Question about 2000 Chrysler Sebring

Open Question

How do you remove map light cover on the mirror

The car is a 2005 Sebring Convertible with dual map lights. One light works the other doesn't. Also what size bulb will it need the manual says a 906, but the base doesn't seem to be miniture.

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: driving lights on chrysler sebring convertible

The roatating knob that turns on the headlight pulls out to turn on the fog lights, but only pulls out when the headlights are on,

Posted on Dec 24, 2008

  • 113 Answers

SOURCE: CLIMATE CONTROL BULBS DEAD SEBRING 2000

According to the Chrysler manual the heater/AC control unit bulbs can only be serviced by an "authorized service center after removal from vehicle" If your comfortable taking it apart to look anyway it probably can't hurt.

Posted on Mar 26, 2009

  • 3 Answers

SOURCE: 2007 Chrysler TOWN AND COUNTRY.. OVRHEAD MAP

I had the same problem on my 07 and it turned out to be caused by the bulbs getting too hot and melting the surrounding plastic which opened the circuit powering them. I was able to fix the problem by removing the bulbs and cleaning the sockets allowing the bulbs to seat correctly. The lenses snap off to give you access to the bulbs. If you are not familiar with how interiors of cars come apart, I would not suggest doing it as you may crack the lens.

Posted on Oct 13, 2009

  • 1608 Answers

SOURCE: After this winter, the blower motor on my 2002

Just go on the passengers side under the dash and remove the insulator panel to see the blower motor.What usually happens is when it gets cold out critters from outside will work their way into your car and make a nest in the blower motor fan.This throws the fan out of balance and hence the vibration.Once you can see the blower motor then remove it.There are 3 or 4 screws.Hope this helps.Good luck.

Posted on Mar 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace the back up light on a 2004 Sebring


really. you have to pull the light cover off. if its on the trunk lid side, I am just guessing but you have to pull the interior panel to get to the light bulbs

Oct 20, 2014 | 2004 Chrysler Sebring

1 Answer

How do i replace a 2008 chrysler sebring convertible drivers side mirror?


remve teh black plastic cover from the door then remove the door panal undo the conector if its power mirror remove 3 10mm nuts revers for instolaton

Feb 13, 2014 | 2008 Chrysler 300

1 Answer

Head lights pulse 2005 sebring convertible


Put a Multimeter on your Battery and see if you are having a fluxuation from the Alternator, that is where your Voltage Regulator is

Apr 11, 2013 | 2005 Chrysler Sebring Conv

1 Answer

2005 Sebring Convertible Check engine light


bad 02 sensors. you need to have your car scanned. auto zone will scan it for free. tell you the code. sell you the part needed to fix it.

Dec 28, 2009 | 2005 Chrysler Sebring Conv

1 Answer

How do i turn off rearview mirror lights; i think i must have hit a button


There should be a button on the rear view mirror which cuts power to the map reading lights, if the switch is not the light cover itself.

Dec 25, 2009 | 2005 Ford Five Hundred

2 Answers

My 2004 chrysler sebring electical is not working.


Check around the MAP sensor area for any connections that may have been disturbed while you were replacing the sensor. Most or all of those functions are controlled by the body control module. I would think that a fault like that would show on the scanner readouts.

Aug 23, 2009 | 2008 Chrysler Sebring Convertible

1 Answer

Dashlight location for a 1999 sebring convertible


Not usualy 1 single bulb but a number of them.Not usual that they all stop working have you checked that the dimmer light hasnt been moved?If no luck with dimmer youll have to remove dash to change the bulbs.Anyway good luck and happy new year.

Dec 29, 2008 | 1999 Chrysler Cirrus

1 Answer

2005 Sebring Convert Radio/light off


I am having this same problem with my 99 sebring.. anyone know what we can do to fix this?

Oct 21, 2008 | 2005 Chrysler Sebring Conv

2 Answers

Driving lights on chrysler sebring convertible


The roatating knob that turns on the headlight pulls out to turn on the fog lights, but only pulls out when the headlights are on,

Aug 15, 2008 | 2004 Chrysler Sebring

Not finding what you are looking for?
2000 Chrysler Sebring Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74115 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7188 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...