Question about 1995 Oldsmobile Cutlass Supreme

1 Answer

No tail lights

I have break lights,blinkers but no tail lights.i need some help please!

Posted by on

  • hodgesbmx Feb 15, 2009

    yes fuses have been checked,could it have to do with my remote start system?

  • ccn7 May 11, 2010

    Did you chk. fuse?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 51 Answers

Do you have dash lights if not then has to be a fuse

Posted on Feb 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 Oldsmobile Silhouette. When I turn on my left blinker all is fine until I press the break then the right blinker shows solid on dash and park assist lights flash. When I turn on right...


Your problem is either a bad bulb in the tail light/brake lights or your turn signal switch is bad. I'm more inclined to say that the problem is the turn signal switch and you need to replace it.

Feb 05, 2015 | Oldsmobile Cars & Trucks

1 Answer

Blinker/Tail Light Issue


The Bulbs Have 2 filliments in them if 1 is burnt out that would give you the fast not working tail light there may be an issue with the brake light switch located above the brake pedal on the arm.

May 16, 2013 | 1997 Plymouth Voyager

1 Answer

Dodge dakota tail light parking light is out on driver side


those lamps have 2 filaments and one of them (the lower brightness one) is burnt out and the brighter one (brakes and blinker) still works. you need to replace that lamp

Mar 05, 2013 | Dodge Dakota Cars & Trucks

1 Answer

Break lights and blinkers not working


If you put the tester on the outlets and it lights up properly but the bulbs dont, you have already concluded that the wiring isn't the problem. unless of course the wires are corroded and simply putting the bulb in shorts it out. Have you tested the bulbs?

Jul 22, 2012 | 2008 Pontiac G6

1 Answer

96 contour. left tail light, 1 and 2nd break light are out.


Everything works, more or less, so you know that the switches and fuses are good. That means that you've got either bulb problems or power/ground problems. First, try swapping the bulbs around to see if the "bad" lights will work with the known "good" bulbs in them. If so, you just need to replace some bulbs. If not, check the sockets inside and out for corrosion, clean them (wire brush, steel wool, sandpaper, etc.) if necessary, and use a voltmeter or automotive tester to make sure that you have power and ground to each socket. The fast flash on the turn signal is just an indicator that a bulb is out.

Bill B

Apr 28, 2010 | 1996 Ford Contour

1 Answer

Drivers side rear blinker light needs replaced


Open the tail gate, and you will see on the side of the tail light housing two screws that you will need to unscrew in order to take the housing out. If it is the tail light ,that is on the actual gate, open the tail gate and remove the plastic bed liner there are few of screws that need to be removed. Hope this helps you fix it.

Apr 17, 2010 | 2003 Subaru Baja

1 Answer

No break lights, tail lights or blinker on passenger side


check fuses with a tester. just because they look good can be missleading

Oct 05, 2009 | 1989 Jeep Cherokee

9 Answers

No tail or running lights


Have you looked at the relays under the hood One of thim have something to do with the lights.

Jan 21, 2009 | 1993 Toyota T100

1 Answer

No dash lights and no tail lights


Check for faulty wires at the fuse block, had one fall off from the block itself from the rear, or it could be a wire break somewhere along the way.

Stop Lights and Blinkers are independant fuse.

Tail lights are on there own fuse and could be a wire break in the rear or removing the bulb and using a metre check for signal at bulb socket where trouble is, Check for disolored connections, Green in color or simular, could be a bad connection which in turn is not letting the curent to other side, Causing a short and loss of power to all remaining lights in curcuit.

Sep 15, 2008 | 1999 Chrysler Town & Country

3 Answers

Trailer wiring for 06 GMC Canyon 4x4


exactly what does it do? please explain what happens when you press the brake turn on the light than brake signals ect.....

Aug 13, 2008 | 2006 GMC Canyon

Not finding what you are looking for?
1995 Oldsmobile Cutlass Supreme Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...