Question about 2001 Dodge Ram 1500 Truck 2WD

3 Answers

1995 Dodge ram 1500 two wheel drive 360 motor

I have a 1995 dodge ram 1500 360 ,I put the truck in the garage sometime around late Oct early November, I use it for outside work so when it freezes I'm done with. This time last year I landed a small job and needed it when I went to use it, it would start right up then as soon as it warmed up it would start loosing power and miss then stall at a light.I got to the job and it sat and cooled off for about 7 hours, as soon as I stared home and it warmed up it starts to miss and then stalls when it needed to idle (it always starts back up) I replace the fuel pump, coil, wires,plugs,idle sensor,and some other sensor on the throttle body,it seemed to clear it up for the most part but it still would get sluggish when it got hot and I had a load on,but still kept going, now I'm wanting to use it this coming week, it has set for 40 days I took it out for a ride and the same thing is happening,starts great idles great until temp comes up and then just like if you turn the key off it stalls,(always starts back up of course)I let it sit and cool for a few hours starts idles for 20 min the bang stalls.I'm ready to launch it in the lake. can you give me some ideas of what it might be or is.Thank you Mike

Posted by on

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 115 Answers

You may have a catylitic convertor that is clogged or partially clogged. Loosening the exhust at the manifolds and leave idleing and see if it still dies.

Posted on Feb 15, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 150 Answers

You might want to clean the throttle body. And the I.A.C. passage in the throttle body. Also check the resistance of the coolant temp sensor.

Posted on Feb 15, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Have you tried changing the temp sensor

Posted on Feb 15, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will not go in to four wheel drive


Dodge Ram 1500 Questions - 4WD not engaging all the ...

www.cargurus.com > Questions > Dodge > Ram 1500

CarGurusOct 18, 2013 - to get it into 4LOW is to 1st get it into HI and then stop and shift it intoLOW. ... I have a 98 Dodge Ram 1500 that I can not get the 4 wheel drive to ... what web site can i go to so i can see how the inside looks on timing gears.

Diagnosing 4WD Engagement Problems on Dodge Ram ...

dodgeram.org > Main > Tech > Maintenance
Nov 1, 2000 - This shift will be easier if you momentarily release the accelerator pedal. Apply a ... Do not attempt to shift to or from 4L while transmission is in gear or clutch is engaged. ... OK, now when you shift into 4WD it gets a little more complicated. .... I have a 97 RAM 1500 Club Cab Sport 4 X4 and I am having

2008 Dodge Ram 1500 Won't Engage 4 Wheel Drive: 20 ...

www.carcomplaints.com/Dodge/Ram_1500/.../drivetrain/wont_engage_4...
Ram 1500 Won't Shift Out Of 4 Wheel Low - Ram got locked into 4 wheel low. Found this ..... It would not go into full time 4 wheel drive or go into 2 wheel drive.

Software Update and Axle Disconnect Actuator ... - RepairPal

repairpal.com > Problems > Dodge > Ram 1500

Feb 08, 2016 | 2004 Dodge Ram 1500

1 Answer

Sparks under steering wheel of dodge ram 1500 2003


My blower on my 04 would randomly cut off but if you tilted the steering it would sometimes work again. Pulled the cover off the steering column and found that one off the connections(plug ins) was arking. Squeased connection closed a bit more with a small screw driver and put some electrical dilithium grease in it and haven't had a problem since.

Mar 05, 2013 | 2004 Dodge Ram 1500

1 Answer

Transmission not wanting to shift out


Sometimes if you got a transmission that don't match the computer that controls it, you get this kind of problem. For example if you got a differenty year model from the original.

May 13, 2010 | 1997 Dodge Ram

2 Answers

How to replace front wheel bearing on a 2002 Dodge 1500


You take off the right tire. You have take all the bolts out from underneath the

Feb 06, 2010 | 1999 Dodge Ram

1 Answer

My four wheel drive wont engage in my 1995 dodge ram 1500


CHECK 4WD FUSE.AND CHECK ELECTRICAL WIRES A VACUUM LINES GOES TO TRANSFER CASE AND CHECK FOR WORN AND DAMAGE SHIFT LINKAGES.

Jan 01, 2010 | 1995 Dodge Ram

1 Answer

Where do i put the new transfer case oil on a 2002 DODGE RAM 1500 Truck? please help...


your transfer case controls you 4 wheel drive it is between front wheels it drives the front wheels

Nov 28, 2009 | 2001 Dodge Ram 1500 Truck 2WD

2 Answers

What transmission is in a 1997 dodge ram 1500 with a 360


If it is 2 wheel drive, than it is a 238-2 tranny

- 42RE with the 3.9L V6
- 46RE with the 5.2L and 5.9L V8
- 47RE with the 8.0L V10 and 5.9L Cummins diesel

(238 is the cubic inch displacement of the 3.9L V6.)

Sep 16, 2009 | 1997 Dodge Ram 1500 Club Cab

1 Answer

Left front popping. already relaced hub assembly. What next????


8002ae8b.gif The top is a 216. The bottom one is a 248. Your option's list calss it something different so I don't know which it is. It sounds like you've got a problem with the u-joint. They're easy to check. If you see a lot of bright orange rust around them, they're bad. Also, put the truck in 4 wheel drive, make sure the front axle engages, and grab the front driveshaft and turn it back and forth sharply while watching the u-joint. If it's bad you'll see the axle side roate a little bit but not the wheel side.
80144188.gif

Apr 15, 2009 | 1999 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

211 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...