard any year from 1999-2005 will fit.
You can also find an airbag control module for cheap at your local junk yard BUT YOU MUST FIND ONE WITH THE SAME (PART NO.) AND (SERV NO.) AS THE ONE YOUR REPLACING.The (part no.) and (serv no.) should be at top left of airbag control module.However it does (Not) have to match numbers under barcode or the numbers at the far bottom right of airbag control module.

After you get both airbags and airbag module
-Disconnect car Battery
-Replace airbags
-Replace airbag module (under passanger seat)
-Double check all connections and connect battery.

Congradulations!Your airbags should be back online.

Notes: Two torx 35 head screws hold the driver airbag, access is through two holes behind steering column.
To remove passanger airbag you have to remove glovebox it uses (7mm)screws.After you remove you will see a pair of (10mm)screws holding airbag.
To remove airbag control module First remove passanger seat 2(15mm).Then after removing you will notice a raises area kinda like a vertical bump.Take a razor blade to your carpet and cut it to explose the module underneath.
The airbag module is held by three screws depending on the year of your car it varies.Most likely 3 (10mm).

Mar 24, 2013 | Pontiac Grand Am Cars & Trucks

1 Answer

How do I replace the airbags in a 2004 Hyundai santa fe


They just unbolt them from the back of the bag. You will also need to replace the Airbag diagnostic monitor module under the dash, it is a one time use module.

Nov 01, 2012 | Hyundai Cars & Trucks

2 Answers

Where is the airbag module located on 2004 vw jetta


The airbag module is a serious safety device and should not be tampered with. The entire air bag system ie module , air bags, seat belt tensioners etc are treated as one unit and there fore not a serviceable item or part replacement there of. The module should be located in the bowels of the dashboard (yellow wiring ) and mounter to the bulkhead. Do NOT tamper or adjust any componants.Good luck

Apr 11, 2010 | 2000 Volkswagen Beetle

1 Answer

HOW DO I RESET AIRBAGS SINCE 2003 RR LAND ROVER SAT AND AIR BAGS ON RIGHT SIDE WENT DOWN AND NOW WILL NOT COME UP AND ERROR MESSAGE ON DASH


you've got to check all the connections and wiring to all of the bags and the module. the module may need to be replaced if the airbags went off. and you'd need to bring it into the dealership to have them program the replacement module.

Oct 28, 2009 | 2004 Land Rover Range Rover

1 Answer

Needing to locate the airbag control module '07 caliber


it is located behind the floor shifter in center console..under small piece of carpet

Jun 16, 2009 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

2004 pacifica impact sensors, airbags


you may not always have to replace sensors, but you will have to change the airbag module (usually under front seat, sometimes in middle of dash) To remove the passenger airbag you have to take out the dash.

May 26, 2009 | 2005 Chrysler Pacifica

1 Answer

Airbag module location for 2004 Mazda6


it is positioned in the very centre of the dash board, behind the radio/Air con unit, it is bolted to the floor, you will need to remove the dash board and possibly the air con unit to access. once the module and air bags have been replaced it shouldnt need anything else.

May 21, 2009 | 2004 Mazda 6

Not finding what you are looking for?
2004 Saturn ION Logo

Related Topics:

416 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6869 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...