Question about 2006 Saturn ION

1 Answer

Power window fell down inside door

2006 saturn ion coupe. how do I remove the door panel to get the window back on the track

Posted by on

  • Anonymous Mar 18, 2014

    how to remove rear door panel

  • Anonymous Mar 30, 2014

    passenger windows wont work

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 541 Answers

There are clips holding the door panel around the edges. to remove the clips, use a small screwdriver to feel for them, then use another one to pull the panel on the other side. Pull outward from both sides of the clip until it comes loose. Do this repeatedly, and then loosen and remove the arm rest.

Pull the window up and have a helper hold it as you work it back into the track.

Good luck.

Posted on Feb 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Passenger side window came off trac and is sitting in door


you have to remove the door panel..unbolt the tracking from inside the door..slide the windows back inside the track rails....push window all the way up..tape the window so that id does not fall back down or have someone hold window up while you rebolt the track to the door.replace door panel....the tracks move over time and that it why the window fell.

Jan 26, 2011 | 2004 Cadillac Deville

1 Answer

I need to know how to replace the side mirror on 2007 Saturn Ion


You may be lucky and just have to remove the top section just behind the mirror. Usually you have to remove the door panel to access the bolts.

Apr 28, 2010 | 2007 Saturn ION-2 Quad Coupe

1 Answer

2006 volkswagen beetle convertible rear passenger window fell off track- how do i get to it to fix it?


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge.

Sep 10, 2009 | 2006 Volkswagen New Beetle

2 Answers

2003 saturn ion 3 driver side window won't roll down.


It may mean a bad switch, regulator, or motor.

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you can test the switch to see if it's the switch that's broken. If not, you can then pull off the weather seal and access the insides of the door

Aug 24, 2009 | 2003 Saturn ION

1 Answer

Driver door wont open


sounds like a hinge problem or the locking device to the door. Might have to play starkey and hutch for a while and jump in the window. Just kidding !! I would take to the dealer and have them look at it. But it appears to be the locking device the way it sounds.

Jun 27, 2009 | 2006 Saturn ION

1 Answer

I was rolling up one of my rear power windows and it made a terrible noise and then fell back down. It now will not roll up and it slides freely when I pull up on the glass.


You will have to remove the screws of the door panel, than take flat-tip screwdriver and pry off door panel. Than you will have to put window back on the track.

Jun 22, 2009 | 2006 Acura MDX

1 Answer

Drivers side door jammed


You will have to roll window down and take very long screw driver to insert through glass opening and beak up latch assembly then door will open ,Then remove door panel and will be able to replace latch,Best done by proffessioal,one mistake can cost.

Jun 12, 2009 | 2006 Saturn ION

2 Answers

Need a part, don't know the name


Might be the door Applique if it's on the outside??

May 15, 2009 | 2007 Saturn ION-2 Quad Coupe

2 Answers

I have a 06 saturn ion. my window will go up


towards the back of the door is a short track that runs left to right. there should be a nut either loose or missing on this track. put loctite on the stud, then put the nut back on. do this AFTER the window is back on track.

Apr 22, 2009 | 2006 Saturn ION

1 Answer

2006 Saturn, passenger side mirror


Just a screw driver and a wrench or socket (actual size varies with cars)
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Jul 21, 2008 | 2006 Saturn ION

Not finding what you are looking for?
2006 Saturn ION Logo

Related Topics:

1,003 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...