Question about 2000 Volkswagen Golf

1 Answer

VW Golf Windscreen Wiper

Only 1 of the front windscreen wipers on my car is not working properly. i checked to have a quick look 2 c what the problem could b n noticed tht the wiper that is ok is stiff as it should b and the other 1 that is not working properly is very loose. Let me know if u need any further info as describing it is quite difficult.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 84 Answers

Sounds like the linkage part came off from the motor. You'll have to remove the 2 wipers arms and the plastic tray to inspect further.

Posted on Feb 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2002 ford focus windscreen wipers at the front dont reset properly. Any ideas?


It is likely the wiper motor is defective due to a failed park circuit switch inside the wiper motor drive.

Jun 22, 2016 | Ford Cars & Trucks

1 Answer

Windscreen wipers not working on my vw passat 2005 '05' but washers are working!


First time you must diagnose why windscreen wipers going slow and/or stopping.
If the windscreen wipers fuse is good:
In order to find out the cause of wipers stopping you can try follows:

1. Carefully extract the wiper arms from their axles (two pieces). In some cases you need to use an extracting tool. Heed of the windscreen !!!
2. Disassemble the plastic covers from the bottom of the windscreen.
3. With the bonnet up you can start the engine, (transmission in "N" or "P" position and parking brake on). Now you must switch on the control lever of the wipers, and go to the engine compartment. If the wiper motor runs let the wiper motor running for a few minutes and switch off. Go to the step 4. If the wiper motor do not runs you must check first the electrical feeding of the motor. It is necessary to unscrew three bolts of the mechanism and disconnect the electrical coupling (difficult assurance). If the electrical feeding is OK you must replace the motor - steps 5, 6, 7. If not you must check electrical connections, the control switch of wipers and electric cables.
4. Now you must check the two bearings of wiper mechanism with your hand. In the most cases the left bearing is out of order (is very hot). This is the most encounter fault of the wipers.
5. For have enough space to manipulation the wiper motor together with their mechanism you must extract the plastic cover of the engine computer box, and extract also the box screws. Then you can move slowly the engine computer box, just for a few milimeters.
6. You must disconnect the electrical coupling of the motor (difficult assurance), unscrew three bolts of the mechanism and extract together with the motor. You must move them slowly between windscreen and engine computer box until the wiper motor go out together with the mechanism. This is the most difficult operation!
7. Now you can repair the bearings, replace entire wiper mechanism or replace the wiper motor. It is not very simply, but it works.
Heed of the windscreen !!!
Refit all in reverse order.

Apr 14, 2011 | 2005 Volkswagen Passat

1 Answer

Hi, I have a 2001 VW golf, and my windshield wipers won't work, they start to move slowly then they stop and they won't go back down? How do i fix this problem or what is the problem? i have check the...


How to check & change a wiper motor, and repair wiper mechanism on 2001 VW Golf

First time you must diagnose why windscreen wipers going slow and/or stopping.
In order to find out the cause of wipers stopping you can try follows:

1. Carefully extract the wiper arms from their axles (two pieces). In some cases you need to use an extracting tool. Heed of the windscreen !!!
2. Disassemble the plastic covers from the bottom of the windscreen.
3. With the bonnet up you can start the engine, (transmission in "N" or "P" position and parking brake on). Now you must switch on the control lever of the wipers, and go to the engine compartment. If the wiper motor runs let the wiper motor running for a few minutes and switch off. Go to the step 4. If the wiper motor do not runs you must check first the electrical feeding of the motor. If the electrical feeding is OK you must replace the motor - steps 5, 6. If not, you must check electrical connections, the control switch of wipers and harness.
4. Now you must check the two bearings of wiper mechanism with your hand. In the most cases the left bearing is out of order (is very hot). This is the most encounter fault of the wipers running.
5. You must disconnect the electrical coupling of the motor (difficult assurance), unscrew three bolts of the mechanism and extract together with the motor. You must move them slowly between windscreen and engine computer box until the wiper motor go out together with the mechanism. This is the most difficult operation!
6. Now you can repair the bearings, replace entire wiper mechanism or replace the wiper motor. It is not very simply, but it works.
Heed of the windscreen !!!
Refit all in reverse order.

Feb 27, 2011 | 2001 Volkswagen Golf

2 Answers

Windscreen wipers only go half way


wipers stop halfway up windscreen

May 24, 2010 | 1999 Volkswagen Passat

1 Answer

My front wipers arent working, could it just be the fuse? if so which fuse do i change as the list only has my rear wiper on it.


Fuse nr.31, F31, (25A) = Windscreen wipers
This fuse is placed on fuse box / relay plate engine bay 1, under bonnet in engine compartment area!

If the fuse F31 is OK.
You must diagnose why windscreen wipers going slow and/or stopping.
In order to find out the cause of wipers stopping you can try follows:
1. Carefully extract the wiper arms from their axles (two pieces). In some cases you need to use an extracting tool. Heed of the windscreen !!!
2. Disassemble the plastic covers from the bottom of the windscreen.
3. With the bonnet up you can start the engine, (transmission in "N" or "P" position and parking brake on). Now you must switch on the control lever of the wipers, and go to the engine compartment. If the wiper motor runs let the wiper motor running for a few minutes and switch off. Go to the step 4. If the wiper motor do not runs you must check first the electrical feeding of the motor. It is necessary to unscrew three bolts of the mechanism and disconnect the electrical coupling (difficult assurance). If the electrical feeding is OK you must replace the motor - steps 5, 6, 7. If not you must check electrical connections, the control switch of wipers and electric cables.
4. Now you must check the two bearings of wiper mechanism with your hand. In the most cases the left bearing is out of order (is very hot). This is the most encounter fault of the wipers running at Audi.
5. For have enough space to manipulation the wiper motor together with their mechanism you must extract the plastic cover of the engine computer box, and extract also the box screws. Then you can move slowly the engine computer box, just for a few milimeters.
6. You must disconnect the electrical coupling of the motor (difficult assurance), unscrew three bolts of the mechanism and extract together with the motor. You must move them slowly between windscreen and engine computer box until the wiper motor go out together with the mechanism. This is the most difficult operation!
7. Now you can repair the bearings, replace entire wiper mechanism or replace the wiper motor. It is not very simply, but it works.
Heed of the windscreen !!!
Refit all in reverse order.

Jan 13, 2010 | 2006 Audi A3

2 Answers

VW passat windscreenwiper not working


the switch is the most likely culprit i have had this befor ewasher works but wipers dont

Jul 19, 2009 | 1999 Volkswagen Passat

1 Answer

Rear windscrenn wiper of Mk4 Golf not working


the linkage that work the wipers are probably gone

Jun 05, 2009 | 2000 Volkswagen Golf

1 Answer

VW Bora wiper problem


Have you checked the wiper motor and linkages to make sure they are properly lubricated? Take care to keep your fingers clear of the (hopefully) moving parts! Your typical can of maintenance spray might get them going initially, but grease is really needed in the long run. D.

Jun 18, 2008 | 2000 Volkswagen Golf

Not finding what you are looking for?
2000 Volkswagen Golf Logo

603 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60792 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...