Question about 1998 Ford Ranger SuperCab

1 Answer

1998 ford ranger ignition problem

1998 ford ranger doesn't seem to be getting any fire.it just turns over with no apparent unusual noises from engine.i tried starting fluid with no results.

Posted by on

  • Anonymous Mar 17, 2014

    engine turns over but will not start

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 118 Answers

Do a basic check of the ignition system if you have a cap and rotor take the cap off and take a look.make sure the coil wire is not burnt,remove it and look.but more than likely the ignition control module is bad.you can scan the computer for codes and that might get you closer.hope it works have a good day DB

Posted on Feb 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 ford ranger right turn signal doesn't work


Find and replace the flasher. Turn the other blinker on and follow the clicking noise. It will be a small square cox making noise

Sep 01, 2012 | 1997 Ford Ranger SuperCab

1 Answer

1998 Ford Ranger 2.5L has no fire. Shop said it was the PCM. I replaced it but still no spark. Crank sensor has also been replaced


A mechanic would check to see if the coil is getting voltage and a ground signal from the ignition module.

Aug 24, 2012 | Cars & Trucks

1 Answer

My 1991 Ford Ranger isn't getting any spark. I changed the spark plugs, wires, ignition module, and the coils. It turns over but does not start


if this is a 2.3 duel fire with the 8 spark plugson a 4cyl it needs a crankshaft postion sensor sorry to say hope it helps

Jan 14, 2011 | 1991 Ford Ranger Supercab

2 Answers

1996 Ford Ranger will turn over but wont start lights work radio works


Sounds like a bad Ignition Module which would cause no firing of the plugs. Pull the #1 plug, put the plug wire back on it and hold the plug (with insulated pliers) to the metal on engine. Then have someone start the truck and see if the plug is firing.

Jan 06, 2011 | 1996 Ford Ranger SuperCab

1 Answer

My 1998 ford econoline is overheating, I flushed the water and replaced it with antifreeze but its still overheating


Hi! most likely that you may have a bad sensor or a vacuum leak by the engine. Start the ignition and safely check under the hood, check the engine from top to bottom and see or hear some unusual sound noise, you may also check infront of the rediator, sometimes the leak start there and it gets transfer to the AC compressor. best of luck.

Glad to help.
Ginskie.

Jul 14, 2010 | 1998 Ford Econoline

1 Answer

Where is the interia switch located on the 2004 model for a ford ranger?


This switch is located under the
right-hand side of the glove box,
just above the carpet.
To reset the switch:
1. Turn the ignition OFF.
2. Check the fuel system for leaks.
3. If no leaks are apparent, reset the
switch by pushing in on the reset
button.

Jun 04, 2010 | 2005 Ford Ranger

1 Answer

Rubbing/grinding noise


Usually the strut bearing will make this noise upon turning a corner and hitting a rut or pot hole when turning. A wheel bearing will make a low pitched whinning sound constantly

Jan 16, 2010 | 1998 Ford Ranger SuperCab

1 Answer

1998 ford raner not getting any fire


If it's not getting fuel check the interia switch. There is a label under you hood that explains "If vehicle fails to start". The switch is on the passenger side kicker panel behind it. If it accidently getting kicked by a passenger it can turn the fuel pump off. Just check it happens all the time to Ford owners.

Feb 14, 2009 | 1998 Ford Ranger SuperCab

1 Answer

Ignition wiring


firingorder6a.gif firingorder6.gif 1991-1994 2.9L and 3.0L Engines Firing Order 1-4-2-5-3-6 1995 And Later 3.0L V-6 With DIS Ignition System Firing Order 1-4-2-5-3-6
4.0L Engines Firing Order: 1-4-2-5-3-6 DIS Ignition System

Nov 22, 2008 | 1995 Ford Ranger Supercab

Not finding what you are looking for?
1998 Ford Ranger SuperCab Logo

271 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...