1993 f150 running badly - won't go over 1500 rpm in drive
Replaced timing, both fuel pumps, fuel filter, spark plugs, wires and distrubuter cap, s-belt. pressure in all valves 110/or more, fuel pressure is 40... rpms fine in park, but have to find "tickle spot" when driving. Don't have a code reader... any ideas greatly appreciated.
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need. goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You've already eliminated the spark plug & wireset, distributor cap & rotor. Sounds like your car needs a tune-up, specifically, the PCV (positive crankcase ventilation) valve, and/of the EGR (Exhaust Gas Recirculation) valve.
Components checked/replaced during a tune-up are: air filter motor oil motor oil filter breather filter fuel filter(s) fuel strainer PCV valve EGR valve spark plugs spark plug wires ECM or distributor cap & rotor cabin air filter transmission oil filter transmission oil engine coolant check all vacuum hoses and lines
Troubleshooting the no-start condition - from the 1990 Mitsu Mighty Max Repair Manual:
Priority Action Part Type -- Cause 1 Inspect Battery -- Battery Discharged or Faulty. 2 Inspect Battery Cable -- Corroded, Broken, Shorted or Poorly Connected Battery Cable. 3 Inspect Distributor Cap -- Distributor Cap Cracked or Burned. 3 Inspect Fuel Filter -- Clogged or Dirty Fuel Filter. 5 Inspect Ignition Coil -- Faulty Ignition Coil. 6 Inspect Wireset -- Worn, Damaged or Faulty Spark Plug Wire(s). 7 Inspect Spark Plug -- Incorrectly Gapped or Fouled Spark Plug(s). 8 Inspect Starter -- Starter Motor Faulty. 9 Inspect Fuel Pump -- Low Fuel Pressure. 10 Inspect Solenoid Switch -- Faulty Starter Solenoid Switch. 11 Inspect Fuel Pump Relay -- Faulty Fuel Pump Relay. 12 Inspect Fuel Injector Pressure Regulator -- Faulty Fuel Injector Pressure Regulator. 13 Inspect Ignition Switch -- Improperly Connected or Faulty Ignition Switch. 14 Inspect Starter Drive -- Faulty Starter Drive. 15 Inspect Fuel Injector -- Dirty or Worn Fuel Injectors. 16 Inspect Fuel Pump Strainer -- Clogged or Dirty Fuel Pump Strainerat. 17 Inspect Engine Control Computer -- Incorrect Operating Information Being Delivered and Sent From The EEC. 18 Inspect Fuel Tank -- Fuel Tank Empty. 19 Inspect Carburetor -- Carburetor Flooded or Faulty Choke. 20 Inspect Distributor -- Worn, Loose, or Incorrectly Installed Distributor.
Hi, Ok you have confirmed that it's not a fuel problem. You need to check for spark. Pull the coil wire off of the coil(secondary lead-looks like a spark plug wire) Have some one crank it over and listen for a popping sound. IF yes, spark is at the coil, that means all ignition sensors are working. Next check for spark at ends of wires after cap. IF no replace cap and rotor. IF yes remove a couple spark plugs and check for fouling(wet, fuel etc...) IF yes replace or clean plugs and retest for starting. IF no spark is present at coil you need to scan computer and watch for rpm signal. IF no rpm signal, replace crankshaft sensor with OEM delco part. BIGGEST problem with these engines is Cap and Rotor burn out.
So you turned the key just to "Run" and hear the fuel pump running (guessing elec pump)?
Did you pull off a spark plug wire to check for spark? If no spark, pull the Distributor cap and check inside of cap, and rotor for damage, if ok, then the coil is bad, replace it.
If you have spark at the plugs, have you tried Starting Fluid? (old school, go to AutoZone for this)