Question about 1996 Chevrolet Cavalier

1 Answer

Heater problem Only when I am in drive the thermisate is riding fine then I put the heat on the temp will go down . will stay by the line not go all the way down it smells not real strong I am shour it coolent. replaced thermistate if it might be heater core what typ of time is in it and price then it might be head gasket but my car is not doing anything but this problem. no smoke no over heating no loose of coolent that it showing right now

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

I would check the oil for coolant then more than likely be your heater core

Posted on Feb 15, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is my heater control valve located on my chevy 1500 WT 4.3 2 wheel drive pick up Im not getting any heat unless riding down road when I stop it blows cool untill I start driving again


Chevy vehicles do not heater control valves in the water lines any more...they always rust out and malfunction. What you are probably experiencing is a bad vacuum ball or a vacuum tubing leak in the heater box area under the dash. The control lead that you use to adjust the heater (temp and direction), is vacuum controlled from engine vacuum. Engine vacuum varies under load and at idle, so the manufacturer put vacuum balls under the dash to store vacuum for the controls. When you adjust the heat or direction, vacuum from the balls is diverted to vacuum motors that position the blend doors to pass air thru the heater core or A/C evaporator. Other motors direct their door(s) to position the air to the floor, mid-vents, or to the defroster. A leak in the tubing, ball, or motor can cause the door(s) to retract to default if vacuum drops down as it does at idle. Have the heater box and vacuum system to it checked out.

Dec 08, 2015 | Cars & Trucks

1 Answer

99 CHevy astro no heat


Blocked air intake to system?

Jun 30, 2017 | Cars & Trucks

3 Answers

No heat blowing cold air.


Do you smell coolant inside of the vehicle. If so then chances are your heater core is going.

Nov 23, 2013 | 1997 Ford Contour

1 Answer

1998 subaru forester overheating heater blows cold air


Any chance of a head gasket leak? Is the coolant level still full? These were known for head gasket issues. Coolant is a closed system and level will not drop unless there is a leak. Make sure there is no air in the system. Replace the radiator cap to make sure that it is operating properly.

Mar 02, 2017 | 1998 Subaru Forester

2 Answers

No heat,engine temp.is normal


the valve that allows the hot water into the heater core is not opening. most likely electronic issue. also check all vacuum and electric lines.

Nov 03, 2009 | 2000 GMC New Sierra 1500

1 Answer

No hot air no temp control can not direct air flow


I have a 98 dodge intrepid wjth a digital temp control Icann't get heat when I go up with temp or in manual over ride.Line's to the heater core are hot both coming and going.Checked # 17 fuse its good.Could it still be the heater core??

Oct 13, 2009 | 1998 Dodge Intrepid

3 Answers

No Heat in 99 Taurus


Just finished fixing my daughters 1999 taurus heat. It would blow warm only when running down the road. At idle it blew cold. I started with replacing thermostat, and water pump because they are the easier fix. Still did not help. Then I replaced the heater core. A daunting job but not that hard to move the dash slighly out of the way to replace. There is a good write up at tarusclub.com. After that, heat was better but at idle, it would still blow cool sometimes. Researched and found answer. Park car on the steepest hill you can find with front of car up. Start car and take off reservoir cap. Let car warm up and keep rpms about 1500. After a while the fluid will come running out of the car and all over the place but it will bring air bubbles with it. Reduce rpm, add more fluid and repeat about 3 times. It will make a mess but after that, the heater works perfectly. We get heat long before the temp gage indicates any and it never blows cold unless you lower the temp.

Nov 21, 2008 | 1999 Ford Taurus

1 Answer

Manual heating system with automatic trans. 7.3 L Diesel, 45k miles


it may be your thermostat, the gauge on the dash is a dummy gauge, there is only three positions that it sees, dead cold, operating temp, and hot, so even though the needle looks fine it just means it s closer to operating temp then it is to cold,

Jul 31, 2008 | 2003 Ford F250 Super Duty Crew Cab

Not finding what you are looking for?
1996 Chevrolet Cavalier Logo

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

78257 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...