Question about 2000 Chevrolet Camaro

1 Answer

My turn signals stay on

When i turn the signal on the light blinks then when i turn it off it turns back on is this normal? there is little box behind the radio with some wires in it and when the light turns back on theres a faint click or pop inside of it. the camaro has marker lights that stay on as well so i thought those were the running light not the blinkers too. hope i described well. also its only the front ones that stay on. when i turn the headlights they dim. if that helps

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 335 Answers

You have daytime runing lights. When you turn the signal off does it just stay on or does it flash? If it just stays on and you have some light dimming problems, it is more than likely a bad ground on the front signal sockets. This can be repaired by cleaning or replacing the sockets. Another cause of this problem can be traced to bad bulbs,a very easy fix.Good luck Moe

Posted on Apr 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My turning signals don't blink on the outside and stays illuminated on the inside and also the front outside. My turning signal fuse is also well. I've noticed that my back up lights stopped working. Would...


Usually if you turn on your turn signal and it stays lit solid inside, it's telling you the bulb is bad in your turn signal outside. I would check your bulbs first. Same for the backup lights.

Jan 14, 2015 | Cars & Trucks

1 Answer

Turn signal and Hazzards issue


Turn signal flasher. Replace with a heavy duty one.

Mar 20, 2014 | 2001 Jeep Cherokee

1 Answer

Turn signal flasher relay location in


Turn signals use what is called a flasher to regulate the speed at which the lamps turn on and off. Usually mounted in the fuse box. I have attached the replacement model for a 1996 Roadie. Should take all of 15 seconds to replace.

Mar 16, 2014 | Buick Roadmaster Cars & Trucks

1 Answer

Turn signal stays on


You have a short in your braklight wireing or a exposed wire arcing volts. did you crash or something? Bad blinker box under stearing wheel little round relay? Could be many things!

Jul 21, 2012 | 1991 Toyota Pickup

2 Answers

My right rear turn signal stays solid, won't blink, in the vehicle the right blinker light blinks excessively fast, I have a 1999 surburban


Sounds like a bad ground to me, although i am no expert.
i would be checkinh all connections and take it from there, a little wd40 might just solve it short term.

Nov 26, 2011 | 1999 GMC Suburban

1 Answer

Jaguar xj6 break light cancels signal


Replace the turn signal switch. Bad contact inside causing a crossing of the circuits. When the turn signal is applied it should open the brake light circuit allowing for just the signal to work. Doesn't sound like the switch is doing it's job.

May 23, 2010 | 1989 Jaguar Vanden Plas

1 Answer

1992 Ford Ranger Turn signal/Hazard light issue


Can you just check to make sure the ignition key switch is not staying over to far and not backing off when you try to start it. I had a truck that did that and it messed up my turn signals until I brought the key switch back a little after starting it. Just a simple idea. Be kind with your rating for me. Raz

Apr 19, 2010 | 1992 Ford Ranger

1 Answer

Driver side signals only work when headlights are OFF


What may have happened is either the headlights wiring or the parking lights wiring somewhere along the wiring fused to the left turn signals wiring. Depending on if the turn signals go on when you put the parking lights on or the headlights on.

If the signals come on when you turn on the headlights than you only need to locate the light green wire that comes off the left turn signal harness.

Next follow that wire the entire way back to the firewall looking for another wire fused to that wire as you go.

If there are no signs of this you need to continue looking on the other side of the firewall all the way back to the turn signal and hazard flasher unit which is a black box that connects to a black harness located next to a grey harness behind the knee bolster.

But if the signals come on when you turn on the parking lights than you will also need to check the wiring from the rear left signal and follow that light green wire all the way back to the turn signal and hazard flasher unit.

This should fix your problem, but if not than your problem may lay within the the wiring between the turn signal/hazard switches and the turn signal and hazard flasher unit.

Also you may have a burnt circuit in the junction block. This block is where the light green from the rear left signal and front left signal meet. Don't have a description but if you cannot find it let me know and I will go out to the yard and look myself and let you know.

Apr 22, 2009 | 2004 Dodge Intrepid

2 Answers

Rear turn signals stay on all the time, cant turn them off


this is caused by the turn signal switch, replace it.

Dec 16, 2008 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
2000 Chevrolet Camaro Logo

397 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...